display HONDA ACCORD COUPE 2004 CL7 / 7.G Owner's Manual

Satellite radio receives signals f rom
two satellites to produce clear, high-
quality digital reception. It of f ers
many channels in several categories.
Along with a large selection of
dif f erent types of music, satellite
radio also allows you to view channel
and category selections in the audio
display.
The XM satellites are in orbit over
the equator; therefore, objects south
of the vehicle may cause satellite
reception interruptions. To help
compensate f or this, ground-based
repeaters are placed in major
metropolitan areas. Satellite signals
aremorelikelytobeblockedbytall
buildings and mountains the f arther
north you travel f rom the equator.
Satellite Radio Signals
Comf ort and Convenience Feat ures
Playing t he XMSatellite Radio
131
Signal may be
blocked by
mountains or
large obstacles
to the south.
SATELLITE
GROUND
REPEATER
——y
y
(%
y
y

If you decide to purchase XM
Satellite Radio service, contact XM
Radio at www.xmradio.com, or at
1-800-852-9696. You will need to give
them your radio I.D. number and
your credit card number.
To get your XM Satellite radio ID
number:Af ter you have registered with XM
Radio, keep your audio system in the
SAT Radio mode while you await
activation. This should take about 30
minutes.
While awaiting activation, make sure
your vehicle remains in an open area
with good reception. Once your
audio system is activated, ‘‘category’’
or ‘‘CH’’ will appear in the display
and you will be able to listen to XM
Radio broadcasts. XM Radio will
continue to send an activation signal
to your vehicle for at least 12 hours
from activation request. If the
service has not been activated after
36 hours, contact XM Radio.
Turn the TUNE knob or press the
TUNE bar until ‘‘0’’ appears in the
display. Your ID number will appear
in the display.
Comf ort and Convenience Feat ures
Playing t he XMSatellite Radio
133
——y
y
(%
y
y

Playing a CD
Comf ort and Convenience Feat ures136
PWR/VOL KNOBUPPER DISPLAY
DISC AND TRACK NUMBERS
CH/DISC BARCD SLOT
EJECT BUTTON
RANDOM ICON
LOAD BUTTON
CD/SAT BUTTON
SCAN BUTTON
DISC
RPTICON TRACK
RPTICON
DISC
SCANICON
TRACK
SCAN ICON
SEEK/
SKIP BAR
CD
LOAD INDICATORAUDIO DISPLAY BUTTON
EX-L and EX-V6 models
with Navigation System (U.S. Vehicles only)
——y
y
(%
y
y

To load or play CD’s, the ignition
switch must be in the ACCESSORY
(I) or ON(II) position.
You operate the CD player/CD
changer with the same controls used
for the radio. To select the CD
player/CD changer, press the CD
button. The number of the track
playing is shown in the display. With
the in-dash CD changer, the disc and
track numbers are displayed. The
system will continuously play a CD
until you change modes.
Insert a CD into the CD slot. The
drive will pull the CD in the rest of
the way to play it. When the system
reaches the end of the disc, it will
return to the beginning and play the
disc again.To play the radio when a CD is
playing, press the AM/FM button.
Press the CD button again to switch
back to the CD player.
To play the tape when a CD is
playing, insert a tape in the player
(optional). If a tape is in the player,
press the AUX button. Press the CD
button again to switch back to the
CD player. The cassette player is
optional on all U.S. models.
To listen to satellite radio when a CD
is playing, press the CD/SAT button.
If you turn the system of f while a CD
is playing, either with the PWR/VOL
knob or by turning off the ignition,
the disc will stay in the drive. When
youturnthesystembackon,theCD
will begin playing where it lef t of f . Press the LOAD button until you
hear a beep and see ‘‘LOAd’’ in the
display (in the upper display on
vehicles with navigation system).
The disc number/icon f or an
empty position is highlighted and
the red light starts blinking.
Insert the disc into the CD slot
when the green CD load indicator
comes on. Insert it only about
half way; the drive will pull it in the
rest of the way. You will see
‘‘BUSY’’ in the display as the CD
load indicator turns red and blinks
as the CD is loaded.
You cannot load and play 3-inch (8-
cm) discs in this system.
You can also play 3-inch (8-cm) discs
without using an adapter ring. 1. 2. 3.
For vehicles with Satellite Radio
For vehicles with in-dash CD changer
LX model
CONT INUED
Playing a CD
Comf ort and Convenience Feat ures
To Play a CD
137
——y
y
(%
y
y

µ
µ
´
Û
Ý
µ µ
µ
When the CD load indicator turns
green and ‘‘LOAd’’ appears in the
screen again, insert the next CD in
the slot.
Repeat this until all six positions
are loaded. If you are not loading
all six positions, the system begins
playing the last CD loaded.
To select a dif f erent disc, press the
appropriate side of a preset bar (1
6) or use the Preset 5 (DISC ) to
select the previous disc or Preset 6
(DISC ) to select the next disc in
sequence. On vehicles with
navigation system, touch the
appropriate disc icon or press the
or side of the CH/DISC bar. If
youselectanemptypositioninthe
CD changer, the system will try to
load the CD in the next available slot.
Each time you
press and release side, the
player skips f orward to the
beginning of the next track. Press
and release side, to skip
backward to the beginning of the
current track. Press it again to skip
to the beginning of the previous
track. To move rapidly within a track, press
andholdthe or side.
The SCAN function
samples all the tracks on the
selected disc in the order they are
recorded on the CD. To activate it,
press and release the SCAN button.
You will see SCAN in the display.
You will get a 10 second sampling of
each track on the selected CD. Press
the SCAN button again to get out of
the system.
This f unction samples
each f irst track of all the discs in the
in-dash CD changer in the order they
are stored. To activate it, select the
D-SCAN mode by pressing and
holding the SCAN button. You will
see D-SCAN in the display. You will
get a 10 second sampling of the f irst
track on each CD. Press the SCAN
button again to get out of the system.
You can also load a CD into an empty
position while a CD is playing by
pressing the appropriate side of a
preset bar or touching a disc icon.
The system stops playing the current
CD and starts the loading sequence.
It plays the CD just loaded.
You operate the CD changer with
the same controls used f or the radio.
The numbers of the disc and track
playingareshowninthedisplay.On
vehicles with navigation system,
these numbers also appear in the
upper display.
4. 5.
On vehicles with in-dash CD changer
Except f or LX model
Comf ort and Convenience Feat ures
Playing a CD
For Vehicles wit hout Navigat ionSyst em
SEEK /SK IP SCAN
D-SCAN
138
——y
y
(%
y

y

µµµ
µ
µ
µ
µ
µ
CONT INUED
To continuously replay
a track, press and release the RPT
button. You will see RPT in the
display. Press the RPT button again
to turn it off. When you touch
this icon on the audio display or
press the SCAN button, you will get
a10secondsamplingof eachtrack
on the current CD. You will see
TRACK SCAN highlighted on the
audioscreenandSCANintheupper
display. Press the icon or button
again to get out of the system.
When you touch
the TRACK RPT icon, the system
continuously plays the same track.
You will see TRACK RPT
highlighted on the audio screen and
RPT in the upper display. Press the icon again to get out of track repeat.
When you touch the
DISC SCAN icon on the audio
display, the system gives you a 10
second sampling of the f irst track on
each disc in the in-dash CD changer.
You will see DISC SCAN highlighted
on the audio screen and D-SCAN in
the upper display. Touch the icon
again to get out of the system. When you touch the
DISC RPT icon on the audio display,
the system continuously replays the
current CD. You will see DISC RPT
highlighted on the audio screen and
D-RPT in the upper display. Touch
the icon to turn the feature off.
When you touch the
RANDOM icon on the audio display,
the system plays the tracks on the
current CD in random order. You
will see RANDOM highlighted on
the audio screen and RDM in the
upper display. To turn this f eature
of f , touch RANDOM again or select
a dif f erent disc icon.
To continuously
replay the current disc, press and
hold the RPT button. You will see
D-RPT in the display. Press the RPT
button again to turn it off.
Press and release the
RDM button to play the tracks in
random order. You will see RDM in
the display. Press the RDM button
again to return to normal play.
To use the controls, press the
AUDIO DISPLAY button, the control
icons will appear on the screen.
Except f or LX model
Playing a CD
Comf ort and Convenience Feat ures
REPEAT TRACK SCAN
TRACK RPT
DISC SCAN
DISC RPT
RANDOM
D-REPEA T
RANDOM
For Vehicles wit h Navigat ion Syst em
139
——y
y
(%
y
y

µ´ µ´
You can also eject discs when the
ignition switch is of f . The disc that
was last selected is ejected f irst. An optional six or eight disc CD
changer is available f or your vehicle
f rom your Honda dealer.
This disc changer uses the same
controls used f or the in-dash CD
player/changer or the radio.
Load the desired CDs in the
magazine, and load the magazine in
the changer according to the
instructions that came with the unit.
To select the CD changer, press the
CD button. The disc and track
numbers will be displayed. To select
a dif f erent disc, use the Preset 5
(DISC ) side or Preset 6 (DISC )
side of the preset bar. To select the
previous disc, press the Preset 5
(DISC ) or Preset 6 (DISC ) to
select the next disc in sequence.If you select an empty slot in the
magazine, the changer will search
f or the next available CD to load and
play.
On LX model, if there are no CDs in
the changer, the display will f lash,
and you will have to select another
mode.
Playing a CD
Comf ort and Convenience Feat ures
Operating the Optional CD
Changer
141
——y
y
(%
y
y

If you see an error message in the
display while playing a CD, f ind the
cause in the chart to the right. If you
cannot clear the error message, take
your vehicle to a Honda dealer.Error Message Cause Solution
FOCUS Error
Mechanical Error
High TemperaturePress the eject button and pull out the CD.
Check if it is inserted correctly in the CD player.
Make sure the CD is not scratched or damaged.
Press the eject button and pull out the CD.
Check the CD for damage or deformation.
If the CD cannot be pulled out or the error
message does not disappear after the CD is
ejected, see a Honda dealer.
Will disappear when the temperature returns to
normal.
CD Player Error Messages
Comf ort and Convenience Feat ures
On L X model
143
——y
y
(%
y
y

If you see an error message in the
display while operating the CD
changer, find the cause in the
f ollowing charts. If you cannot clear
theerrormessage,takeyourvehicle
to a Honda dealer.
Error Message Cause Solution
FOCUS Error
Mechanical Error
No CD in the CD
Changer
High TemperaturePress the CD eject button and pull out the CDs.
Check f or an error message, and insert the CDs
again. If the message does not disappear or the
CDs cannot be pulled out, see a Honda dealer.
Press the CD eject button and pull out the CDs.
Check f or an error message, and insert the CDs
again. If the message does not disappear or the
CDs cannot be pulled out, see a Honda dealer.
Insert CDs.
Will Disappear when the temperature returns
to normal.
Without Navigation System
With Navigation System
::
CD Changer Error Messages
Comf ort and Convenience Feat ures
Except f or L X model
144
——y

y
(%
y
y

Comf ort and Convenience Feat ures
Playing a T ape (Opt ional)
148
PWR/VOL KNOBAUDIO DISPLAY BUTTON
TUNE/SOUND KNOBUPPER DISPLAY
CD/DISC BAR
RPT ICON
FF ICON
REW ICON SEEK/SKIP BAR RPT INDICATOR
TAPE DIRECTION INDICATOR
PLAY/PROG ICON CD/SAT BUTTON EX-L and EX-V6 models
with Navigation System (U.S. Vehicles only)
NOISE REDUCTION (NR) ICON
——y

y
(%
y

y