HONDA CIVIC 2023 Owners Manual

709
uuMaintenance Under the Hood uMaintenance Items Under the Hood
Maintenance
2.0 L engine models without Auto Idle Stop
Brake/Clutch Fluid
(Black Cap)
Washer Fluid
(Blue Cap) Engine Oil Dipstick
(Black)
Battery
Engine Coolant
Reserve Tank Cap
Engine Coolant
Reserve Tank
Engine Oil Fill Cap
23 CIVIC HATCHBACK TYPE R-31T406100_03.book 709 ページ ２０２２年６月２３日　木曜日　午後９時２８分

710
uuMaintenance Under the Hood uOpening the Hood
Maintenance
Opening the Hood
1. Park the vehicle on a level surface, and set
the parking brake.
2. Pull the hood release handle under the
driver's side lower co rner of the dashboard.
u The hood will pop up slightly.
3. Push the hood latch lever (located under
the front edge of the hood to the center) to
the side and raise the hood. Once you have
raised the hood slightly, you can release the
lever.
4. Remove the support rod from the clamp
using the grip. Mount the support rod in
the hood.
When closing, remove the support rod, and
stow it in the clamp, then gently lower the
hood. Remove your hand at a height of
approximately 12 inches (30 cm) and let the
hood close.1 Opening the Hood
NOTICE
Do not open the hood when the wiper arms are
raised. The hood will strike the wipers, resulting in
possible damage to the hood and/or the wipers.
NOTICE
Do not press the engine cover forcibly. This may
damage the engine cover and component parts.
When closing the hood, check that the hood is
securely latched.
If the hood latch lever moves stiffly, or if you can
open the hood without lifti ng the lever, the latch
mechanism should be cl eaned and lubricated.
Do not open the hood while the Auto Idle Stop
*
function is activated.
3WARNING
The hood support rod can become very hot
due to heat from the engine.
To ensure against po ssible burns, do not
handle the metal section of the rod: Use
the foam grip instead.
2.0 L engine models
Hood Release Handle
Pull
Lever
Support Rod
Grip
Clamp
* Not available on all models
23 CIVIC HATCHBACK TYPE R-31T406100_03.book 710 ページ ２０２２年６月２３日　木曜日　午後９時２８分

711
uuMaintenance Under the Hood uRecommended Engine Oil
Continued
Maintenance
Recommended Engine Oil
Use a genuine engine oil or another commercial engine oil of suitable type and
viscosity (for the ambient temperature) as shown in the image that follows.
Oil is a major contributor to your engine's performance and longevity. If you drive
the vehicle with insufficient or deteriorated oil, the engine may fail or be damaged.
*1:Formulated to improve fuel economy.
Genuine Engine OilCommercial Engine Oil
●Honda Genuine Motor Oil●Premium-grade 0W-20 detergent oil
with an API Certifica tion Seal on the
container.
1 Recommended Engine Oil
Engine Oil Additives
Your vehicle does not require oil additives. In fact,
they may adversely affect the engine performance
and durability.
Models with Auto Idle Stop
Ambient TemperatureAmbient Temperature
23 CIVIC HATCHBACK TYPE R-31T406100_03.book 711 ページ ２０２２年６月２３日　木曜日　午後９時２８分

uuMaintenance Under the Hood uRecommended Engine Oil
712
Maintenance
*1:Formulated to improve fuel economy.
■Synthetic oil
You may also use synthetic motor oil if it is labeled with the API Certification Seal
and is the specified viscosity grade.
Genuine Engine OilCommercial Engine Oil
●Honda Genuine Motor Oil● API service SN or higher grade● API Certification Mark “Starburst”
1 Recommended Engine Oil
The following seal indica tes the oil is energy
conserving and that it meets the American Petroleum
Institute's late st requirements.Models without Auto Idle Stop
Ambient TemperatureAmbient Temperature
23 CIVIC HATCHBACK TYPE R-31T406100_03.book 712 ページ ２０２２年６月２３日　木曜日　午後９時２８分

713
uuMaintenance Under the Hood uOil Check
Continued
Maintenance
Oil Check
We recommend that you check the engi ne oil level every time you refuel.
Park the vehicle on level ground.
Wait approximately three minutes after turning the engine off before you check the oil.
1. Remove the dipstick (orange or black).
2. Wipe the dipstick with a clean cloth or
paper towel.
3. Insert the dipstick back all the way into its
hole.
1Oil Check
If the oil level is near or below the lower mark, slowly
add oil, being carefu l not to overfill.
1.5 L engine models
2.0 L engine models with Auto Idle Stop
23 CIVIC HATCHBACK TYPE R-31T406100_03.book 713 ページ ２０２２年６月２３日　木曜日　午後９時２８分

714
uuMaintenance Under the Hood uOil Check
Maintenance
2.0 L engine models without Auto Idle
Stop
23 CIVIC HATCHBACK TYPE R-31T406100_03.book 714 ページ ２０２２年６月２３日　木曜日　午後９時２８分

715
uuMaintenance Under the Hood uOil Check
Maintenance
4. Remove the dipstick again, and check the
level. It should be between the upper and
lower marks. Add oil if necessary.
Upper Mark
Lower Mark
1.5 L engine models
Upper Mark
Lower Mark
2.0 L engine models
1Oil Check
NOTICE
Under certain driving conditions, it is normal for the
engine oil level to rise above the upper mark. If you
have a concern, consult a dealer for details.
23 CIVIC HATCHBACK TYPE R-31T406100_03.book 715 ページ ２０２２年６月２３日　木曜日　午後９時２８分

716
uuMaintenance Under the Hood uAdding Engine Oil
Maintenance
Adding Engine Oil
1. Unscrew and remove the engine oil fill cap.
2. Add oil slowly.
3. Reinstall the engine oil fill cap, and tighten
it securely.
4. Wait for three minutes and recheck the
engine oil dipstick.1Adding Engine Oil
NOTICE
Do not fill the engine oil above the upper mark.
Overfilling the engine oil may result in leaks and
engine damage.
If any oil spills, wipe it away immediately. Spilled oil
may damage the engine compartment components.
Engine Oil
Fill Cap
1.5 L engine models
Engine Oil
Fill Cap
2.0 L engine models with Auto Idle Stop
2.0 L engine models without Auto Idle
Stop
Engine Oil
Fill Cap
23 CIVIC HATCHBACK TYPE R-31T406100_03.book 716 ページ ２０２２年６月２３日　木曜日　午後９時２８分

717
uuMaintenance Under the Hood uChanging the Engine Oil and Oil Filter
Continued
Maintenance
Changing the Engine Oil and Oil Filter
You must change the engine oil and oil fi lter regularly in order to maintain the
engine's lubrication. The engine may be damaged if they are not changed regularly.
Change the oil and filter in accordance with the maintenance message on the driver
information interface. 1.Run the engine until it reaches normal
operating temperature, and then turn the
engine off.
2. Open the hood and remove the engine oil
fill cap.
3. Remove the Phillips-head screws and
slotted head screws by turning 90°
counter-clockwise on the undercarriage
and remove the under cover.1Changing the Engine Oil and Oil Filter
NOTICE
You may damage the environment if you do not
dispose of the oil in a suitable way. If you are
changing the oil by yourself , appropriately dispose of
the used oil. Put the oil in a sealed container and take
it to a recycling center. Do not throw the oil away
into a garbage can or onto the ground.
Under Cover
Screw
Models with Auto Idle Stop
Under Cover
Screw
Models without Auto Idle Stop
23 CIVIC HATCHBACK TYPE R-31T406100_03.book 717 ページ ２０２２年６月２３日　木曜日　午後９時２８分

718
uuMaintenance Under the Hood uChanging the Engine Oil and Oil Filter
Maintenance
4. Remove the drain bolt and washer from
the bottom of the engine, and drain the
oil into a suitable container.1.5 L engine models
Drain Bolt
Washer
2.0 L engine models with Auto Idle Stop
Drain Bolt
Washer
2.0 L engine models without Auto Idle
Stop
Drain Bolt
Washer
23 CIVIC HATCHBACK TYPE R-31T406100_03.book 718 ページ ２０２２年６月２３日　木曜日　午後９時２８分