stop start GENESIS G90 2023 Repair Manual

5-113
05
Puddle Lamp
ORS051084L
Welcome light
When all doors (and trunk) are closed
and locked, the puddle lamp will turn
on for 15 seconds if any of the below is
performed.

[The doors are unlocked by the smart
key.

[The outside door handle touch sensor
is touched with the smart key in
possession.

[The vehicle is approached with the
smart key in possession. (if equipped)
The puddle lamp turns off if the Engine
Start/Stop button is in the ACC position
with a door open.
For more details, refer to “Welcome
System” in this chapter.
Escort light
When the Engine Start/Stop button is in
the OFF position and the driver’s door is
opened, the puddle lamp will turn on for
30 seconds. If the driver’s door is closed
within the 30 second period, the puddle
lamp will turn off after 15 seconds. If the
driver’s door is closed and locked, the
puddle lamp will turn off immediately.
The Puddle Lamp Escort Light will turn
on only the first time the driver’s door is
opened after the engine is turned off.
Welcome System
ORS051077L
Welcome system helps keep the driver
visible by turning on vehicle lights when
the driver approaches the vehicle.

5-115
05
ORS051272
High Beam Assist will automatically
switch between high beam and low
beam depending on the detected
brightness from the lamps of oncoming
vehicles or vehicles in front.
Detecting sensor
ORS071001L
M: Front view camera
The front view camera is used as a
detecting sensor to detect ambient light
and brightness while driving.
Refer to the picture above for the
detailed location of the detecting sensor.
NOTICE
Always keep the front view camera in
good condition to maintain optimal
performance of High Beam Assist.
)RUPRUHGHWDLOVRQWKHSUHFDXWLRQV
of the front view camera, refer to

U)RUZDUG&ROOLVLRQ$YRLGDQFH$VVLVW
)&$
VVHFWLRQLQFKDSWHU
High Beam Assist Setting
ORS051241L
With the Engine Start/Stop button in the
21SRVLWLRQVHOHFW
S/LJKWV

5-118
Convenience Features
ORS051284
)URQW:LQGVKLHOG:LSHUV
Operates as follows when the Engine
Start/Stop button is in the ON position.
MIST: For a single wiping cycle,
push the lever upward and
release. The wipers will operate
continuously if the lever is held in
this position.
OFF: Wiper is not in operation.
AUTO: The rain sensor located on the
upper end of the windshield
glass senses the amount of
rainfall and controls the wiping
cycle for the proper interval.
The more it rains, the faster the
wiper operates. When the rain
stops, the wiper stops. To vary
the speed setting, turn the speed
control knob.
LO: The wiper runs at a lower speed.
HI: The wiper runs at a higher speed.
Information
If there is heavy accumulation of snow
or ice on the windshield, defrost the
windshield for about 10 minutes, or until
the snow and/or ice is removed before
using the windshield wipers to ensure
proper operation.
If you do not remove the snow and/or ice
before using the wiper and washer, it may
damage the wiper and washer system.
AUTO (Automatic) control
ORS051085
The rain sensor located on the upper
end of the windshield glass senses
the amount of rainfall and controls the
wiping cycle for the proper interval.
The wiper operation time will be
automatically controlled depends on
rainfall.
When the rain stops, the wiper stops.
To vary the sensitivity setting, turn the
sensitivity control knob.
If the wiper switch is set in AUTO mode
when the Engine Start/Stop button is in
the ON position, the wiper will operate
once to perform a self-check of the
system. Set the wiper to the OFF position
when the wiper is not in use.
WIPERS AND WASHERS

5-143
05
To Defrost Inside Windshield
ORS051130
1. Set the fan speed to the highest
(extreme right) position.
2. Set the temperature to the extreme
hot (HI) position.
3. Press the defroster button (
).
4. Fresh mode will be selected
automatically.
Check to make sure the air intake control
is in Fresh mode. If the air intake control
indicator light is illuminated, press the
button once to enable Fresh mode
(indicator light OFF).
If the
position is selected, lower fan
speed is adjusted to a higher fan speed.
Defogging Logic
To reduce the probability of fogging
up the inside of the windshield, the air
intake or air conditioning are controlled
automatically according to certain
conditions. To cancel or reset the
defogging logic, do the following.
1. Press the Engine Start/Stop button to
the ON position.
2. Press the defroster button (
) or
().
3. While pressing the air conditioning
button (A/C), press the air intake
control button at least 5 times within
3 seconds.
The air intake control button indicator
will blink 3 times to indicate that the
defogging logic has been disabled.
Repeat the steps again to re-enable the
defogging logic.
If the battery has been discharged or
disconnected, it resets to the defog logic
status.

5-146
Convenience Features
Turning the Auto Defogging System
ON or OFF
&OLPDWHFRQWUROV\VWHP
Press the front windshield defroster
button for 3 seconds when the Engine
Start/Stop button is in the ON to turn the
system on or off.
To check whether the system is on
or off, go to the settings menu in the
infotainment system and see if 'Auto
Defog' is selected or not.
Infotainment system
Auto Defogging System can be turned
RQDQGRIIE\VHOHFWLQJ
S6HWXS

5-154
Convenience Features
,17(5,25)($785(6
Cup Holder
ORS051094
ORS051093
A : Front seat,
B : Rear seat
Cups or small beverages cups may be
placed in the cup holders.
Front seat:
Push the cover up and it will slowly open.
Push it up once more to to close the
cover.
Rear seat:
Push the cover. The cover will slide open.
WARNING

[Avoid abrupt starting and braking
when the cup holder is in use to
prevent spilling your drink. If hot
liquid spills, you could be burned.
Such a burn to the driver could cause
loss of vehicle control resulting in an
accident.

[Do not place uncovered or unsecured
cups, bottles, cans, etc., in the cup
holder containing hot liquid while
the vehicle is in motion. Injuries may
result in the event of a sudden stop
or collision.

[Only use soft cups in the cup holders.
Hard objects can injure you in an
accident.
WARNING
Keep cans or bottles out of direct sun
light and do not put them in a hot
vehicle. It may explode.
NOTICE

[Keep your drinks sealed while
driving to prevent spilling your drink.
If liquid spills, it may get into the
vehicle’s electrical/electronic system
and damage electrical/electronic
parts.

[When cleaning spilled liquids do not
use hot air to blow out or dry the cup
holder. This may damage the interior.

5-157
05
USB Charger (if equipped)
ORS051098
ORS051099
ORS051200
A : Front seat,
B : Rear seat (if equipped),
C : Rear seat
The USB-C charger is designed to
recharge batteries of small size electrical
devices using a USB-C cable.
The electrical devices can be recharged
when the Engine Start/Stop button is in
the ON (or START) position.
The battery charging state may be
monitored on the electrical device.Disconnect the USB-C cable from the
USB port after use.

[A smart phone or a tablet PC may
get warmer during the re-charging
process. It does not indicate any
malfunction with the charging system.

[A smart phone or a tablet PC, which
adopts a different re-charging
method, may not be properly re-
charged. In this case, use an exclusive
charger of your device.

[The charging terminal is only to
recharge a device. Do not use the
charging terminal either to turn on
an audio or to play media In the
infotainment system.
Information
&KDUJLQJPD\QRWEHSRVVLEOHZKHQXVLQJ
D7\SH&FRQYHUWHUVROGE\DPRELOHSKRQH
manufacturer or commercially available.

5-158
Convenience Features
Wireless Smart Phone Charging
System (if equipped)
ORS051201
ORS051202
A : Front seat,
B : Rear seat (if equipped),
M : Indicator light,
N : Charging pad
Charging smart phone
The wireless smart phone charging
system charges only the Qi-enabled
smart phones (
). Read the label on
the smart phone accessory cover or
visit your smart phone manufacturer’s
website to check whether your smart
phone supports the Qi technology.The wireless charging process starts
when you put a Qi-enabled smart phone
on the wireless charging unit.
1. The system is available when all doors
are closed, and when the Engine
Start/Stop button is in the ON (or
START) position.
2. You can turn on or off the wireless
charging function from the Settings
menu. Select:
- Front seat (infotainment system):
6HWXS

5-159
05
The indicator light will blink orange for 10
seconds if there is a malfunction in the
wireless charging system.
In this case, temporarily stop the
charging process, and re-attempt to
charge your smart phone again.
The system warns you with a message on
the LCD display if the smart phone is still
on the wireless charging unit after the
vehicle is turned OFF and the front door
is opened.
For some manufacturer’s smart phones,
the system may not warn you even
though the smart phone is left on the
wireless charging unit. This is due to the
particular characteristic of the smart
phone and not a malfunction of the
wireless charging. Information

[The wireless smart phone charging
system may not support certain smart
phones, which are not verified for the
Qi specification (
).

[When placing your smart phone on the
charging pad, position the phone in the
middle of the mat for optimal charging
performance. If your smart phone is off
to the side, the charging rate may be
less and in some cases the smart phone
may experience higher heat conduction.

[In some cases, the wireless charging
may stop temporarily when the smart
key is used, either when starting the
vehicle or locking/unlocking the doors,
etc.

[When charging certain smart phones,
the charging indicator may not change
to blue when the smart phone is fully
charged.

[The wireless charging process may
temporarily stop, when temperature
abnormally increases inside the wireless
smart phone charging system. The
wireless charging process restarts,
when temperature falls to a certain
level.

[The wireless charging process may
temporarily stop when there is any
metallic item, such as a coin, between
the wireless smart phone charging
system and the smart phone.

5-160
Convenience Features

[When charging some smart phones
with a self-protection feature, the
wireless charging speed may decrease
and the wireless charging may stop.

[If the smart phone has a thick cover,
the wireless charging may not be
possible.

[If the smart phone is not completely
contacting the charging pad, wireless
charging may not operate properly.

[If the Engine Start/Stop button is in the
2))SRVLWLRQWKHFKDUJLQJDOVRVWRSV

[When any smart phone without a
wireless charging function or a metallic
REMHFWLVSODFHGRQWKHFKDUJLQJSDG
a small noise may sound. This small
sound is due to the vehicle discerning
FRPSDWLELOLW\RIWKHREMHFWSODFHGRQ
the charging pad. It does not affect
your vehicle or the smart phone in any
way.

[Some smart phones may not be able
to charge depending on the internal
structure of the smart phone. If this
occurs, try charging the mobile phone
by moving it to the left or right side of
the wireless charging pad. However, for
some foldable smart phones that have
magnets inside the smart phone, try
charging the smart phone while holding
it close to the left side of the wireless
charging pad.NOTICE
Some magnetic items like credit cards,
phone cards or rail tickets may be
damaged if left with the smart phone
during the charging process.
Information
This device complies with Part 15 of the
)&&UXOHV
2SHUDWLRQLVVXEMHFWWRWKHIROORZLQJWKUHH
conditions:
1. This device may not cause harmful
interference, and
2. This device must accept any
interference received, including
interference that may cause undesired
operation.
3. &KDQJHVRUPRGLILFDWLRQVQRWH[SUHVVO\
approved by the party responsible
for compliance could void the user’s
authority to operate the device.