ISUZU TF SERIES 2004 Workshop Manual

Page 131 of 4264

RESTRAINT CONTROL 9A1-61

DTC B1000 (Flash Code 72) SDM Internal Fault (SDM=SRS control unit)


RTW49JLF000101
Circuit Description
DTC B1000 is an indication of a potential internal SRS
control unit malfunction and will set if any of the
following conditions are detected:
1) Microprocessor energy reverse time failure.
2) EEPROM read / write failure.
3) ROM check sum.
4) Calibration check sum fault.
5) Inflators reserve voltage low.
6) Inflators electronic sensor active signal not detected
during commanded deployment.
7) QSDD (High-side/Low-side) FET failure.
8) Frontal accelerometer failure.
9) Phase lock loop lost lock.
10) QSDD communication fault.
DTC Will Set When
Any of the above indicated malfunctions are detected by
the SRS control unit. The malfunctions described
above are tested mainly during “Continuous Monitoring”
and some ones run each ignition cycle.

Action Taken
SRS control unit turns “ON” the “AIR BAG” warning
lamp and sets a diagnostic trouble code.

DTC Will Clear When
SRS control unit is replaced.

Page 132 of 4264

9A1-62 RESTRAINT CONTROL SYSTEM

DTC B1000 (Flash Code 72) SDM Internal Fault (SDM=SRS control unit)
WARNING: DURING SERVICE PROCEDURES. BE VERY CAREFUL WHEN HANDLING A SRS CONTROL
UNIT. NEVER STRIKE OR JAR THE SRS CONTROL UNIT. NEVER POWER UP THE SRS WHEN THE SRS
CONTROL UNIT IS NOT RIGIDLY ATTACHED TO THE VEHICLE. ALL SRS CONTROL UNIT AND MOUNTING
BRACKET FASTENERS MUST BE CAREFULLY TORQUED AND THE ARROW MUST BE POINTING TOWARD
THE FRONT OF THE VEHICLE TO ENSURE PROPER OPERATION OF THE SRS. THE SRS CONTROL UNIT
COULD BE ACTIVATED WHEN POWERED WHILE NOT RIGIDLY ATTACHED TO THE VEHICLE WHICH
COULD CAUSE DEPLOYMENT AND RESULT IN PERSONAL INJURY.
CAUTION: If DTC B1000 can not clear by Tech2, it is necessary to replace the SRS control unit.

Step Action Yes No
1 Was the “SRS Diagnostic System Check” performed? Ignition switch
“OFF.”
Replace SRS
control unit.
Repeat the “SRS
Diagnostic System
Check” Go to the “SRS
Diagnostic System
Check”

Page 133 of 4264

Page 134 of 4264




No. TFRET-WE-0431

Page 135 of 4264




WORKSHOP MANUAL
TF SERIES
AXLE

SECTION 4

Page 136 of 4264

Page 137 of 4264

PROPELLER SHAFT 4A-1
SECTION 4A
PROPELLER SHAFT
TABLE OF CONTENTS
PAGE
Main Data and Specifications ........................................................................................... 4A- 3
Rear Propeller Shaft...................................................................................................... 4A- 3
Torque Specifications ....................................................................................................... 4A- 5
Front Propeller Shaft ................................................................................................... 4A- 6
Torque Specifications ....................................................................................................... 4A- 7
Rear Propeller Shaft .......................................................................................................... 4A- 8
General Description ...................................................................................................... 4A- 8
Removal and Installation .............................................................................................. 4A-11
Universal Joint Disassembly........................................................................................ 4A-12
Inspection and Repair .................................................................................................. 4A-14
Universal Joint Reassembly ........................................................................................ 4A-16
Rear Propeller Shaft Assembly ........................................................................................ 4A-17
Disassembly and Reassembly .................................................................................... 4A-18
Front Propeller Shaft ........................................................................................................ 4A-19
Removal and Installation .............................................................................................. 4A-19
Disassembly ................................................................................................................. 4A-21
Universal Joint Disassembly and Reassembly ......................................................... 4A-23
Reassembly .................................................................................................................. 4A-27

Page 138 of 4264

4A-2 PROPELLER SHAFT
Service Precaution
WARNING: THIS VEHICLE HAS A
SUPPLEMENTAL RESTRAINT SYSTEM (SRS).
REFER TO THE SRS COMPONENT AND WIRING
LOCATION VIEW IN ORDER TO DETERMINE
WHETHER YOU ARE PERFORMING SERVICE ON
OR NEAR THE SRS COMPONENTS OR THE SRS
WIRING. WHEN YOU ARE PEREFORMING
SERVICE ON OR NEAR THE SRS COMPONENTS
OR THE SRS WIRING, REFER TO THE SRS
SERVICE INFORMATION. FAILURE TO FOLLOW
WARNING COULD RESULT IN POSSIBLE AI
R
BAG DEPLOYMENT, PERSONAL INJURY, OR
OTHERWISE UNNEEDED SRS SYSTEM
REPAIRS. CAUTION : Always use the correct fastener in the
proper location. When you replace a fastener,
use ONLY the exact part number for that
application. ISUZU will call out those fasteners
that require a replacement after removal. ISUZU
will also call out the fasteners that require thread
lockers or thread sealant. UNLESS OTHERWISE
SPECIFIED, do not use supplemental coatings
(Paints, greases, or other corrosion inhibitors)
on threaded fasteners or fastener joint
interfaces. Generally, such coatings adversely
affect the fastener torque and the joint clamping
force, and may damage the fastener. When you
install fasteners, use the correct tightening
sequence and specifications. Following these
instructions can help you avoid damage to parts
and systems.

Page 139 of 4264

PROPELLER SHAFT 4A-3
MAIN DATA AND SPECIFICATIONS
REAR PROPELLER SHAFT

mm(in)
4
2 Model
Engine Model 4JA1-T(L) 4JA1-TC 4JH1-TC
Transmission Type 5 M/T (MUA) 5M/T (MUA) 4A/T
Wheel Base Long Long Extra Long Long
Front Suspension  High Ride
SuspensionExcept High
Ride
Suspension 
Rear Axle 
220mm 



Type 
OBS 



Outside Diameter mm 75 68.9 68.9 68.9 63.5
(in) (2.95) (2.71) (2.71) (2.71) (2.50)
Inside Diameter mm 71.8 64.9 64.9 64.9 60.3
(in) (2.89) (2.63) (2.63) (2.63) (2.44)
Length 1st(L1) mm 799.5 798.5 801.5 946.5 720.5
(in) (31.48) (31.44) (31.56) (37.26) (28.37)
2nd(L2) mm 796 801 796 801 801
(in) (31.34) (31.54) (31.34) (31.54) (31.54)
Spline Major mm 29.89 29.89 29.89 29.89 29.89
Diameter (in) (1.18) (1.18) (1.18) (1.18) (1.18)
Fix Bolt Size M10 M10 M10 M10 M10
* OBS - Outboard Slip (Spline Engagement To T/M)



mm(in)
4
2 Model
Engine Model C24SE
6VE1
Transmission Type 5M/T (MUA)
5M/T (MUA) 4A/T
Wheel Base Long Extra Long Long Extra Long Long Extra Long
Front Suspension High Ride
Suspension Except High
Ride
Suspension





Rear Axle 


220mm 



Type 


OBS 



Outside Diameter mm 75 75 75 68.9 68.9 75 75
(in) (2.95) (2.95) (2.95) (2.71) (2.71) (2.95) (2.95)
Inside Diameter mm 71.8 71.8 71.8 64.9 64.9 71.8 71.8
(in) (2.89) (2.89) (2.89) (2.63) (2.63) (2.89) (2.89)
Length 1st(L1) mm 823.5 820.5 970.5 823.5 971.5 778.5 928.5
(in) (32.42) (32.30) (38.21) (32.42) (38.25) (30.65) (36.56)
2nd(L2) mm 801 796 796 801 801 801 801
(in) (31.54) (31.34) (31.34) (31.54) (31.54) (31.54) (31.54)
Spline Major mm 29.89 29.89 29.89 29.89 29.89 30.48 30.48
Diameter (in) (1.18) (1.18) (1.18) (1.18) (1.18) (1.20) (1.20)
Fix Bolt Size M10 M10 M10 M10 M10 M10 M10
* OBS - Outboard Slip (Spline Engagement To T/M)

Page 140 of 4264

4A-4 PROPELLER SHAFT

mm(in)
4
4 Model
Engine Model 4JA1-T(L) 4JA1-TC 4JH1-TC
Transmission Type 5M/T (MUA) 5M/T (MUA) 4A/T
Wheel Base Long Long Extra Long Long
Front Suspension 




Rear Axle 220mm 220mm 


Type OBS OBS 


Outside Diameter mm 75 68.9 68.9 63.5
(in) (2.95) (2.71) (2.71) (2.50)
Inside Diameter mm 71.8 64.9 64.9 60.3
(in) (2.89) (2.63) (2.63) (2.44)
Length 1st(L1) mm 469.5 468.5 616.5 402.5
(in) (18.48) (18.44) (24.27) (15.85)
2nd(L2) mm 801 801 801 801
(in) (31.54) (31.54) (31.54) (31.65)
Spline Major mm 29.89 29.89 29.89 29.89
Diameter (in) (1.18) (1.18) (1.18) (1.18)
Fix Bolt Size M10 M10 M10 M10
* OBS - Outboard Slip (Spline Engagement To T/M)


mm(in)
4
4 Model
Engine Model C24SE 6VE1
Transmission Type 5M/T
(MUA) 5M/T (MUA) 4A/T
Wheel Base Long Long Extra Long Long
Front Suspension    
Rear Axle    
Type    
Outside Diameter mm 63.5 68.9 68.9 75
(in) (2.50) (2.71) (2.71) (2.95)
Inside Diameter mm 60.3 64.9 64.9 71.8
(in) (2.44) (2.63) (2.63) (2.89)
Length 1st(L1) mm 495.5 492.5 641.5 484.5
(in) (19.51) (19.39) (25.26) (19.07)
2nd(L2) mm 801 801 801 801
(in) (31.54) (31.54) (31.54) (31.54)
Spline Major mm 29.89 29.89 29.89 29.89
Diameter (in) (1.18) (1.18) (1.18) (1.18)
Fix Bolt Size M10 M10 M10 M10
* OBS - Outboard Slip (Spline Engagement To T/M)

Page:   < prev 1-10 ... 91-100 101-110 111-120 121-130 131-140 141-150 151-160 161-170 171-180 ... 4270 next >