windshield wipers INFINITI Q50 2015 Quick Reference Guide

16
first drive features
LANE CHANGE SIGNAL

Move the lever up or down until the turn signal begins to flash but the lever does not latch
to signal a lane change. Hold the lever until the lane change is completed.

Move the lever up or down until the turn signal begins to flash but the lever does not latch
and release the lever. The turn signal will automatically flash three times.

Choose the appropriate method to signal a lane change based on road and
traffic conditions.
For more information, refer to the “Instruments and controls (section 2)” of your Owner’s Manual.
Windshield Wiper and Washer Switch
RAIN-SENSING AUTO WIPER SYSTEM (if so equipped)

Move the lever to one of the following positions to
operate the windshield wipers:

1 Mist (MIST) – One sweep operation of
the wipers.

2 Auto (AUTO ) – Operates the rain-sensing wipers
intermittently. The intermittent speed can be
adjusted by twisting the time control ring
3
to increase or decrease wiper sensitivity.

4 Low (LO) – Wipers operate at a continuous
low-speed.

5 High (HI) – Wipers operate at a continuous
high-speed.

6 Pull the lever toward you to activate the washer.
The wipers will operate several times.
PULLING UP THE WIPER ARM

The wiper arm should be in the up position when
replacing the wiper.

To pull up the wiper arm, push the wiper switch to
the MIST
1 position twice when the ignition
switch is in the OFF position within 1 minute. The
wiper operation stops in mid-operation and the wiper arm can be pulled up.

The shift lever should be in the P (PARK) position.

To return the wiper arm, place the wiper arm in the down position and operate the wiper
switch once.
For more information, refer to the “Instruments and controls (section 2)” of your Owner’s Manual.
6
MIST
OFFAUTO
LO
HI
3
1
2
4
5
2045927_15c_Infiniti_Q50_QRG_071415.indd 167/14/15 3:39 PM