trunk INFINITI M HYBRID 2013 Dismantling Guide

6. Remove the front trunk trim panel (1) and remove the trunk floor trim panel (2) .
7.
Remove the battery inlet duct A (1) , DC/DC converter outlet duct (2) and battery outlet duct B
(3) .
8. Remove the DC/DC harness (1) , the 12V battery vent tube (2) and the high voltage harness clip (A) . Grip the tip of the tube to remove the 12V battery vent
tube. AAYIA0070ZZ
AAYIA0071ZZ
JSCIA0011ZZ
42

16. Remove the mounting nut (A) and then disconnect the
harness from the fuse box on the left side of the trunk
room.
17. Disconnect the brake power supply backup unit harness connector (A) and remove the ground cable mounting
bolts (B) . : Vehicle front
18.

Disconnect the high voltage harness connector (A) and
harness connector (B) . : Vehicle front
Touching high voltage components without wearing
appropriate

PPE will cause electrocution. Immediately protect the terminals of the disconnected
high

voltage harness connector socket using
insulated tape so that they are not exposed. JSCIA0279ZZ
JSCIA0280ZZ
JSCIA0281ZZ
AAYIA0043ZZ
45

25. Remove the high voltage battery pack mounting bolts (A)
from the trunk side. : Vehicle front
Touching high voltage components without wearing
appropriate

PPE will cause electrocution.
26. Place a plywood panel (A) on top of the spare tire, then lift the high voltage battery pack upwards (1) and slide a
cardboard panel (B) underneath it (2) . Touching high voltage components without wearing
appropriate

PPE will cause electrocution.
27. Pull the cardboard (A) together with the high voltage battery pack (1) toward the rear of the vehicle. Touching high voltage components without wearing
appropriate

PPE will cause electrocution. JSCIA0018ZZ
JSCIA0019ZZ
JSCIA0020ZZ
48

28. Follow the procedure below to remove the high voltage battery pack from the trunk room.
Touching high voltage components without wearing appropriate PPE will cause
electrocution.
a.
Attach carabiners (A) in the positions as shown in the figure, and then connect a slinger (B)
to them.
b. Using an engine crane (A) to lift up the high voltage battery pack (1) and remove it from the trunk room. JSCIA0021ZZ
JSCIA0284ZZ
49

• Be careful that the engine crane does not contact
the trunk lid.
• Apply protection so that no scratches or other damage occurs on the vehicle body or trunk lid.
29. Remove the DC/DC converter inlet duct clips (A) and then the DC/DC converter inlet duct (1) . Touching high voltage components without wearing
appropriate

PPE will cause electrocution.
30. Remove the battery cooling fan mounting bolts (A) and remove the battery cooling fan (1) . Touching high voltage components without wearing
appropriate

PPE will cause electrocution. JSCIA0282ZZ
AAYIA0048ZZ
AAYIA0049ZZ
50