reset GMC ENVOY 2006 Get To Know Guide

9
Activate the Daytime Running Lamps
(DRL) and automatic headlamp system
• Move the knob to the AUTO ( )
position.
• All exterior lamps and the instrument
panel/radio lights will illuminate when
they are needed.
Manually activate the parking lamps,
sidemarker lamps, taillamps, instru
ment panel/radio lights and license
plate lamps
• Move the knob to the parking lamp
()position.
Manually activate the headlamps, all
exterior tail/marker lamps and the
instrument panel/radio lights
• Move the knob to the ON ( )
position.
Activate the fog lamps
• Press the button (see “A” below)
located on the instrument panel to the
right of the exterior lamps switch
once.
• An indicator lamp will illuminate.
• To turn them off, press the button
again.
See Section 3 of your Owner Manual.
Heated, Power Outside Mirrors
(if equipped)
Activate heat feature on the power
outside mirrors
• Press the rear window defogger
button on the climate control panel.
See Section 2 of your Owner Manual.
Outside Mirror with Curb View
Assist (if equipped)
This feature automatically adjusts the
passenger side mirror downward to a
preset tilt position when the vehicle is in
Reverse gear. The mirror returns to its
normal position when the vehicle is
moved out of Reverse. See your Owner
Manual to activate this system for the
first time.
See Sections 2 and 3 of your Owner Manual.
A

11
Set the time to an FM station’s Radio
Data System (RDS) setting
(if equipped)
• Press and hold both HR and MN for
two seconds until UPDATED and the
clock symbol appear on the display.
• If the time is not available from the
station, NO UPDAT appears in the
display.
Program radio station presets
• Turn the radio on.
• Press the BAND button to select the
band (AM/FM1/FM2/XM1/XM2).
• Use the seek or tune knob to tune in
the desired station.
• Press AUTO EQ to select the equal
ization that best suits the type of
station selected.
•Press and hold one of the six num
bered buttons until a beep sounds;
release the button.
•Repeat these steps for each station
preset, using a different numbered
button for each station.
Display a station’s INFO message
when INFO appears on the display
•Press INFO to see the message.
Once the complete message has
been displayed, INFO disappears
from the display.
Tune to an RDS broadcast of a
selected program type
• Press the TYPE button to select the
Program Type you want to listen to.
• Press the or button.
Access one of the two available XM
Satellite Radio bands (if equipped)
• Press the BAND button until XM1 or
XM2 appears on the display.
Load one CD into the SixDisc CD
Player (if equipped)
• With the ignition on, press and
release the LOAD side of the LOAD
CD button.
• Wait for the indicator light at the right
side of the slot to turn green.
•Insert the disc partway into the slot,
label side up; the player will pull the
disc in.
Load multiple CDs
• With the ignition on, press and hold
the LOAD button for two seconds.
The unit beeps and the light to the
right of the slot begins to flash.
• When the light stops flashing and
turns green, insert a disc partway,
label side up.
• The indicator light will begin blinking
and then turn green. Load another
disc at this time.
• When loading more than one but
fewer than six CDs, press the LOAD
button again to signal that loading is
complete.

Getting to Know YourEnvoy14
OnStar®(if equipped)
The OnStar system provides invehicle
safety, security, and phone services,
available 24 hours a day, 7 days a
week. These services are easily
accessed through the three OnStar
buttons in your vehicle.
•Press the white Phone button to
access OnStar Personal Calling, a
handsfree, voiceactivated phone
service.*
•Press the blue OnStar button to con
nect to an OnStar Advisor for servic
es such as GM Goodwrench Remote
Diagnostics or routing and location
assistance.**
•Press the red Emergency button to
connect to an OnStar Advisor who
can contact a nearby emergency
services provider to dispatch ambu
lance, police, fire, or other emergency
services to your location.
For more information about OnStar fea
tures, refer to the OnStar Owner’s
Manual and Audio CD, located in your
glove box.
*Available in most markets
**Routing and location assistance may require
service upgrade
See Section 2 of your Owner Manual.
Driver Information Center (DIC)
(if equipped)
Your vehicle’s Driver Information Center
(DIC) is located in the instrument panel
cluster.
Access DIC modes
• Press one of the following DIC but
tons located on the steering wheel.
– Trip Information ( )
Trip Information Button
• Press to scroll through the
odometer, TRIP A, TRIP B, and
TIMER. When either TRIP A or TRIPBis displayed, you can press the
Select button ( ) to reset the
displayed odometer.
• You can also reset a trip odometer
to zero by pressing and holding the
reset stem for four seconds. When
TIMER is displayed, you can press
to start or stop the timer. To reset
it to zero, push and hold while
TIMER is displayed.

Fuel Information Button
• Press to scroll through the range,
average fuel economy, fuel used and
the GM Oil Life System
TM.
• RANGE estimates the remaining dis
tance you can drive without refueling.
Range is based on recent fuel econo
my and the fuel remaining in the tank.
• AVG. ECON calculates how many
miles per gallon you are getting
based on overall driving conditions.
Press and hold the Select button ()while AVG. ECON is displayed
and the DIC will begin calculating the
average fuel economy from that point
in time.
• FUEL USED shows the current
amount of fuel used in gallons since
the last reset for FUEL USED. This
mode should be reset after every fuel
tank fillup.
• ENGINE OIL LIFE calculates an esti
mate (percentage) of the engine oil’s
remaining useful life. It also will alert
you when it is time to change your oil
by illuminating the CHANGE ENG
OIL light on the DIC. Please remem
ber to always reset the oil life system
after an oil change by pressing and
holding for four seconds while
ENGINE OIL LIFE is displayed. When
successful, the DIC will display
ENGINE OIL LIFE: 100%.
15
Note:If your vehicle is not equipped
with DIC steering wheel buttons, press
the trip odometer reset stem located in
the instrument panel cluster to select
the information. Hold the stem for four
seconds to reset trip odometers.Personalization Button
• Press once and the vehicle settings
will be displayed. Press again to
scroll through and set the personal
ization features.
Select Button
• Press to scroll through the menu
choices for each personalization
feature. Finalize your choice by
pressing while it is displayed on
the DIC and move on to the next
feature.
• The personalization features can be
reset to their default mode by holding
and down for four seconds.
Language Options
• If you find that the unit displays a lan
guage other than the one you prefer
and you are unable to change it, hold
and down until the display
begins cycling through the three
available languages. Release the
buttons when you see the preferred
language.
Displaying Driver Preferences
•The driver preferences are recalled
by pressing memory button 1 or 2
located on the driver’s door. The last
value displayed for each preference
is saved automatically.
See Section 3 of your Owner Manual.