key HONDA ACCORD SEDAN 2013 9.G Technology Reference Guide

67
INST\fU\bENT PANEL INDICATO\fS
\balfunction IndicatorsIf an indicator remains on, there may be a problem\b see your dealer
On/Off Indicators
Condition IndicatorsAction is needed by driver
PASSENGER AIRBAG O\b\b(next to display screen)
VSA O\b\b
ECON Mode on
Fog lights on Headlights on
Turn signals/hazards on
High beams on
Charging system
Low brake fluid
ABS
(antilock brake system)
Malfunction lamp (check engine light)
TPMS (tire pressure monitoring system)
VSA®(vehicle stability assist)
Parking brake on:
\felease
Seat belt reminder:
\basten seat belt(s)\S
Brake system
Adaptive Cruise Control
Adaptive Cruise Control on
Smart Entry System
Low oil pressure
SRS
(supplemental restraint system)
EPS (electric power steering)
FCW (forward collision warning
system)
L\fW (lane departure warning
system)
\foor/Trunk open:
Close door(s) / tr\Sunk Low tire pressure:
Add air
System message indicator:
Check MID
Low fuel:
\fefill
L\fW (blinks): Stay in your lane
FCW (blinks): Brake
Immobilizer (blinks):Use correct key
Briefly appear with each engine start. Red and orange indicators a\Ere most critical. Blue
and green indicators are used for general information. See your Owner’s Manual for
more information.
13 Accord 4D TRG_TOUR\AING_ATG_NEW STYLE \A8/9/2012 10\f33 AM \APage 5

1415
How It Works
O N E T O U C H T U R N S I G N A L
Use this quick and convenient method to signal a lane change.
• Lightly push the turn signallever up or down for a three
blink sequence.
• For a continuous signal\b push the lever up or down until it
locks into place.
How It Works
A U T O H E A D L I G H T S W I T H W I P E R I N T E G R A T I O N
For your safety and convenience\b your vehicle’s headlights automatically turn on when
you activate the windshield wipers.
• Make sure your headlights are in the AUTOposition.
• Turn on your windshield wipers. The headlights also turn on.
• When you turn off the windshield wipers\b the headlights turn off shortly after.
D R I V I N G P O S I T I O N M E M O R Y S Y S T E M ( D P M S )
How It Works
1. Turn on the vehicle. Make sure
the shift lever is in Park (P).3. Press SET. You will hear a beep.
4.Press the memory button
corresponding to the remote (1
or 2) you are using. You will
hear two beeps.
Note: Stored positions can also be recalled by pressing memory buttons
(1 or 2) on the door.
Store driver’s seat positions into memory for each corresponding keyless remote
(1 or 2)\b which are recalled when you unlock the driver’s door with the remote
and enter the vehicle.
2.Adjust your preferred seat
settings.
13 Accord4D TRG_TOURING\fATG_NEW\A STYLE 7/13/2012 4\f41 PM Page 9