HONDA CR-V 2005 RD4-RD7 / 2.G Owners Manual

Vents, Heating, and A/C
98
FAN CONTROL DIAL
TEMPERATURE CONTROL DIAL MODE CONTROL DIAL
RECIRCULATION BUTTON AIR CONDITIONING (A/C) BUTTON REAR WINDOW DEFOGGER BUTTON
REAR WINDOW DEFOGGER/ HEATED MIRRORS BUTTON(If equipped)

The outside air intakes f or the
heating and cooling system are at
the base of the windshield. Keep this
area clear of leaves and other debris.
Thesystemshouldbeleftinfresh
air mode under almost all conditions.
Keeping the system in recirculation
mode, particularly with the A/C of f ,
can cause the windows to fog up.
Switch to recirculation mode when
driving through dusty or smoky
conditions, then return to fresh air
mode.
This button turns the rear window
def ogger of f and on (see page ).
When the recirculation indicator is
on, air f rom the vehicle’s interior is
sent throughout the system again.
When the indicator is off, air is
brought in f rom the outside of the
vehicle (fresh air mode). This button turns the air
conditioning on and of f . The
indicatorinthebuttonisonwhen
the A/C is on. Turning this dial clockwise increases
the temperature of the airflow. Turn this dial to increase or decrease
the fan speed and airflow. Use the mode control dial to select
the vents the air flows from. Some
air will f low f rom the dashboard
corner vents in all modes.
Air flows from the center
and corner vents in the dashboard.
Airf low is divided between
the vents in the dashboard and the
f loor vents.
Air f lows f rom the f loor
vents. When you select , the
system automatically switches to
f resh air mode.
On some models, this button also
controls the heated mirror function
(see page ). The system automatically
turns on the A/C and switches to
recirculation mode. Air f lows f rom
the center and side vents in the
dashboard.
68
89
CONT INUED
Rear Window Def ogger Button
Recirculation Button Air Conditioning (A/C) Button T emperature Control Dial
Fan Control Dial A ir Flow Buttons Mode Control Dial
Vents, Heating, and A/C
Features
99

The heater uses engine coolant to
warm the air. If the engine is cold, it
will be several minutes bef ore you
f eel warm air coming f rom the
system.
The f low-through ventilation system
draws in outside air, circulates it
through the interior, then exhausts it
through vents near the tailgate. Air f lows f rom the def roster
vents at the base of the windshield. Airf low is divided between
the f loor vents and the def roster
vents at the base of the windshield.
When you select or ,
the system automatically switches to
f resh air mode and turns on the A/C.
In this case, you cannot turn the A/C
off.
Set the temperature to the lower
limit.
Make sure the A/C is of f .
Select and fresh air mode.
Set the f an to the desired speed. Select .
When you select , the system
automatically switches to f resh air
mode.
Set the f an to the desired speed.
Adjust the warmth of the air with
the temperature control dial.
Air conditioning places an extra load
on the engine. Watch the engine
coolant temperature gauge (see page
). If it moves near the red zone,
turn of f the A/C until the gauge
reading returns to normal.
Turn on the A/C by pressing the
button. The indicator in the button
comesonwhenafanspeedis
selected.
Make sure the temperature is set
to maximum cool.
Select .
If the outside air is humid, select
recirculation mode. If the outside
air is dry, select f resh air mode.
Set the f an to the desired speed.
1.
2.
3.
4. 1.
2.
3.
4.
5.
1.
2.
3.
62
Vents, Heating, and A/C
Using the Heater
Ventilation Using the A /C
100

To remove f og f rom the inside of the
windows:
Air conditioning, as it cools, removes
moisture from the air. When used in
combination with the heater, it
makes the interior warm and dry.
This setting is suitable f or all driving
conditions whenever the outside
temperature is above 32°F (0°C).
To cool the interior with MAX A/C:
Set the f an to the desired speed.
Select MAX A/C mode.
The system automatically turns on
the A/C, selects , and
switches to recirculation mode.
Make sure the temperature is set
to maximum cool.
you can
cool it down more rapidly by partially
opening the windows, turning on the
A/C, and setting the fan to
maximum speed in f resh air mode.
Turn the fan on.
Turn on the air conditioning.
Select and fresh air mode.
Adjust the temperature to your
pref erence.
Set the f an to the desired speed or
high f or f aster def rosting.
Select . The system
automatically switches to fresh air
mode and turns on the A/C. The
A/C indicator will not come on, if
it was previously of f .
Adjust the temperature so the
airf low feels warm.
Select to help clear the
rear window and the outside
mirrors (if equipped).
To increase airf low to the
windshield, close the corner vents.
1.
2.
3.
4.
1.
2.
3.
4.
5.
1.
2.
3.
If the interior is very warm,
Vents, Heating, and A/C
T o Def og and Def rost To Dehumidif y the Interior
Features
101

When you select or ,
the system automatically switches to
f resh air mode and turns on the A/C.
This helps to dehumidif y the air and
to def og the windshield. In either
mode, you cannot turn of f the A/C.
When you switch to another mode,
the A/C returns to its original setting,
either on or of f , as displayed by the
A/C indicator.
Select . The system
automatically switches to f resh air
mode and turns on the A/C. The
A/C indicator does not come on if
it was previously off.
Select .
Set the f an and temperature
controls to maximum level.
To clear the windows f aster, you can
close the dashboard corner vents by
rotating the wheel below each vent.
This sends more warm air to the
windshield def roster vents. Once the
windshield is clear, select f resh air
mode to avoid f ogging the windows.
For your saf ety, make sure you have
a clear view through all the windows
bef ore driving.
Turning the f an speed control dial all
the way to the left shuts the system
off.
Keep the system of f f or short
periods only.
To keep stale air and mustiness
f rom collecting, you should have
the f an running at all times.
1.
2.
3.
T o Remove Exterior Frost or Ice
From the Windows
To Turn Everything Of f
Vents, Heating, and A/C
102

Some models may have one of the
audio systems described in this
section. Read the appropriate pages
in this section f or operation of the
audio systems installed in your
vehicle.page to f or U.S. LX model,
Canadian SE model
page to f or U.S. EX, SE
models, Canadian EX, EX-L
models
If your vehicle has a dif f erent audio
system ref er to its manual f or
operating instructions. 115105
116 131
Audio System
Features
103
U.S. LX and Canadian SE model

Audio System
104
Canadian EX and EX-L models U.S. EX and SE models

Playing the Radio
Features
105
SCAN BUTTON FM BUTTON
TREBLE/ BALANCE
BASS/ FADE
AM BUTTON AUTO SELECT BUTTON
SEEK BUTTONS
PRESET BUTTONS TUNE KNOB POWER/VOLUME KNOB
U.S. LX and Canadian SE model

µ
µ
ÓÓ
µ
´µ
You can use any of f ive methods to
f ind radio stations on the selected
band: the
preset buttons, and .
Use the TUNE knob to
tune the radio to a desired f requency.
Turn the knob right to tune to a
higher f requency, or lef t to tune to a
lower f requency.
The SEEK f unction
searches up and down f rom the
current f requency to f ind a station
with a strong signal. To activate it,
press the or SEEK button, then
release it.
The ignition switch must be in the
ACCESSORY (I) or ON (II) position.
Turn the system on by pushing the
PWR/VOL knob or the AM or FM
button. Adjust the volume by turning
the PWR/VOL knob.
The SCAN f unction
samples all stations with strong
signals on the selected band. To
activate it, press the SCAN button,
then release it. You will see SCAN in
the display. The system will scan f or
a station with a strong signal. When
it f inds one, it will stop and play that
station f or about 10 seconds.
If you do nothing, the system will
scan f or the next strong station and
play it f or 10 seconds. When it plays
a station that you want to listen to,
press the SCAN button again.
The band and f requency that the
radio was last tuned to is displayed.
To change bands, press the AM or
FM button. On the FM band, ST will
be displayed if the station is
broadcasting in stereo.
Stereo reproduction on AM is not
available.
To Play the Radio
TUNE,SEEK,SCAN,
AUTO SELECT
To Select a Station
TUNE
SEEK
SCAN
Playing the Radio
106

µµIf you are
traveling far from home and can no
longer receive your preset stations,
you can use the auto select feature to
find stations in the local area. Select the desired band, AM or
FM. FM1 and FM2 let you store
two f requencies with each preset
button.
UsetheTUNE,SEEK,orSCAN
function to tune the radio to a
desired station.
Repeat steps 1 through 3 to store a
total of six stations on AM and
twelve stations on FM.
The preset f requencies will be lost if
your vehicle’s battery goes dead, is
disconnected, or the radio f use is
removed.
If you do not like the stations auto
select has stored, you can store
other f requencies on the preset
buttons as previously described.
You will see a ‘‘0’’ displayed af ter
pressing a preset button if auto
select cannot f ind a strong station f or
every preset button.
Press the A. SEL button. ‘‘A.SEL’’
f lashes in the display, and the system
goes into scan mode f or several
seconds. It stores the f requencies of
six AM and twelve FM stations in
the preset buttons.
Pick a preset button and hold it
until you hear a beep.
Each preset button can
store one f requency on AM and two
f requencies on FM.
To turn of f auto select, press the
A. SEL button. This restores the
presets you originally set.
1.
2.
3.
4.
AUTO SELECT Preset
Playing the Radio
Features
107