display HYUNDAI IONIQ 6 2023 Owner's Manual

Introduction/Getting Started with Your Electric Vehicle
1-56
Tips for enhancing the distance to empty
The distance to empty vary depending on the charge level of the high voltage battery,
weather, temperature, duration of the battery use, terrain, driving habits, etc.
You can increase the distance to empty by driving the vehicle following the instructions
below.
• The air resistance increases rapidly as the electric vehicle drives faster, so avoid speeding to increase the distance to empty and the electric energy economy.
• Rapid acceleration consumes a lot of driving energy and rapid deceleration limits the regenerative braking. Gradually depress and release the accelerator pedal when
accelerating or decelerating to maintain speed.
• If you operate the air conditioner or heater too much, the high voltage battery uses excessive electricity. This may reduce the distance to empty. Therefore, set the cabin
temperature to 72 °F (22 °C) AUTO level 2. Various assessment tests have been used to
verify that this setting maintains optimal energy consumption rates. Especially in
winter, reducing heating and using heated seats instead can significantly increase the
distance to empty. Turn off the air conditioner or heater if you do not need them.
• When using the air conditioner or heater, the energy consumption is reduced if recirculation mode is selected instead of fresh mode. Fresh mode requires a large
amount of energy consumption as the outside air has to be reheated or cooled.
• Close the windows while driving. Driving with the windows open increases air resistance and the usage of the air conditioner or heater.
• When using the air conditioner or heater while driving alone, use the DRIVER ONLY function.
• Always maintain specified tire pressures and use tires for electric vehicles.
• Do not use unnecessary electrical components while driving.
• Do not load unnecessary items in the vehicle.
• Do not mount parts that may increase air resistance.
When the distance to empty is insufficient
• When the High voltage battery level warning light is displayed, immediately charge the vehicle at a nearby charging station.
• Drive energy efficiently following the “Tips for enhancing the distance to empty.”
• When the battery level is 0 %, do not try to drive. Move to a safe place and call for help.
Hyundai_CE_en_US.book Page 56

1
1-57
Checking the real time energy status (CHARGE/POWER gauge)
The CHARGE/POWER gauge displays the charging and discharging status of the electric
energy produced by the regenerative braking and the energy consumption of the electric
motor.
B0002902
•CHARGE : Shows the charging status of the electric motor when vehicle is decelerating
or driving on a downhill road (being charged by the regenerative brakes). The more
electric energy is charged, the lower the gauge level.
• POWER : Shows discharging status of the electric motor when vehicle is accelerating or
driving on an uphill road. The more electric energy is discharged (used), the higher the
gauge level.
Checking the State of Charge (SOC)
The SOC indicator is displayed at the bottom of the CHARGE/POWER gauge and shows
the charge level of the high voltage battery as a percentage. The lower the number, the
more the vehicle needs to be charged, and 100 % indicates a full charge.
B0002903
Hyundai_CE_en_US.book Page 57

Introduction/Getting Started with Your Electric Vehicle
1-58
B0002904
• When the remaining battery of the high voltage battery is lower than 10 %, the warning light will be displayed.
• When the warning light is displayed, charge the vehicle.
Information • To find a nearby charging station, refer to the “Searching for nearby charging stations” in this chapter.
• Check if the SOC is enough before driving on highways.
• After the warning light is displayed, immediately charge the vehicle at a nearby charging station. The vehicle may not operate properly depending on the driving speed, weather, and
other driving conditions.

Checking the warning and indicator lights
The warning and indicator lights are displayed in the middle of the instrument cluster
before or while driving, depending on the status of the electric vehicle. Understand the
meaning of the warning and indicator lights referring to the instructions below and drive
safely.
CAUTION If the warning light illuminates while driving or does not go off, have the vehicle
inspected by an authorized HYUNDAI dealer.

Hyundai_CE_en_US.book Page 58

1
1-61
Checking warning messages
Check the meaning of the warning messages referring to the table below and take
appropriate measures.
WARNING • Do not drive with a warning message displayed.
• If a warning message does not go off after taking measures, have the vehicle immediately inspected and repaired by an authorized HYUNDAI dealer.

Warning MessageCauseMeasure
Low EV battery The high voltage battery level
reaches below 20 %.
• The warning light on the instrument cluster turns on
simultaneously. Charge the vehicle
immediately.
Charge immediately.
Power limited The high voltage battery level
reaches below 10 %.
• The warning light on the
instrument cluster turns on
simultaneously.
• The vehicle’s power may be reduced to minimize the
energy consumption of the
high voltage battery. Charge the battery
immediately.
Check electric vehicle
system There is a problem with the
electric vehicle control system. • Do not drive when the warning
message is displayed.
• Have the vehicle inspected by an authorized HYUNDAI
dealer.
-PX
CBUUFSZ
$IBSHF

JNNFEJBUFMZ
1PXFS
MJNJUFE
$IFDL
FMFDUSJD
WFIJDMF
TZTUFN
Hyundai_CE_en_US.book Page 61

Introduction/Getting Started with Your Electric Vehicle
1-62
Power limitedThis warning message is
displayed when the power of
the vehicle is limited to ensure
the safety of high-powered
components for the reasons
below:
• The high voltage battery level
is too low or voltage is
decreasing.
• The temperature of the high voltage battery is too high or
too low.
• When the driving system is overheated and requires
protection. If it illuminates alone, it did not
fail.
• Charge the vehicle is the
charge level is low.
• If both Power down indicator light and Service warning
light illuminate at the same
time, have the vehicle
inspected by an authorized
HYUNDAI dealer.
• Do not accelerate or start the vehicle suddenly when the
warning message is
displayed.
• Be careful when the Power down indicator light is
displayed. The vehicle may
not properly drive uphill and
roll back on a slope.
Low EV battery
temperature. Power
limited If you start or turn off the
vehicle when the outside
temperature is low, both
warning messages appear to
protect electric vehicle system.
• If the high voltage battery
charge level is low and parked
outside for a long time,
vehicle power could be
limited due to the low battery
temperature. • Charging the battery before
driving helps increase power.
• If these warning messages are still displayed even after the
ambient temperature has
increased, have the vehicle
inspected and repaired by an
authorized HYUNDAI dealer.
EV Battery
Overheated! Stop
vehicle The high voltage battery
temperature is too high. • Stop the vehicle in a safe place
and turn off the Start/Stop
button and wait until the
battery temperature
decreases.
• If these warning messages are still displayed even after
turning off the engine and
waiting for a sufficient time,
immediately have the vehicle
inspected by an authorized
HYUNDAI dealer.
Warning MessageCauseMeasure
1PXFS
MJNJUFE
-PX
CBUUFSZ

UFNQFSBUVSF
1PXFS
MJNJUFE
#BUUFSZ
PWFSIFBUFE 4UPQ
TBGFMZ
Hyundai_CE_en_US.book Page 62

1
1-63
Stop vehicle and
check power supplyA failure occurs in the power
supply system. Immediately stop the vehicle in
a safe place. Have the vehicle
towed to an authorized
HYUNDAI dealer for inspection
and maintenance.
Unplug vehicle to
start You have started the vehicle
with the charging connector
plugged in. Unplug the charging cable and
start the vehicle.
Charging Door Open You have started the vehicle
with the charging door opened. Check if the charging door is
completely closed after
charging the vehicle.
Charging Stopped.
Check the AC charger These warning messages are
displayed when charging is
stopped for the reasons below:
• There is a problem with the
external AC charger or DC
charger.
• The external AC charger stopped the charging.
• The charging cable is damaged. • Check whether there is any
problem with the external AC
or DC charger and charging
cable.
• Charge the vehicle with an AC charger that has been
approved for proper operation
or a genuine HYUNDAI
portable charger.
• If the same problem occurs, have the vehicle inspected by
an authorized HYUNDAI
dealer.
Warning MessageCauseMeasure
4UPQ
TBGFMZ
BOE
DIFDL
QPXFS TVQQMZ
6OQMVH
WFIJDMF UP
TUBSU
$IBSHJOH
EPPS PQFO
$IBSHJOH
TUPQQFE1MFBTF
DIFDL
UIF
"$
DIBSHFS
Hyundai_CE_en_US.book Page 63

Introduction/Getting Started with Your Electric Vehicle
1-64
Charging Stopped.
Check the cable
connectionThese warning messages are
displayed when charging is
stopped for the reasons below:
• The charging connector is not
correctly connected to the
charging inlet.
• The unlock button on the charging connector is
pressed. • Separate the charging
connector from the vehicle
and reconnect it.
• Check whether there is any problem, such as external
damage, foreign substances,
etc., with the charging
connector and charging inlet.
• Charge the vehicle with a charger that has been
approved for proper operation
or a genuine HYUNDAI
portable charger.
• If the same problem occurs, have the vehicle inspected by
an authorized HYUNDAI
dealer.
Warning MessageCauseMeasure
$IBSHJOH
JOUFSSVQUFE
1MFBTF
DIFDL
UIF
DBCMF
DPOOFDUJPO
Hyundai_CE_en_US.book Page 64

2
2-7
Steering Wheel Control Overview
A1000701The actual shape may differ from the illustration.
(1) Lighting control lever ............................................................................................... 5-67
(2) Wiper and washer control lever .............................................................................. 5-77
(3) Rotary shifter(Rotary gearshift dial) .........................................................................6-8
(4) Paddle shifter ........................................................................................................... 6-14
(5) Voice recognition button ....................................................................................... 5-109
(6) Steering wheel audio controls .............................................................................. 5-108
(7) Bluetooth® wireless technology hands-free button ............................................. 5-110
(8) Cluster display control............................................................................................. 4-23
(9) Lane Driving Assist button ...................................................................................... 7-29
(10) Driving Assist button .............................................................................................. 7-64
(11) Vehicle Distance button .......................................................................................... 7-65
(12) Drive mode button ..................................................................................................6-39
5
7
108
11
12
9
1244
3
6
Hyundai_CE_en_US.book Page 7

3
3-41
SRS warning light
B3002501
The SRS (Supplemental Restraint System)
airbag warning light on the instrument
cluster the airbag symbol depicted in the
illustration. The system checks the airbag
electrical system for malfunctions. The
light indicates that there is a potential
problem with your airbag system, which
could include your side and/or curtain
airbags used for rollover protection.
WARNING If your SRS malfunctions, the airbag may
not inflate properly during an accident
increasing the risk of serious injury or
death.
If any of the following conditions occur,
your SRS is malfunctioning:
• The light does not turn on for about 3-6 seconds when the Start/Stop button is
in the ON position.
• The light stays on after illuminating for about three to 6 seconds.
• The light comes on while the vehicle is in motion.
• The light blinks when the (ready indicator) is displayed on the
instrument cluster.
Have an authorized HYUNDAI dealer
inspect the SRS as soon as possible if any
of these conditions occur.
During a moderate to severe frontal
collision, sensors will detect the vehicle’s
rapid deceleration. If the rate of
deceleration is high enough, the control
unit will inflate the front airbags, at the
time and with the force needed.
The front airbags help protect the driver
and front passenger by responding to
frontal impacts in which seat belts alone
cannot provide adequate restraint. When
needed, the side airbags help provide
protection in the event of a side impact or
rollover by supporting the side upper
body area.
• Airbags are activated (able to inflate if
necessary) only when the Start/Stop
button is in the ON or START position,
and it can be activated within about 3
minutes after the vehicle is turned off.
• Airbags inflate in the event of certain frontal or side collisions to help protect
the occupants from serious physical
injury.
• Generally, airbags are designed to inflate based upon the severity of a
collision, its direction, or etc. These two
factors determine whether the sensors
produce an electronic
deployment/inflation signal.
• The front airbags will completely inflate and deflate in an instant. It is virtually
impossible for you to see the airbags
inflate during an accident. It is much
more likely that you will simply see the
deflated airbags hanging out of their
storage compartments after the
collision.
• In addition to inflating in serious side collisions, vehicles equipped with a
rollover sensor, side and/or curtain
airbags will inflate if the sensing system
detects a rollover.
When a rollover is detected, curtain
airbags will remain inflated longer to
help provide protection from ejection,
especially when used in conjunction
with the seat belts. (if equipped with a
rollover sensor)
Hyundai_CE_en_US.book Page 41

4
4. Instrument Cluster
Instrument Cluster........................................................................................................... 4-2Instrument Cluster Control ......................................................................................... 4-3
Gauges and Meters ...................................................................................................... 4-3Power/Charge Gauge .................................................................................................. 4-3
State of Charge (SOC) Gauge for High Voltage Battery............................................4-4
Gear Shift Indicator ...................................................................................................... 4-5Warning and Indicator Lights......................................................................................4-6Cluster Display Messages.......................................................................................... 4-16
Cluster Display ............................................................................................................... 4-23 Cluster Display Control.............................................................................................. 4-23
View Modes ................................................................................................................ 4-23
Vehicle Settings (Infotainment System) ...................................................................... 4-26 Setting Your Vehicle .................................................................................................. 4-27
Hyundai_CE_en_US.book Page 1