lock HONDA INSIGHT 2014 2.G User Guide
Page 52 of 411
CONT INUED
With the child seat in the desired
seating position, route the belt
through the child seat according
to the seat maker’s instructions,
then insert the latch plate into the
buckle and remove any slack f rom
the lap portion of the belt.
When not using the LATCH system,
all child seats must be secured to the
vehicle with the lap part of a lap/
shoulder belt.
In addition, the lap/shoulder belts in
all seating positions except the
driver’s have a lockable retractor
that must be activated to secure a
child seat.
Attach the tether strap hook to the
tether anchor, then tighten the
strap as instructed by the child
seat maker.
If the tether strap is too long and
cannot be tightened f irmly, f ind a
route where the strap can be
tightened securely.
Push and pull the child seat
f orward and f rom side-to-side to
verify that it is secure.
1.
6.
7.
Installing a Child Seat
Installing a Child Seat with a L ap/
Shoulder Belt
49
12/07/13 16:43:09 31TM8630_054
Driver and Passenger Saf etyTOC
2014 Insight
Page 53 of 411
Push and pull the child seat
forward and from side-to-side to
verify that it is secure enough to
stay upright during normal
driving maneuvers. If the
child seat is not secure, unlatch
the belt, allow it to retract fully,
then repeat these steps.
To deactivate the lockable retractor
andremoveachildseat,unlatchthe
buckle, unroute the seat belt, and let
the belt fully retract.
To remove slack, it may help to
putweightonthechildseat,or
push on the back of the seat while
pulling up on the belt. Af ter conf irming that the belt is
locked, grab the shoulder part of
the belt near the buckle, and pull
up to remove any slack from the
lap part of the belt. Remember, if
the lap part of the belt is not tight,
the child seat will not be secure.
To activate the lockable retractor,
slowly pull the shoulder part of the
belt all the way out until it stops,
then let the belt feed back into
Af ter the belt has retracted, tug on
it. If the belt is locked, you will not
be able to pull it out. If you can pull
thebeltout,itisnotlocked,and
you will need to repeat these steps. 4.
5.
2.
3.
Installing a Child Seat
50
12/07/13 16:43:16 31TM8630_055
Driver and Passenger Saf etyTOC
the retractor.
2014 Insight
Page 62 of 411
This section gives inf ormation about
the controls and displays that
contribute to the daily operation of
your vehicle. All the essential
controls are within easy reach............................
Control Locations .60
............................
Instrument Panel .61
..........
Instrument Panel Indicators . 62
.............................................
Gauges .72
.............
Multi-Inf ormation Display . 75
Controls Near the Steering .........................................
Wheel .118
Windshield Wipers and .....................................
Washers .119
.......
Turn Signals and Headlights . 120
.........
Daytime Running Lights . 123
......
Instrument Panel Brightness . 124
...............
Hazard Warning Button . 125
...............
Rear Window Def ogger . 126
................................
ECON Button .127
......
Steering Wheel Adjustments . 128
.............................
Keys and Locks .129
......................
Immobilizer System .130
..............................
Ignition Switch .131
....................................
Door Locks .133
............
Childproof Door Locks . 134
.....................
Remote Transmitter .135
..............................................
Hatch .139
................
Unlocking the Hatch . 140
...............................................
Seats .141
...........
Front Seat Adjustments . 141Driver’s Seat Height
............................
Adjustment .141
........................
Head Restraints .142
.
Folding the Rear Seats Down . 145
......................................
Armrest .146
...........................................
Mirrors .147
..
Adjusting the Power Mirrors . 147
..............
Power Mirror Heaters . 148
............................
Power Windows .149
...............................
Parking Brake .151
.........
Interior Convenience Items . 152
...............
Under Floor Storage . 153
.
Floor Storage Compartments . 153
.....................
Beverage Holders .154
.........
Accessory Power Socket . 155
.............
Console Compartment . 155
..................................
Glove Box .156
...............................
Center Tray .156
..........................
Center Pockets .157
..................................
Coat Hook .158
..................................
Sun Visors .158
............................
Vanity Mirror .158
...............................
Interior Lights .159
Instruments and Controls
Inst rument s and Cont rols
59
12/07/13 16:44:30 31TM8630_064
2014 Insight
Page 63 of 411
Î
Î
Î
Î
Î
If equipped
Ref er to the navigation system manual.
1:
2:
Control L ocations
60
(
P.72) (P.72, P.75)
EX model with navigation system is shown. HAZARD WARNING BUTTON
MULTI-INFORMATION DISPLAY
INSTRUMENT PANEL INDICATORS
GAUGES
ECON BUTTON DOOR LOCK TAB
POWER WINDOW
SWITCHES
HOOD RELEASE HANDLE AUDIO SYSTEM
PASSENGER AIRBAG
OFF INDICATOR
(P.35)
PARKING BRAKE LEVER AUTOMATIC
TRANSMISSION (CVT) CLIMATE CONTROL
SYSTEM
(P.62)
MIRROR CONTROLS
( P.147)
( P.127)
(P.133)
( P.133)
( P.149) NAVIGATION SYSTEM
(P.151 )
USB ADAPTER CABLE
PADDLE SHIFTERS
POWER DOOR LOCK
MASTER SWITCH (P.125)
(P.168)
(P.162 )
(P.271 )
( P.197, P.205)
( P.276)
(P.248)
2
1
1
12/07/13 16:44:36 31TM8630_065
Inst rument s and Cont rolsTOC
2014 Insight
Page 64 of 411
Î
ÎÎ
Î Î
The U.S. instrument panel is shown. Dif f erences f or the Canadian models are noted in the text.
Instrument Panel
61
LIGHTS ON INDICATOR
SEAT BELT REMINDER
INDICATOR ANTI-LOCK BRAKE SYSTEM
(ABS) INDICATOR
SUPPLEMENTAL RESTRAINT
SYSTEM (SRS) INDICATOR
SYSTEM MESSAGE
INDICATOR
BRAKE SYSTEM INDICATOR
(AMBER)
VSA OFF INDICATOR
MALFUNCTION
INDICATOR LAMP PARKING BRAKE AND
BRAKE SYSTEM
INDICATOR (RED)
DOOR/HATCH OPEN
INDICATOR
SIDE AIRBAG OFF
INDICATOR
IMMOBILIZER
SYSTEM INDICATOR
IMA SYSTEM
INDICATOR HIGH BEAM
INDICATOR
ELECTRIC POWER STEERING
INDICATOR
(P.64)
(P.63) (P.66)
: If equipped(P.62) (
P.64)
(
P.65)
(
P.68)
(P.68)
(P.69)
(P.64)
(P.69)
HIGH TEMPERATURE INDICATOR
(P.67)
LOW TEMPERATURE INDICATOR ( P.67)
(P.70)
(P.66) CRUISE MAIN INDICATOR
(P.69)
CRUISE CONTROL INDICATOR (P.69)
LOW OIL PRESSURE
INDICATOR
LOW TIRE PRESSURE/
TPMS INDICATOR
12 VOLT BATTERY
CHARGING SYSTE
M
INDICATOR (P.70)
ECON MODE INDICATOR
(P.71)
(P.70)
AUTO IDLE STOP INDICATOR
LOW FUEL INDICATOR
VEHICLE STABILITY ASSIST
(VSA) SYSTEM INDICATOR
SECURITY SYSTEM INDICATOR
(
P.65, P.293)
(P.65, P.293)
(P.66, P.281, P.283) (P.63, P.366)
(
P.62, P.365)
(P.63, P.364)
(P.62, P.363)
12/07/23 10:21:03 31TM8630_066
Inst rument s and Cont rolsTOC
2014 Insight
Page 67 of 411
This indicator normally comes on f or
a f ew seconds when you turn the
ignition switch to the ON (II)
position, and START (III) position.
When the brake system indicator
(amber) comes on and stays on,
there is a problem with the Creep
Aid System or Brake Assist (the
normal brake operates properly).
Have your vehicle checked by your
dealer. For more inf ormation, see
page.
You will also see a ‘‘CHECK BRAKE
SYSTEM’’ message on the multi-
inf ormation display (see page).This indicator normally comes on f or
a f ew seconds when you turn the
ignition switch to the ON (II)
position. If it comes on at any other
time, there is a problem with the
ABS. If this happens, have your
vehicle checked at a dealer. With
this indicator on, your vehicle still
has normal braking ability but no
anti-lock f unction. For more
inf ormation, see
page. This indicator comes on brief ly when
you turn the ignition switch to the
ON (II) position. If it comes on at
any other time, it indicates a
potential problem with your f ront
airbags. This indicator will also alert
you to a potential problem with your
airbag system components. For
more information, see
page .
You will also see a ‘‘CHECK ABS
SYSTEM’’ message on the multi-
inf ormation display (see page).You will also see a ‘‘CHECK
AIRBAG SYSTEM’’ message
on the multi-information display
(see
page ).
89 8934
89
285 287
Instrument Panel Indicators
Brake System
Indicator
(A mber)Anti-lock Brake System
(A BS) Indicator
Supplemental Restraint
System Indicator
64
U.S. Canada
12/07/13 16:45:12 31TM8630_069
Inst rument s and Cont rolsTOC
2014 Insight
Page 72 of 411
This indicator reminds you that the
exterior lights are on. It comes on
when the light switch is in either theor position. If you turn the
ignition switch to the ACCESSORY
(I) or the LOCK (0) position without
turning of f the light switch, this
indicator will remain on. A reminder
chime will also sound when you open
the driver’s door.
This indicator comes on with the
high beam headlights. For more
inf ormation, see page .
This indicator also comes on with
reduced brightness when the
daytime running lights (DRL) are on
(see page ).
The lef t or right turn signal indicator
blinks when you signal a lane change
or turn. If an indicator does not blink
or blinks rapidly, it usually means
one of the turn signal bulbs is
burned out (see pages and ).
Replace the bulb as soon as possible,
since other drivers cannot see that
you are signaling.
When you press the hazard warning
button, both turn signal indicators
and all turn signals on the outside of
the vehicle f lash.
This indicator comes on when you
turn on the cruise control system by
pressing the CRUISE button on the
steering wheel (see
page).
This indicator comes on when you
set the cruise control. See page
f or inf ormation on operating the
cruise control.
121
123
325 327
222
222On LX and EX models
On LX and EX models
Cruise Main Indicator
Lights On Indicator
High Beam Indicator
Turn Signal and
Hazard Warning
Indicators
Cruise Control Indicator
Instrument Panel Indicators
69
12/07/13 16:45:59 31TM8630_074
Inst rument s and Cont rolsTOC
2014 Insight
Page 94 of 411
ÛÝ
You can customize some vehicle
control settings. To enter the
customizing mode, press and hold
either INFO button ( / ) for more
than 3 seconds. To change the
settings, the ignition switch must be
in the ON (II) position, and the
vehicle must be stopped with the
transmission in Park. If you turn the ignition switch to the
ACCESSORY (I) or the LOCK (0)
position, or move the shif t lever out
of Park, the display will change to
the normal screen.
If you try to enter the customizing
mode while the vehicle is moving,
you will see a ‘‘MUST STOP AND
SHIFTTOPARKTOCHANGE
SETTINGS’’ message and you
cannot change the settings.
If you want to change any vehicle
control settings, select CHG
SETTING, then press the SEL/
RESET button.
Refer to the table on the following
pages about the settings you want
to customize.
CONT INUED
Customized Settings
Multi-Inf ormation Display
91
12/07/13 16:48:58 31TM8630_096
Inst rument s and Cont rolsTOC
2014 Insight
Page 96 of 411
Î
Î
Î
Î
Î
Î
Î
Description
Menu Item
Group Setup Page
Setting Option
Changes when the doors automatically lock.
Changes when the doors automatically unlock.
Changes which doors unlock with the remote
transmitter in a first push.
The exterior lights flash each time you press the
LOCK or UNLOCK button. A beeper will also
sound when you press the LOCK button twice.
Changes how long it takes (in seconds) for the
doors to relock and the security system to set after
you unlock but do not open the door.
Set/Cancel all the customized settings as default.
AUTO DOOR LOCK
AUTO DOOR UNLOCK
DOOR LOCK MODE
KEYLESS LOCK
ACKNOWLEDGMENT
SECURITY RELOCK
TIMER
DOOR SETUP
(P.108)
DEFAULT ALL
(P.117) 109
110
112
114
115
117
SHIFT FROM P
WITH VEH SPD
OFF
IGN OFF
OFF
DRIVER DOOR
ALL DOORS
ON
OFF
90sec
60sec
30sec
SET
CANCEL
Default setting
:
DRIVER DOOR /
AL L DOORS
SHIFT TO P
Multi-Inf ormation Display
93
12/07/13 16:49:09 31TM8630_098
Inst rument s and Cont rolsTOC
2014 Insight
Page 103 of 411
ÛÝÛÝ
µ
µ
µ
Elapsed Time Reset
You can choose this item to
customize from ‘‘METER SETUP’’
by pressing the INFO ( / )
button repeatedly. Press the SEL/RESET button to see
the selections.
Select the desired setting by
pressing the INFO ( / ) button,
then enter your selection by pressing
the SEL/RESET button.
There are three elapsed time reset
choices you can make:
IGN OFF The elapsed time is
reset when you turn the ignition
switch to the LOCK (0) position.
TRIP A The elapsed time is reset
when Trip A is reset.
TRIP B The elapsed time is reset
when Trip B is reset.
Multi-Inf ormation Display
100
12/07/13 16:50:06 31TM8630_105
Inst rument s and Cont rolsTOC
2014 Insight