HYUNDAI IONIQ 5 2022 Owners Manual

Maintenance
9-42
Instrument panel fuse panel
Fuse NameFuse Rating Circuit Protected
P/SEAT RR RH30A Rear Power Seat RH Module
A/C17.5A A/C Control Module
A/BAG115A SRS Control Module
MODULE210AAMP, P/E Junction Block (Power Outlet Relay
(RLY.11)), IBU, ADAS Unit (Parking), A/V & Navigation
Keyboard, A/V & Navigation Head Unit
MULTIMEDIA15A A/V & Navigation Head Unit
DR LOCK20A Door Lock Relay, Door Unlock Relay
MODULE110AHazard Lamp Switch, Multifunction Switch, Data
Link Connector, Rain
Sensor, P/R Junction Block (Blower Relay (RLY.9)),
Driver/Passenger Door Speaker Mood Lamp, Driver/
Passenger Door Arm Rest Mood Lamp, Rear
Door Mood Lamp LH/RH, PTG Unit, Rear Power
Seat LH/RH Module, Driver/Passenger Power Seat
Module
P/SEAT PASS30APassenger Power Seat Switch, Passenger Power Seat
Module
P/SEAT RR LH30A Rear Power Seat LH Module

09
9-43
Motor compartment fuse panel
ONE1091013
Inside the fuse/relay box cover, you can
find the fuse/relay label describing fuse/
relay names and ratings.
Information
Not all fuse panel descriptions in this
manual may be applicable to your vehicle;
the information is accurate at the time of
printing. When you inspect the fuse panel
in your vehicle, refer to the fuse panel
label.
ONE1091047N

Maintenance
9-44
Motor compartment fuse panel
Type Fuse NameFuse Rating Circuit Protected
MULTI
FUSE-1LDC180A P/R Junction Block (Fuse : F15, F17, F20, F21)
MDPS1100A MDPS Unit
MULTI
FUSE-2B+560APCB Block (IG3 Main Relay, Fuse : F1, F2, F3,
F4, F6)
B+360AICU Junction Block (Fuse : F1, F2, F10, F11,
F19, F20,F29, F37, F38, F46, F47, F55, F56)
B+260AICU Junction Block (IPS1, IPS4, IPS6, IPS8,
IPS9, IPS10)
RR HTD50A P/R Junction Block (RLY.3)
IEB160A IEB Unit
IEB260A IEB Unit
IEB440A Multipurpose Check Connector
IG140A P/R Junction Block (RLY.5, RLY.7)
IG240A P/R Junction Block (RLY.10)
MULTI
FUSE-3C/FAN80A Cooling Fan Motor
B+150A ICU Junction Block (IPS2, IPS3, IPS4, IPS5)
TRAILER150A Trailer Connector Unit
BLOWER50A P/R Junction Block (RLY.9)

09
9-45
Type Fuse NameFuse Rating Circuit Protected
FUSEB+440AICU Junction Block (Long Term Load Latch
Relay,
Fuse : F8, F17, F18, F26, F27, F35, F36, F45,
F44, F53, F54)
E-SHIFTER140A P/R Junction Block (RLY.2, Fuse : F22)
CHARGER110AP/R Junction Block (RLY.1, RLY.12), ICCU,
VCMS
CHARGER210A CDM
AMS10A 12V Battery Sensor
EWP120A Electronic Water Pump #1
EWP220A Electronic Water Pump #2
TRAILER220A Trailer Connector Unit
VESS10A VESS Unit
VCU140A VCU

Maintenance
9-46
Type Fuse NameFuse Rating Circuit Protected
FUSEP/OUTLET140A P/R Junction Block (RLY.11)
T/GATE30A PTG Unit
A/C215A A/C Control Module
EOP140A Rear Electronic Oil Pump
EOP240A Front Electronic Oil Pump (AWD)
E-SHIFTER210AP/R Junction Block (RLY.2), SCU, Electronic
ATM Shift Lever
P/OUTLET320A Rear Power Outlet
P/OUTLET220A Front Power Outlet

09
9-47
Fuse NameFuse Rating Circuit Protected
WIPER125A PCB Block (Wiper Main Relay)
EPCU115A Front Inverter (AWD)
HORN15APCB Block (Horn Relay), PCB Block (Burglar Alarm
Horn Relay)
WIPER27.5A IBU
VCU215A VCU
IG3 120A ICU Junction Block (Fuse : F14, F16, F24)
IG3 315A Electronic Water Pump
IG3 510A BMS Coolant 3Way Valve
VCU310A VCU
IG3 410AA/C Coolant Valve, Electronic Water Pump #1, #2,
Electronic A/C Compressor
IEB310A Multipurpose Check Connector, IEB Unit
IG3 610A Cooling Fan Motor, Front Electronic Oil Pump (AWD)
MDPS2 *
110A MDPS Unit
IG3 215A Front Inverter (AWD), VCU
*1 : MDPS (Motor Driven Power Steering) is the same as EPS (Electric Power Steering)

Maintenance
9-48
Consult an authorized HYUNDAI dealer
to replace most vehicle light bulbs. It is
difficult to replace vehicle light bulbs
because other parts of the vehicle must
be removed before you can get to the
bulb. This is especially true for removing
the headlamp assembly to get to the
bulb(s).
Removing/installing the headlamp
assembly can result in damage to the
vehicle.
WARNING

[Prior to working on a light, depress
the foot brake, shift to P (Park), apply
the parking brake, press the Start/
Stop button to the OFF position
and take the key with you when
leaving the vehicle to avoid sudden
movement of the vehicle and to
prevent possible electric shock.

[Be aware the bulbs may be hot and
may burn your fingers.
NOTICE
Be sure to replace the burned-out bulb
with one of the same wattage rating.
Otherwise, it may cause damage to the
fuse or electrical wiring system.
NOTICE
To prevent damage, do not clean the
headlamp lens with chemical solvents
or strong detergents.
Information - Headlamp
desiccant (if equipped)
This vehicle is equipped with desiccant to
reduce fogging inside the headlamp due
to moisture. The desiccant is consumable
and its performance may change based on
the used period or environment. If fogging
inside the headlamp due to moisture
continues for a long time, consult an
authorized HYUNDAI dealer.
Information
The headlamp and tail lamp lenses could
appear frosty if the vehicle is washed after
driving or the vehicle is driven at night in
wet weather. This condition is caused by
temperature difference between the lamp
inside and outside and, it does not indicate
a problem with your vehicle. When
moisture condenses in the lamp, it will be
removed after driving with the headlamp
on. The removable level may differ
depending on lamp size, lamp position
and environmental condition. However, if
moisture is not removed, have your vehicle
inspected by an authorized HYUNDAI
dealer.
LIGHT BULBS

09
9-49
Information

[A normally functioning lamp may
flicker momentarily to stabilize the
vehicle’s electrical control system.
However, if the lamp goes out after
flickering momentarily, or continues to
flicker, have the system checked by an
authorized HYUNDAI dealer.

[The Parking lamp may not turn on
when the Parking lamp switch is turned
on, but the Parking lamp and headlamp
switch may turn on when the headlamp
switch is turned on. This may be caused
by network failure or vehicle electrical
control system malfunction. If this
occurs, have the system checked by an
authorized HYUNDAI dealer.
Information
The headlamp aiming should be adjusted
after an accident or after the headlamp
assembly is reinstalled.
Headlamp, Parking Lamp, Turn
Signal Lamp, Daytime Running
Light (DRL) Replacement
„Type A
ONE1091014N
„ Type A
(1) Headlamp (High/Low)
(2) Headlamp (Low)
(3) Turn signal lamp (Bulb type)
(4) Parking lamp/Daytime running light
(DRL)
(5) Front side marker (LED)
„Type B
ONE1091015N
„ Type B
(1) Headlamp (Low)
(2) Headlamp (High)
(3) Parking lamp/Daytime running light/
Turn signal lamp (LED)
(4) Front side marker (LED)
(5) Garnish hidden lighting (if equipped)

Maintenance
9-50
If the LED lamp does not operate, have
the system inspected by an authorized
HYUNDAI dealer.
The LED lamps cannot be replaced as
a single unit because it is an integrated
unit. The LED lamps has to be replaced
with the unit.
A skilled technician should check or
repair the LED lamp, for it may damage
related parts of the vehicle.
Turn signal lamp (bulb type)
1. Engage the parking brake and
disconnect the negative battery cable.
2. Remove wheel guard clips (under the
front bumper).
3. Push the wheel guard aside and
remove the bulb socket by turning it
counterclockwise.
4. Remove the bulb from the socket
by pressing it in and rotating it
counterclockwise until the tabs on the
bulb align with the slots in the socket.
Pull the bulb out of the socket.
5. Install a new bulb by inserting it into
the socket and rotating it until it locks
into place.
6. Push the socket into the assembly and
turn the socket clockwise.
7. Install the wheel guard in the reverse
order.
WARNING

[Wear eye protection when changing
a bulb. Allow the bulb to cool down
before handling it.

[Always handle them carefully, and
avoid scratches and abrasions. If
the bulbs are lit, avoid contact with
liquids.

[Never touch the glass with bare
hands. Residual oil may cause the
bulb to overheat and burst when lit.

[A bulb should be operated only when
installed in a turn signal lamp.

[If a bulb becomes damaged or
cracked, replace it immediately and
carefully dispose of it.

[Replacing the bulb may cause
damage to the bulb relevant parts
of the vehicle, and also may cause
injuries. To replace the turn signal
lamp, visit an authorized HYUNDAI
dealer.

09
9-51
Side Repeater Lamp
Replacement
ONE1091029
If the LED lamp (1) does not operate,
have the system inspected by an
authorized HYUNDAI dealer.
The LED lamps cannot be replaced as
a single unit because it is an integrated
unit. The LED lamps has to be replaced
with the unit.
A skilled technician should check or
repair the LED lamp, for it may damage
related parts of the vehicle.
Rear Combination Lamp
Replacement
„Type A
ONE1091017N
„Type B
ONE1091018N
(1) Rear lamp/Stop lamp
(2) Stop lamp/Turn signal lamp
(3) Reverse lamp
- Type A : Bulb
- Type B : LED (if equipped)
(4) Rear side marker (LED)
If the LED lamp does not operate, have
the system inspected by an authorized
HYUNDAI dealer.
The LED lamps cannot be replaced as
a single unit because it is an integrated
unit. The LED lamps has to be replaced
with the unit.
A skilled technician should check or
repair the LED lamp, for it may damage
related parts of the vehicle.