HUMMER H2 2007 Owners Manual

Page 161 of 570

Adjusting the Crossrails
Adjust the crossrails to t your load by doing the
following:
1. Loosen the lock knobs on the crossrail
supports by turning the knobs
counterclockwise. Only loosen them enough
to allow the crossrails to slide easily.2. Slide the crossrails to the desired position,
being sure to align the lines in the side rails
with the arrows on the crossrail supports.
3. Tighten the lock knobs and then try to move
the crossrails back and forth to be sure that
they do not move.
4. Once you load the cargo onto the crossrails,
secure it by tying it down to the crossrail
support cargo tie-down loops. Do not
load cargo directly on the roof of your vehicle.
Be sure you do not cover the roof marker
lamps or the Center-High-Mounted
Stoplamp (CHMSL), if your vehicle has this
feature, with cargo.
To prevent damage or loss of cargo check now and
then to make sure the luggage and cargo are still
securely fastened and the crossrails are tight.
161

Page 162 of 570

Stop Tabs
If your vehicle has a sunroof, it will have a
crossrail stop tab placed in the siderail in the
location labeled SUNROOF STOP. This tab
prevents you from moving the crossrails past the
opening of the sunroof and loading cargo too
far forward.If your vehicle has the OnStar and navigation
system, it will have a crossrail stop tab placed in
the siderail in the location labeled OnSTAR STOP.
This tab prevents you from moving the crossrails
and cargo too close to the OnStar antenna,
which could cause the system to function
improperly or not at all.
Vehicles with the off-road lamps will have
additional stop tabs placed in the siderails to
prevent you from moving the lamps too far
rearward, causing them to shine into the optional
sunroof opening.
162

Page 163 of 570

Crossrail Channels
Notice:If you drive your vehicle through an
automatic car wash that does not have enough
clearance for any roof-mounted accessories
(such as off-road lamps or a roof basket)
on your vehicle, you can damage your vehicle.
To avoid damaging your vehicle in a car
wash, remove any roof-mounted accessories if
you can, and do not use an automatic car
wash while roof-mounted accessories are on
your vehicle. SeeWashing Your Vehicle
on page 495for more information.
The crossrails have built in channels to allow you
to attach other items designed for this system,
such as basket luggage carriers, bike racks,
ski racks, etc.To use the crossrail channels, do the following:
1. Use the included key to unlock the crossrail
end cap by turning it counterclockwise. If you
ever lose a key, your dealer will be able to
help you obtain a replacement.
163

Page 164 of 570

2. Pull the end cap
straight out from the
crossrail.
3. Peel back the rub strip from the crossrail.
4. Slide the accessory you are using into
the crossrail channel and secure it as
the accessory instructions direct.
5. Place the crossrail endcap back on and lock it
with the key.You will not be using the rub strip when using
crossrail accessories. When you remove any
crossrail accessory, be sure to reinstall the rub
strip. To do this, press the rub strip in place until it
seats into the channel of the crossrail.
Rear Seat Armrest
Your vehicle is equipped with a rear
armrest/cupholder.
To open it, pull up and then out on the tab,
located at the top center of the armrest, and pull
the armrest down.
164

Page 165 of 570

Cargo Tie Downs (SUT)
There are four oval shaped openings (A) in the
cargo bed that allow access to four tie downs. You
can use these tie downs to secure cargo.
All-Weather Cargo Area
Your vehicle has features to help it resist the
elements and protect cargo inside the cargo area.
Even when the water management system is
working properly and the cover system is on, there
may be some instances (heavy rains, automated
car washes, etc.) when water may be present
in the drain holes. See “Cargo Area Floor Drains”
later in this section for more information.
Removal and Cleaning
To ensure that the water management system
performs properly, be sure that the midgate,
tailgate and cover system are fully closed and that
each element of the water management system
is clean and not blocked with debris. Follow
the instruction given next in this section for the
proper procedures on cleaning each item of
the water management system.
165

Page 166 of 570

Side Rail Channels
The side rail channels are located on top of both
sides of the roof and the cargo area. You may
want to ush them out with clean water if
you notice any debris collecting inside of them.
When loading cargo into the cargo area, be careful
not to damage the rails.
For more information on this feature seeLuggage
Carrier on page 160.
Cargo Area Floor Drains
Your vehicle also has four cargo-area oor
drains (A) located under the cargo mat, if it has
this feature, near the sides of the cargo area.
These drains should be cleaned periodically to
allow water to exit the cargo area.
166

Page 167 of 570

The cargo mat has cutouts for the drains. You can
ush the drains through the cutouts, but if the
cargo area is extremely dirty you can lift up the
edges of the cargo oor mat or take the whole mat
out and ush the drains with water. The drain
grates can be removed to clear any debris that has
accumulated in the drain.
Tonneau Cover (SUT)
{CAUTION:
If you remove the tonneau cover, do not
store it in the vehicle without securing it
to the vehicle. An improperly stored
tonneau cover could be thrown about the
vehicle during a collision or sudden
maneuver. You or others could be injured.
When you put the cover back on, always
be sure that it is securely reattached.
Your vehicle may have a hard tonneau cover, you
can use it to cover items in the cargo area of
your vehicle.Your tonneau cover will have two lock cylinders
on it. One lock cylinder is to secure the cover
closed and the other lock cylinder will allow you to
secure the tailgate closed.
167

Page 168 of 570

You will be able to open the cover by turning the
cover release latch in a clockwise direction,
which will allow you to lift the cover with the
assistance of the struts.
Sunroof
The vehicle may have a
power sliding sunroof.
The ignition must
be on or in the
accessory position, or
Retained Accessory
Power (RAP) must
be active.
SeeRetained Accessory Power (RAP) on
page 121. The switch used to operate the sunroof
is located in the overhead console.
168

Page 169 of 570

Express-Open/Close Sunroof
The sunroof has a feature which allows the
sunroof panel to be opened or closed without
continuously pressing the switch. The
express-open can be stopped at any time by
pushing the front of the switch a second time.
The sunroof has four positions:
Comfort open stop:To open the sunroof and
sunshade, press the rear of the switch quickly
and release. The glass panel will open to
an interim position that reduces wind noise.
For information on using the sunshade,
see “Sunshade Operation” later.
Full open stop:To open the sunroof further,
press the rear of the switch quickly once more.
Express close:To close the sunroof, press the
front of the switch quickly and release.
Vent:The vent position allows the rear of the
sunroof to be opened and tilted upward. With
the sunroof in the fully closed position, press
and hold the front of the switch until the sunroof
reaches the desired vent position or until it
stops moving. To close the sunroof from the
vent position, press and hold the rear of the
switch until the sunroof is fully closed.
Do not leave the sunroof open for long periods of
time as debris may collect in the tracks.
169

Page 170 of 570

Anti-Pinch Protection Feature
If something gets caught between the glass panel
and roof frame while the sunroof is closing, the
glass panel will stop and open half way, and
the deector will raise fully.
If something gets caught between the glass panel
and the roof frame during the tilt down operation,
the glass panel will stop and open fully.
If the sunroof panel receives a strong impact, the
anti-pinch protection feature may work even if
nothing gets caught between the glass panel and
roof frame.
Do not to leave the sunroof open for long periods
of time as debris may collect in the tracks.
Sunshade Operation
The sunshade will open automatically when
opening the sunroof.
However, it can manually be pulled shut after the
sunroof is closed. To adjust the sunshade,
push it backward or pull it forward to the desired
position. The sunshade cannot be adjusted further
than the current closed position of the sunroof.
Notice:If you force the sunshade forward of
the sliding glass panel, damage will occur
and the sunroof may not open or close
properly. Always close the glass panel before
closing the sunshade.
170

Page:   < prev 1-10 ... 121-130 131-140 141-150 151-160 161-170 171-180 181-190 191-200 201-210 ... 570 next >