automatic transmission GENESIS G70 2023 User Guide

Page 272 of 552

Driving Your Vehicle6-20
[ Always apply the parking brake when
leaving the vehicle. Do not depend on
placing the transmission in P (Park) to
keep the vehicle from moving.
[ Exercise extreme caution when
driving on a slippery surface. Be
especially careful when braking,
accelerating or shifting gears. On a
slippery surface, an abrupt change
in vehicle speed can cause the drive
wheels to lose traction and may cause
loss of vehicle control resulting in an
accident
[ Optimum vehicle performance
and fuel economy is obtained by
smoothly depressing and releasing
the accelerator. WARNING
To reduce the risk of SERIOUS INJURY
or DEATH:
[ALWAYS wear your seat belt. In a
collision, an unbelted occupant
is significantly more likely to be
seriously injured or killed than a
properly belted occupant.
[ Avoid high speeds when cornering or
turning.
[ Do not make quick steering wheel
movements, such as sharp lane
changes or fast, sharp turns.
[ The risk of rollover is greatly
increased if you lose control of your
vehicle at highway speeds.
[ Loss of control often occurs if two or
more wheels drop off the roadway
and the driver over steers to reenter
the roadway.
[ In the event your vehicle leaves
the roadway, do not steer sharply.
Instead, slow down before pulling
back into the t ravel lanes.
[ Genesis Branded Vehicle
recommends you to follow all posted
speed limits.
NOTICE
ickdown mechanism
se the kickdown mechanism for
maximum acceleration. Depress the
accelerator pedal beyond the pressure
point. The automatic transmission will
shift to a lower gear depending on the
engine speed.

Page 295 of 552

06
6-43
OIK060029L
6. During vehicle launching, continue to depress the accelerator pedal to keep
the Launch Control system active until
desired duration.
The message ‘Launch Control Active’
will appear on the cluster LCD display.
To deactivate (end) Launch Control,
release the accelerator pedal.
Information
aunch Control is available again after
cooling down by driving the vehicle for at
least 3 minutes.
CAUTION
[ Launch Control system is intended
for use at a closed race track and not
intended for use on public roads. It
will not compensate for driver's who
are inexperienced or lack familiarity
with the race track.
[ Do not use Launch Control during
break-in period of the vehicle.
NOTICE
Constant use of Launch Control can
put enormous stress on the vehicle
resulting in premature wear of related
components.
Limited Use of Launch Control
OIK057181N
Transmission temperature too high.
aunch control not available
A warning message will pop up on the
clus
ter LCD display if the transmission
fluid temperature is above a certain
level while using Launch Control. Also,
Launch Control will be automatically
deactivated.
If this occurs, the driver should cool
down the transmission fluid temperature
by driving the vehicle at a constant
speed over 37 mph (60 km/h).

Page 297 of 552

06
6-45
Coasting Release Conditions
The Coasting function will be
automatically released when the
following conditions are met.
[COMFORT, SPORT, SPORT+ is
selected for driving mode
[ The driver uses the paddle shifter
[ Smart Cruise Control is activated (Set
speed appears on the cluster)
[ The vehicle’s speed exceeds 30~100
mph (50~160 km/h) range
[ The road gradient is under -5% or over
+5%
Information
It is recommended to turn off the
Coasting function if you are driving under
fre uently stop-and-go condition. Change
the drive mode to COMFORT, SPORT,
SPORT or deselect Coasting from the
infotainment system screen.
NOTICE
[If the accelerator pedal is pressed
quickly for accelerating with the
Coasting function in operation,
acceleration may occur after the
engagement of the clutch inside the
transmission. In turn, the driver may
continue to feel acceleration even
after the system is turned off.
[ Driving with the Coasting function
off may be required in some cases
since the engine brake is not applied
while the Coasting function is
operating.
[ Operating the infotainment system
screen to activate or deactivate
the Coasting function while driving
may be dangerous as the driver’s
attention is dispersed.

Page 298 of 552

Driving Your Vehicle6-46
Drive mode may be selected according
to the driver's preference or road
condition.
OIK060033
Drive mode
The mode changes whenever the DRIVE
MODE selection knob is rotated.
COMFORT mode
COMFORT mode provides smooth
driving and comfortable riding.
ECO mode
ECO mode helps improve fuel
efficiency for eco-friendly
driving.
Fuel efficiency varies according
to the driver's driving habit and
road condition.
[ When ECO mode is selected, the
ECO indicator will illuminate on the
instrument cluster.
[ When ECO mode is activated:
- The acceleration response may be slightly reduced if the accelerator
pedal is depressed moderately.
- The air conditioner performance may be limited.
- The shift pattern of the automatic transmission may change.
- Engine noise may be louder at some automatic transmission shifts as
down-shift requires pressing down
more on the accelerator.
The above situations are normal
conditions when the ECO mode
is activated to help improve fuel
efficiency.
imitations of ECO mode
If the following conditions occur while
E
CO mode is operating, the system
operation is limited even though there is
no change in ECO indicator.
[ When coolant temperature is low:
The system will be limited until engine
performance becomes normal.
[ When driving up a hill:
The system will be limited to gain
power when driving uphill because
engine torque is restricted.
[ When driving the vehicle in manual
shift mode using the paddle shifter.
The system will be limited according
to the shift location.
'5,9(02'(,17(*5$7('&21752/6<67(0

Page 432 of 552

08
8-3
If You Have a Flat Tire While
Driving
If a tire goes flat while you are driving:
[Take your foot off the accelerator
pedal and let the vehicle slow down
while driving straight ahead. Do not
apply the brakes immediately or
attempt to pull off the road as this
may cause loss of vehicle control
resulting in an accident. When the
vehicle has slowed to such a speed
that it is safe to do so, brake carefully
and pull off the road. Drive off the
road as far as possible and park on
firm, level ground. If you are on a
divided highway, do not park in the
median area between the two traffic
lanes.
[ When the vehicle is stopped, press
the hazard warning flasher button,
shift the vehicle to P (Park), apply the
parking brake, and press the Engine
Start/Stop button to the OFF position.
[ Have all passengers get out of the
vehicle. Be sure they all get out on the
side of the vehicle that is away from
traffic.
[ When changing a flat tire, follow the
instructions provided later in this
chapter.
IF THE ENGINE WILL NOT
START
[Be sure to shift the vehicle to P (Park)
if it is an automatic transmission
vehicle. The engine starts only when
the vehicle is in P (Park).
[ Turn on the interior light. If the light
dims or goes out when you operate
the starter, the battery is drained.
See instructions for “Jump Starting”
provided in this chapter.
[ Check the fuel level and add fuel if
necessary.
If the vehicle still does not start, call an
authorized retailer of Genesis Branded
products for assistance.
NOTICE
Push or pull starting the vehicle may
cause the catalytic converter to
overload which can lead to damage to
the emission control system.

Page 447 of 552

Emergency Situations8-18
Jack Label
OHYK065011
The actual Jack label in the vehicle may differ from the illustration.
For more detailed specifications, refer to the label attached to the jack.
1. Model Name
2. Maximum allowable load
3. When using the jack, set your parking brake.
4. When using the jack, stop the engine.
5. Do not get under a vehicle that is supported by a jack.
6. The designated locations under the frame
7. When supporting the vehicle, the base plate of jack must be vertical under the lifting point.
8. Shift into Reverse gear on vehicles with manual transmission or shift the gear to the P position on vehicles with automatic transmission.
9. The jack should be used on firm level ground.
10. Jack manufacture
11. Production date
12. Representative company and address

Page 458 of 552

08
8-29
OIK082016N
[Use a towing cable or chain less than
16 ft. (5 m) long. Attach a white or red
cloth (about 12 in. (30 cm) width) in
the middle of the cable or chain for
easy visibility.
[ Drive carefully so the towing cable or
chain remains tight during towing.
[ Before towing, check the automatic
transmission for fluid leaks under your
vehicle. If the automatic transmission
fluid is leaking, flatbed equipment or a
towing dolly must be used.
NOTICE
Accelerate or decelerate the vehicle
in a slow and gradual manner while
maintaining tension on the tow rope
or chain to start or drive the vehicle,
otherwise tow hooks and the vehicle
may be damaged.
NOTICE
To avoid damage to your vehicle and
vehicle components when towing:
[Always pull straight ahead when
using the towing hooks. Do not pull
from the side or at a vertical angle.
[ Do not use the towing hooks to pull
a vehicle out of mud, sand or other
conditions from which the vehicle
cannot be driven out under its own
power.
[ Limit the vehicle speed to 10 mph
(15 km/h) and drive less than
1 mile (1.5 km) when towing to avoid
serious damage to the automatic
transmission.

Page 464 of 552

Maintenance9-6
Owner Maintenance Schedule
When you stop for fuel:
[ Check the coolant level in the engine
coolant reservoir or the liquid-cooled
intercooler coolant reservoir.
[ Check the windshield washer fluid
level.
[ Check for low or under-inflated tires.
WARNING
Be careful when checking your coolant
level if the engine is hot. This may
result in coolant being blown out of the
opening and cause serious burns and
other injuries.
While operating your vehicle:
[Note any changes in the sound of the
exhaust or any smell of exhaust fumes
in the vehicle.
[ Check for vibrations in the steering
wheel. Notice if there is any increased
steering effort or looseness in the
steering wheel, or change in its
straight-ahead position.
[ Notice if your vehicle constantly turns
slightly or “pulls” to one side when
traveling on smooth, level road.
[ When stopping, listen and check for
unusual sounds, pulling to one side,
increased brake pedal travel or “hard-
to-push” brake pedal.
[ If any slipping or changes in the
operation of your transmission occurs,
check the transmission fluid level.
[ Check the automatic transmission P
(Park) function.
[ Check the parking brake.
[ Check for fluid leaks under your
vehicle (water dripping from the air
conditioning system during or after
use is normal).
At least monthly:
[Check coolant level in the engine
coolant reservoir.
[ Check the operation of all exterior
lights, including the stoplights, turn
signals and hazard warning flashers.
[ Check the inflation pressures of all
tires including the spare for tires that
are worn, show uneven wear, or are
damaged.
[ Check for loose wheel lug nuts.
At least twice a year: (for example,
every Spring and Autumn)
[Check radiator, heater and air
conditioning hoses for leaks or
damage.
[ Check windshield washer spray and
wiper operation. Clean wiper blades
with a clean cloth dampened with
washer fluid.
[ Check headlight alignment.
[ Check muffler, exhaust pipes, shields
and clamps.
[ Check the seat belts for wear and
function.
At least once a year:
[Clean body and door drain holes.
[ Lubricate door hinges and hood
hinges.
[ Lubricate door and hood locks and
latches.
[ Lubricate door rubber weather strips.
[ Check the air conditioning system.
[ Inspect and lubricate automatic
transmission linkage and controls.
[ Clean the battery and terminals.
[ Check the brake fluid level.

Page 469 of 552

09
9-11
Normal Maintenance Schedule (Cont.)
MAINTENANCE INTERVALS
MAINTENANCE
ITEM Number of months or driving distance, whichever comes first
Months 12 24 36 48 60 72 84 96 108 120
Miles×1,000 6 12 18 24 30 36 42 48 54 60
Km×1,000 10 20 30 40 50 60 70 80 90 100
Automatic transmission fluid
*4
No check, No service required
Differential oil (rear) *
5 *6
Without LSD I
With LSD R
Differential oil (front) (AWD) *
5
I
Transfer case oil (AWD) No check, No service required
Vapor hose, fuel filler cap and fuel tank IIIII
I : Inspect and if necessary, adjust, correct, clean or replace.
R : Replace or change.
*4 :
Use only the specified automatic transmission fluid. (Refer to "Recommended lubricants and capacities" in chapter 2 or the
label in the engine compartment.)
*5 :
Front/rear differential oil should be changed anytime, front/rear differential have been submerged in water.
*6 :
When replacing differential oil with LSD (Limited Slip Differential), use only specified LSD oil.

Page 471 of 552

09
9-13
Maintenance Under Severe Usage Conditions
The following items must be serviced more frequently on cars normally used under
severe driving conditions. Refer to the chart below for the appropriate maintenance
intervals.
R : Replace or change.
I : Inspect and if necessary, adjust, correct, clean or replace.
Maintenance itemMaintenance
operation Maintenance intervals Driving
condition
Engine oil and filter RE
very 3,000 miles
(5,000 km) or 6 months A, B, C, D,
E, F, G, H, I, J, K, L
Air cleaner filter IInspect more frequently
depending on the condition C, E
Spark plugs RReplace more
frequently depending on the condition A, B, F, G,
H, I, K
Automatic transmission fluid REvery 60,000 miles
(100,000 km) A,C,E,F,G,
H,I,K
Front brake disc/pads, calipers IInspect more frequently
depending on the condition C, D, E, G,
H , J, K
Rear brake disc/pads IInspect more frequently
depending on the condition C, D, E, G,
H , J, K
Parking brake IInspect more frequently
depending on the condition C, D, G, H
Steering gear box, linkage & boots/
Lower arm ball joint, upper arm ball
joint IInspect more frequently
depending on the condition C, D, E,
F, G
Drive shafts and boots IInspect more frequently
depending on the condition C, D, E, F,
G, H, I, J
Differential oil (front) (AWD) REvery 72,000 miles
(120,000 km) C, E, G, H,
I, J
Differential oil (rear) Without LSD R
Every 72,000 miles
(120,000 km) C, E, G, H,
I, J
With LSD REvery 36,000 miles
(60,000 km) C, E, G, H,
I, J
Cabin air filter
(for evaporator and blower unit) RReplace more
frequently depending on the condition C, E, G
Propeller shaft IInspect more frequently
depending on the condition C, D, E, F,
G, H, I, J

Page:   < prev 1-10 11-20 21-30 next >