ESP INFINITI G CONVERTIBLE 2013 Quick Reference Guide

4
first drive features
INFINITI Intelligent Key™ System
The INFINITI Intelligent Key™ system allows you to lock or
unlock the vehicle, open the trunk and start the engine.
NOTE: It is important to make sure the Intelligent Key is
with you (that is, in your pocket or purse).
The oper ating range of the Intelligent Key is within



31.5 in (80 c
m) from each request switch.
To lock the vehicle, push either door handle request
s

witch
01 once or press the
button
02 on
the k
eyfob.
T o unlock the vehicle, perform one of the following procedures:
• Push
either door handle request

switch
01 once; the
c
orresponding door will unlock. Push the door handle



r

equest switch
01 again within 1 minute; all other
door
s will unlock, or
• Press


the
button
03 on the keyfob to unlock the driver’s

s
ide door. Press the
button again; all other doors will unlock.
T
o release the trunk lid, press the button
04 for more than
1 sec
ond. Lift the trunk lid to access the trunk.
T o retract your hard top (Convertible models), push and hold the door handle request switch
01
u
ntil the hard top is fully open.
The Int elligent Key can also be used to activate the panic alarm by pressing and holding the

b
utton 05 for more than 1 second. Once activated, the panic alarm and headlights will stay
on f
or 25 seconds.
INFINITI INTELLIGENT KEy™ BATTERy DISCHARGE
If the battery in the Intelligent Key is almost discharged,



the guide light 06 of the Intelligent Key port blinks and
the Int
elligent Key battery discharge indicator 07 is
di
splayed in the dot matrix liquid crystal display.
T o start the engine under these circumstances, insert



the Int
elligent Key into the key port with the buttons



f
acing upward and the key ring end toward you until



it
latches into place. Then push the ignition switch to



s
tart the engine.
To remove the Intelligent Key from the port, push the



ignition sw
itch to turn the engine off and then pull the



Int
elligent Key out of the port.
The Int elligent Key port does not charge the Intelligent Key battery. If you see the low battery
indic

ator
07 , replace the battery in the Intelligent Key.
For more information, refer to the “Pre-driving checks and adjustments (section 3)”, the “Starting and driving (section 5)” and the
“Maintenance and do-it yourself (section 8)” of your Owner’s Manual.
01
07
06
02
03
04
05

11
FM/AM/SiriusXM™* Satellite Radio With CD/DVD Player (with Navigation System)
(if so equipped)
01 V OLUME/ON•OFF CONTROL KNOB

Pr
ess the VOL/ON•OFF control knob to turn the system on or off. Turn the knob right or left



t
o increase or decrease the volume.
02 SEEK•CAT AND TRACK BUTTONS

T
o scan quickly through each broadcasting station, press the SEEK•CAT button or the


tr
AC k button to stop at the previous or next broadcast station.
F
or Sirius x M™ satellite radio, press the SEEK•CAT button or the trACk button to switch to


the fir

st channel of the previous or next category.
Pr
ess the SEEK•CAT button or the tr AC k button to change tracks on a CD.
Pr
ess and hold the SEEK•CAT button or the tr AC k b
utton to fast forward or rewind a track



on a CD
.
03 t UNE/FOLDE r /AUDIO CON tr OL k NOB

T
o manually tune the radio, turn the t UNE/FOLDE r /AUDIO knob left or right.
04 StAtION P r ESE t BU ttONS

T
welve stations can be set for the FM band, six for the AM band and eighteen for



Siriu
s x M satellite radio.
T
o store a station in a preset, you must first select a radio band by pressing the AM•FM/



S
A t
b
utton
05 , then tune to the desired AM, FM or Sirius x M satellite station.

Then pr
ess and hold the desired station preset button (1-6) until the preset number is



upd
ated on the display and the sound is briefly muted. The channel indicator will then

d

isplay and the sound will resume. Programming is now complete.
T
o retrieve a previously set station, select the radio band where the preset was stored,



then pr
ess the corresponding station select button (1-6).
*SiriusxM™ Satellite Radio is only available on vehicles equipped with optional SiriusxM™ satellite subscription service.
For more information, refer to the “Monitor, climate, audio, phone and voice recognition systems (section 4)” of your Owner’s Manual.
01
05
0203
04

16
system guide
Speak in a clear and natural voice without pausing between words.
Look straight ahead and avoid speaking too loudly or too softly.
To go back to the previous command, say “Go back”.
To cancel a voice recognition session, say “Exit” or press and hold the
or
button.
T o interrupt the system voice and give a command quickly, press the
or
button.
When s peaking Phonebook names, please be aware some phones require the last name to be



s
poken before the first name. For example, “Michael Smith” may be spoken as “Smith Michael”.
To increase or decrease the volume of the voice prompts, push the volume control switches

or
+ on the steering wheel or turn the VOL/ON•OFF control knob on the audio system while

the sy
stem is responding.
If the Voice Recognition system does not recognize your voice commands, train the system



u
sing the Speaker Adaptation Mode. See your Owner’s Manual for detailed information.
Some c ommands are not available while the vehicle is in motion.
The “Help” c ommand can be used to hear a list of available commands at any time.
Please refer to the cellular phone manufacturer’s Owner’s Manual for detailed information



r
egarding your Bluetooth phone.
Bluetooth® System with Navigation (if so equipped)
CONNECTING PROCEDURE
NOTE: The vehicle must be stationary when connecting
the phone.
1.


Pr
ess the P h ONE button on the instrument panel or
the button on the steering wheel and select the
“C
onnect Phone” key.
2.


Initi

ate connecting from the phone.
• The
connecting procedure
v
aries

according to each




c

ellular phone model. For detailed connecting



in

structions and a list of compatible phones,



p

lease visit www.InfinitiUSA.com/bluetooth.
• When
prompted for a PIN code, enter “1234”




fr

om the handset. (The PIN code is assigned



b

y INFINITI and cannot be changed.)
3.


When the c
onnecting is complete, the screen will



r

eturn to the Phone menu display.