HONDA CR-V 2007 RD1-RD5, RE7 / 3.G Owners Manual

The operator will load
your vehicle on the back of a truck.
Any other method of towing will
damage the drive system. When you
contact the towing agency, inform
th em a flat-bed is required.
If
your vehicle needs to be towed,
call a professional towing service or
organization. Never tow your vehicle
with just a rope or chain. It is very
dangerous. Refer to
on page
for non-emergency towing
inf ormation. 250
On 4WD models
The only way you can saf ely tow
your vehicle is with f lat-bed
equipment. Towing Your Vehicle
Behind a Motorhome
Emergency Towing
T aking Care of t he Unexpect ed
317
Towing with only two tires on the
ground will damage parts of the 4WD
system. It should be transported on a
f lat-bed truck or trailer.

µ
Thediagramsinthissectiongive
you the dimensions and capacities of
your vehicle and the locations of the
identif ication numbers. It also
includes inf ormation you should
know about your vehicle’s tires and
emissions control systems.
................
Identif ication Numbers .320
................................
Specif ications .322
DOT Tire Quality Grading
......................
(U.S. Vehicles) .324
Unif orm Tire Quality ..................................
Grading .324
.................................
Treadwear .324
......................................
Traction .324
.............................
Temperature .325
.................................
Tire Labeling .326
Tire Pressure Monitoring System (TPMS) Required Federal ............................
Explanation .327 .......................
Emissions Controls .329
.....................
The Clean Air Act .329
Crankcase Emissions Control ....................................
System .329
Evaporative Emissions Control ....................................
System .329
Onboard Ref ueling Vapor ................................
Recovery .329
...
Exhaust Emissions Controls . 330
....................
PGM-FI System .330
Ignition Timing Control ................................
System .330
Exhaust Gas Recirculation ...................
(EGR) System . 330
Three Way Catalytic ...........................
Converter .330
....................
Replacement Parts . 330
..
Three Way Catalytic Converter . 331
..............
State Emissions Testing . 332
T echnical Inf ormation
Technical Inf ormation
319

Your vehicle has several identif ying
numbers located in various places.
The vehicle identif ication number
(VIN) is the 17-digit number your
dealer uses to register your vehicle
f or warranty purposes. It is also
necessary f or licensing and insuring
your vehicle. The easiest place to
find the VIN is on a plate fastened to
the top of the dashboard. You can
seeitbylookingthroughthe
windshield on the driver’s side. It is
also on the certification label
attached to the driver’s doorjamb,
and is stamped on the engine
compartment bulkhead. The VIN is
also provided in bar code on the
certif ication label.
To access the VIN in the engine
compartment, pull down the lid on
the back of the engine compartment.
Make sure to close the lid bef ore
closing the hood.
Identif ication Numbers
320
VEHICLE IDENTIFICATION NUMBERCERTIFICATION LABEL

The engine number is stamped into
the f ront of the engine block.
You can see the engine number
through the window next to the ‘‘H’’
logo.
The transmission number is on a
label on top of the transmission.
Identif ication Numbers
Technical Inf ormation
321
ENGINE NUMBERAUTOMATIC TRANSMISSION NUMBER

ÎÎ
Î
Î
Specif ications
322
Dimensions
Weights
Engine
Capacities
Capacities
177.9 in (4,518 mm)
Length
Width
Height
Wheelbase
Track 66.1 in (1,680 mm)
103.1 in (2,620 mm)
61.6 in (1,565 mm)
61.6 in (1,565 mm)
Gross vehicle weight rating See the certification label attached to the driver’s doorjamb.
Type
BorexStroke
Displacement
Compression ratio
Spark plugs Water cooled 4-stroke DOHC
i-VTEC 4-cylinder gasoline engine 3.43 x 3.90 in (87.0 x 99.0 mm) 144 cu-in (2,354 cm
)
9.7 : 1
IZFR6K-11
SKJ20DR-M11
Fuel tank
Engine oil 15.3 US gal (58
)
4.4 US qt (4.2
)
4.2 US qt (4.0)
5.6 US qt (5.3) 1.32 US gal (5.0
)
1.88 US gal (7.1)
Engine
coolant
Automatic
transmission
fluid
Rear
differential
fluid (4WD)
Windshield
washer
reservoir 2.6 US qt (2.5
)
7.6 US qt (7.2
)
2.7 US qt (2.6
)
1.3 US qt (1.2
)
1.5 US qt (1.4)
7.4 US qt (7.0
)
Excluding the oil remaining in the engine
Including the coolant in the reserve tank and that remaining in the
engine
Reserve tank capacity:
0.16 US gal (0.6
) 2.6 US qt (2.5
)
4.8 US qt (4.5)
Approx.
Front
Rear
Change
Without filter
Total 1:
2:
(NGK) (DENSO) Change
Total
Change
4WD
2WD
Total 4WD
2WD
Change
Total
U.S. Vehicles
Canada
Vehicles
71.6 in (1,820 mm)
1 2
Including filter

µµµ
µ
µ
µ
µ
µ
µ
µ
µ
µ
µ
µ
µ
µ
µ
Specifications
T
echnical Inf ormat ion
323
Air Conditioning
Battery Fuses
Alignment
Tires
Lights
HFC-134a
(R-134a)
15.2 16.8 oz (430 480 g)
SP-10
12 V
12 V 50/55
W
21 W
36 AH/5 HR
12
V
12
V
12
V
12
V
12
V
12
V
12
V
12
V
12
V
21 W
3CP 8W
8W
8W
5W
21
W
21/5
W
21
W
12 V
47 AH/20 HR
12 V
Refrigerant
type
Charge quantity
Lubricant type
Capacity 12
V 3 CP Interior
Under-hood
Toe-in
Camber
Caster
0.0in(0mm)
0.08 in (2.0 mm)
0°
1°00’
1°45’
225/65R17 102T
Size
Pr essure
30 psi (210 kPa , 2.1 kgf/cm
)
30
psi (210 kPa , 2.1 kgf/cm)
T155/90D17
101M
60 psi (420 kPa , 4.2 kgf/cm
)
Headlights
Front
turn signal lights
Parking lights/side marker
lights
Rear turn signal lights
Stop/Taillights
Back-up lights
License plate light
Ceiling light
Spotlights
Cargo area light
Rear side marker lights
High-mount brake light See
page 315 or the fuse label
attached under the steering
column.
See page 316 or the fuse box
cover.
Front
Rear
Front
Rear
Front
High/Low
(Amber)(HB2)
Front/Rear
Spare
Front
Rear
Spare
(Amber)

µ
The tires on your vehicle meet all
U.S. Federal Saf ety Requirements.
All tires are also graded f or
treadwear, traction, and temperature
perf ormance according to
Department of Transportation
(DOT) standards. The f ollowing
explains these gradings.
Quality grades can be f ound where
applicable on the tire sidewall
between the tread shoulder and the
maximum section width. For
example: The treadwear grade is a compara-
tive rating based on the wear rate of
the tire when tested under controlled
conditions on a specif ied government
test course. For example, a tire
graded 150 would wear one and one-
half (1 1/2) times as well on the
government course as a tire graded
100. The relative perf ormance of
tires depends upon the actual condi-
tions of their use, however, and may
depart signif icantly f rom the norm
due to variations in driving habits,
service practices, and dif f erences in
road characteristics and climate.The traction grades, f rom highest to
lowest, are AA, A, B, and C. Those
grades represent the tire’s ability to
stop on wet pavement as measured
under controlled conditions on
specif ied government test surf aces
of asphalt and concrete. A tire
marked C may have poor traction
perf ormance.
Warning: The traction grade
assignedtothistireisbasedon
straight-ahead braking traction tests,
and does not include acceleration,
cornering, hydroplaning, or peak
traction characteristics.
All passenger car tires must conf orm
to Federal Saf ety Requirements in
addition to these grades. T readwear 200
Traction AA
Temperature A
Unif orm T ire Quality Grading Treadwear Traction AA, A, B, C
DOT Tire Quality Grading (U.S. Vehicles)
324

µWarning: The temperature grade f or
this tire is established f or a tire that
is properly inf lated and not
overloaded. Excessive speed,
underinf lation, or excessive loading,
either separately or in combination,
can cause heat buildup and possible
tire f ailure.
The temperature grades are A (the
highest), B, and C, representing the
tire’s resistance to the generation of
heat and its ability to dissipate heat
when tested under controlled
conditions on a specif ied indoor
laboratory test wheel. Sustained high
temperature can cause the material
of the tire to degenerate and reduce
tire life, and excessive temperature
can lead to sudden tire f ailure. The
grade C corresponds to a level of
perf ormance which all passenger car
tires must meet under the Federal
Motor Vehicle Saf ety Standard No.
109. Grades B and A represent
higher levels of perf ormance on the
laboratory test wheel than the
minimum required by law. Temperature A,B,C
DOT Tire Quality Grading (U.S. Vehicles)
Technical Inf ormation
325

µ
µ
µ µµ µ
µ µ
µ
µ
µ
µ
The tires that came on your vehicle
have a number of markings. Those
you should be aware of are described
below.
Speed symbol (an
alphabetical code indicating
the maximum speed rating). Load index (a numerical code
associated with the maximum
load the tire can carry).
Whenever tires are replaced, they
should be replaced with tires of the
same size. Below is an example of
tire size with an explanation of what
each component means. Tire width in millimeters.
Aspect ratio (the tire’s section
height as a percentage of its
width).
Tire construction code (R
indicates radial).
Rim diameter in inches. The tire identif ication number (TIN)
is a group of numbers and letters
that look like the f ollowing example
TIN. TIN is located on the sidewall
of the tire.
This indicates that the tire
meets all requirements of
the U.S. Department of
Transportation.Manuf acturer’s
identification mark.
Tire type code. Date of manuf acture.
Max Press The maximum air
pressurethetirecanhold.
Max Load The maximum load the
tire can carry at maximum air
pressure.
R DOT
B97R
FW6X2202
65 T 102
225
17
Tire Labeling
Tire Size T ire Ident if icat ion NumberMaximum T ire Pressure
Maximum T ire L oad
326
225/65R17 102T DOT B97R FW6X 2202