headlights HONDA CR-V 2005 RD4-RD7 / 2.G Owners Manual

Page 7 of 274






To use the horn, press the center pad of the steering wheel.
If equipped.
1:
2:
Your Vehicle at a Glance
4
HEADLIGHTS/TURN SIGNALS
REAR WINDOW
DEFOGGER
WINDSHIELD
WIPERS/WASHERS
AUDIO SYSTEM
HAZARD WARNING
BUTTON
(P.66)
(P.88) (P.68)
PASSENGER AIRBAG
OFF INDICATOR
(P.30)
(P.67)
SHIFT LEVER (A/T)
INSTRUMENT PANEL
BRIGHTNESS
(P.67) CLOCK
(P.65)
(P.135)
(P.171) (P.161)
(P.137)
HORN
CRUISE CONTROL
MASTER BUTTON
(P.138) MOONROOF SWITCH
A/T model is shown. STEERING WHEEL ADJUSTMENT
(P.69)
CRUISE CONTROL
BUTTONS
(P.138) PARKING BRAKE
(P.68)
REMOTE AUDIO
CONTROLS
VEHICLE STABILITY
ASSIST (VSA) SYSTEM
ON/OFF SWITCH (P.103)
1
2
2

Page 56 of 274

This section gives inf ormation about
the controls and displays that
contribute to the daily operation of
your vehicle. All the essential
controls are within easy reach............................
Control Locations .54
............................
Instrument Panel .55
..........
Instrument Panel Indicators . 56
.............................................
Gauges .61
...................................
Trip Meter .61
.....................................
Odometer .62
..................................
Fuel Gauge .62
...................
Temperature Gauge . 62
Outside Temperature ..................................
Indicator .62
..........
Check Fuel Cap Indicator . 63
Controls Near the Steering ...........................................
Wheel .64
.
Windshield Wipers and Washers . 65
.........
Turn Signals and Headlights . 66
........
Instrument Panel Brightness . 67
.................
Hazard Warning Button . 67
.................
Rear Window Def ogger . 68
.................................
Parking Brake .68
..........
Steering Wheel Adjustment . 69
...............................
Keys and Locks .70
........................
Immobilizer System .71
................................
Ignition Switch .72
......................................
Door Locks .73
......................
Power Door Locks .73
..............
Childproof Door Locks . 73...............
Tailgate and Hatch Glass . 74
.......................
Remote Transmitter .75
.................................................
Seats .78
....................................
Seat Heaters .86
..............................
Power Windows .86
.........................................
Moonroof .88
.............................................
Mirrors .88
...........
Interior Convenience Items . 90
.......................
Beverage Holders .91
...............................
Built-in Table .91
....................................
Glove Box .93
.....................................
Coin Tray .93
......................
Sunglasses Holder .94
................................
Center Table .94
..........
Accessory Power Sockets . 95
.............................
Center Pocket .95
......................................
Sun Visor .95
.................................
Interior Lights .95
Instruments and Controls
Inst rument s and Cont rols
53

Page 62 of 274

This indicator comes on with the
high beam headlights. For more
inf ormation, see page .
On Canadian models, this indicator
comes on with reduced brightness
when the daytime running lights
(DRL) are on (see page ).
This indicator comes on when you
turn the ignition switch to the ON
(II) position with the headlight
switch of f and the parking brake set.
It should go of f if you turn on the
headlights or release the parking
brake. If it comes on at any other
time, it means there is a problem
withtheDRL.Theremayalsobea
problem with the high beam
headlights.This indicator comes on as a
reminder that you must ref uel soon.
The lef t or right turn signal indicator
blinks when you signal a lane change
or turn. If an indicator does not blink
or blinks rapidly, it usually means
one of the turn signal bulbs is
burned out (see page ). Replace
the bulb as soon as possible, since
other drivers cannot see that you are
signaling.
When you press the hazard warning
button, both turn signal indicators
and all turn signals on the outside of
the vehicle f lash. When the indicator comes on, there
is about 2.74 US gal (10.4
)of fuel
remaining in the tank bef ore the
needle reaches E. There is a small
reserve of f uel remaining in the tank
when the needle does reach E.
This indicator comes on if the
tailgate or the hatch glass is not
closed tightly.
This indicator comes on if any door
is not closed tightly.
67
67
205
Canadian models only
Turn Signal and Hazard Warning
Indicators High Beam Indicator
L ow Fuel Indicator
Daytime Running L ights
Indicator Tailgate and Hatch Glass
Open Indicator
Door-open Indicator
Instrument Panel Indicators
Inst rument s and Cont rols
59

Page 67 of 274




Î Î
To use the horn, press the center pad of the steering wheel.
If equipped.
1:
2:
Controls Near the Steering Wheel
64
CRUISE CONTROL
MASTER BUTTON
(P.138)HEADLIGHTS/TURN SIGNALS
SHIFT LEVER (A/T)
WINDSHIELD WIPERS/
WASHERS
A/T model is shown. REAR WINDOW DEFOGGER
HAZARD WARNING BUTTON
(P.65) (P.
67)
(P.88)
(P.68)
(P.30)
(P.69)
(P.66)
PASSENGER AIRBAG OFF
INDICATOR
VEHICLE STABILITY
ASSIST (VSA)
SYSTEM ON/OFF
SWITCH INSTRUMENT PANEL
BRIGHTNESS
(P.67)
(P.171)
MOONROOF SWITCH
REMOTE AUDIO
CONTROLS
(P.135) (P.161)
PARKING BRAKE
(P.68)
STEERING WHEEL ADJUSTMENT
CRUISE CONTROL
BUTTONS
(P.138) HORN
2
2 1

Page 69 of 274



Push down on the
lef t lever to signal a lef t turn and up
to signal a right turn. To signal a lane
change, push lightly on the lever,
and hold it. The lever will return to
center when you release it or
complete a turn.
OFF
When you turn the wiper switch to
the ‘‘OFF’’ position or turn of f the
ignition switch, the wiper will
return to its parked position.
Rotate the switch
counterclockwise to turn the
window wiper on and the window
washer to spray.
The rear wiper will not work if the
hatch glass is not f ully closed.
If you open the hatch glass while the
rear wiper is operating, the wiper will
stop. To return the wiper to its
parked position, close the hatch
glass, and then rotate the switch to
the ‘‘OFF’’ position.
Therearwindowwasherusesthe
same f luid reservoir as the wind-
shield washer.
Turn signal
Of f
Parking and interior lights
Headlights
High beams
Flashhighbeams
Turning the switch to
the ‘‘ ’’ position turns on the
parking lights, taillights, instrument
panel lights, side-marker lights, and
rear license plate lights. Turning the
switch to the ‘‘ ’’ position turns
on the headlights. If you leave the
lights on with the key removed f rom
the ignition switch, you will hear a
reminder tone when you open the
driver’s door.
1.
2.
3.
4.
5.
6.
3.
4.
Turn Signal Turn Signal and Headlights
Headlights
Windshield Wipers and Washers, Turn Signal and Headlights
66

Page 70 of 274

µTurntheknobontheleftsideof the
instrument panel to adjust the
brightness of the instrument panel
lights. Push the button below the center
vents to turn on the hazard warning
lights (f our-way f lashers). This
causes all f our outside turn signals
and both turn indicators in the
instrument panel to f lash. Use the
hazard warning lights if you need to
park in a dangerous area near heavy
traffic, or if your vehicle is disabled.
To f lash the high beams, pull the
lever back lightly, then release it.
The high beams will stay on as long
as you hold the lever back.
The headlights revert to normal
operation when you turn the switch
to the ‘‘ ’’ position. With the headlight switch off, the
high beam headlights and the high
beam indicator come on with
reduced brightness when you turn
the ignition switch to the ON (II)
position and release the parking
brake. They remain on until you turn
the ignition switch of f , even if you
set the parking brake. To turn on high
beams, push the lever f orward until
you hear a click. The blue high beam
indicator will come on (see page ).
Pull the lever back to return to the
low beams. 59
Canadian models only
Hazard Warning Button
Instrument Panel Brightness
Daytime Running L ights High Beams
Headlights, Instrument Panel Brightness, Hazard Warning Button
Inst rument s and Cont rols
67
INSTRUMENT PANEL BRIGHTNESS
CONTROL KNOB

Page 91 of 274

If equippedKeep the inside and outside mirrors
clean and adjusted f or best visibility.
Be sure to adjust the mirrors bef ore
you start driving.
The inside mirror has day and night
positions. The night position reduces
glare f rom headlights behind you.
Flip the tab on the bottom edge of
the mirror to select the day or night
position.
Turn the ignition switch to the ON
(II) position, and use the switch
under the lef t dashboard vent to
operate the moonroof .
To tilt up the back of the moonroof ,
press and hold the center button
().
To close the moonroof , press and
hold the top of the switch ( ).
To open the moonroof , press and
hold the bottom of the switch
().
Moonroof Mirrors
Moonroof , Mirrors
88
TABOpening or closing the
moonroof on someone’s hands
or fingers can cause serious
injury.
Make sure all hands and fingers
are clear of the moonroof
before opening or closing it.
If you try to open the moonroof in
below-f reezing temperatures, or when
it is covered with snow or ice, you can
damage the moonroof panel or motor.

Page 189 of 274

̵
µµ



We recommend the use of Honda
parts and f luids whenever you have
maintenance done. U.S. Vehicles:
According to state and federal
regulations, f ailure to perf orm
maintenance on the items marked
with will not void your emissions
warranties. However, all
maintenance services should be
perf ormed at the recommended time
or mileage period to ensure long-
term reliability.
Youshouldcheckthefollowing
items at the specif ied intervals. If
you are unsure of how to perf orm
any check, turn to the appropriate
page listed.
Engine oil level Check every
time you f ill the f uel tank. See
page .
Engine coolant level Check the
radiator reserve tank every time
you f ill the f uel tank. See page .
Automatic transmission Check
the f luid level monthly. See page .
Brakes Check the f luid level
monthly. See page .
Tires Check the tire pressure
monthly. Examine the tread f or
wear and foreign objects. See page .
Lights Check the operation of
the headlights, parking lights,
taillights, high-mount brake light,
and license plate light monthly.
See page .
Your authorized dealer knows your
vehicle best and can provide
competent, ef f icient service.
However, service at a dealer is not
mandatory to keep your warranties
in effect. Maintenance may be done
by any qualif ied service f acility or
skilled person to keep your
warranties in ef f ect. Keep all the
receipts as proof of completion, and
have the person who does the work
f ill out the maintenance record.
Check your warranty booklet f or
more inf ormation.
145
146
199
212 203 201
Maintenance Schedule
Servicing Your Vehicle
Maintenance,
replacement, or repair of
emissions control devices and
systems may be done by any
automotive repair establishment
or individual using parts that are
‘‘certif ied’’ to EPA standards. Owner’s Maintenance Checks
186

Page 206 of 274

CONT INUED
Theheadlightswereproperlyaimed
when your vehicle was new. If you
regularly carry heavy items in the
cargo area or pull a trailer,
readjustment may be required.
Adjustmentsshouldbedonebyyour
dealer or other qualif ied mechanic.
Your vehicle has halogen headlight
bulbs. When replacing a bulb, handle
it by its base, and protect the glass
f rom contact with your skin or hard
objects. If you touch the glass, clean
it with denatured alcohol and a clean
cloth.
Remove the electrical connector
f rom the bulb by pulling the
connector straight back.
Remove the rubber weather seal
by pulling on the tab.
Unclip the end of the hold-down
wire f rom its slot. Pivot it out of
the way, and remove the bulb.
1.
2.
3.
Headlight A iming Replacing a Headlight Bulb
Lights
Maint enance
203
WEATHER SEAL BULB
CONNECTOR
Low Beam Headlight
HOLD-DOWN WIRE
Halogen headlight bulbs get very hot
when lit. Oil, perspiration, or a scratch
on the glass can cause the bulb to
overheat and shatter.

Page 207 of 274


Install the new bulb into the hole,
making sure the tabs are in their
slots. Pivot the hold-down wire
back in place, and clip the end into
the slot.
Install the rubber seal over the
back of the headlight assembly.
Make sure it is right side up; it is
marked ‘‘ .’’
Push the electrical connector onto
the new bulb. Make sure it is
connected securely. Turn on the
headlights to test the new bulb.
4.
5.
6.
Lights
204
High Beam Headlight

Page:   1-10 11-20 next >