ECU HONDA PRELUDE 1992 Owner's Manual

Emission Controls

Exhaust Emission Controls

The exhaust emission controls
include four systems: PGM-FI,
Ignition Timing Control, Exhaust
Gas Recirculation and Catalytic
Converter. These four systems
work together to control the engine's combustion and minimize
the amount of HC, CO, and NOx
that comes out the tailpipe. The
exhaust emission control systems
are separate from the crankcase
and evaporative emission control

systems.

PGM-FI System
The PGM-FI System on your car
has three sub systems: Air Intake,
Electronic Control, and Fuel
Control. The Electronic Control
Unit (ECU) uses various sensors to
determine how much air is going
into the engine. It then controls
how much fuel to inject under all
operating conditions. Ignition Timing Control System
This system constantly adjusts the
ignition timing, reducing the
amount of HC, CO and NOx

produced.

Exhaust Gas Recirculation (EGR)
The EGR system takes some of the
exhaust gas and routes it back into
the intake manifold. Adding ex-
haust gas to the air/fuel mixture re-
duces the amount of NOx produced
when the fuel is burned.
Catalytic Converter
The catalytic converter is in the exhaust system. Through chemical
reactions, it converts HC, CO, and
NOx in the engine's exhaust to
carbon dioxide (CO 2), dinitrogen
(N 2), and water vapor.
Replacement Parts

The emission control systems are

designed and certified to work to-

gether in reducing emissions to
levels that comply with the Clean

Air Act. To make sure the emis-
sions remain low, you should use

only new genuine Honda replace-

ment parts or their equivalent for

repairs. Using lower quality parts
may increase the emissions from

your car .

The emissions control systems are

covered b y
warranties separate

from the rest of your car. Read

your warranty manual for more
information.
Technical InformationProCarManuals.comMain Menu Table of Contents s t