c24se ISUZU TF SERIES 2004 Workshop Manual

6H-2 ENGINE SPEED CONTROL SYSTEM (C24SE)
Accelerator Pedal Control Cable

RHD MODEL


RTW46HLF000501

Removal
1. Disconnect the accelerator control cable from the
accelerator pedal and dash panel.
2. Remove the cable clips.
3. Remove the accelerator control cable from
accelerator control cable bracket.
1) Slide the lock in direction A
2) Rotate the ratchet ring in indirection an arro
w
90
.

ENGINE SPEED CONTROL SYSTEM (C24SE) 6H-3
4. Remove the accelerator control cable from the
throttle.




LHD MODEL

RTW46AMH000101

Inspection
Check the following items and replace the control
cable if any abnormality is found.
 The control cable should move smoothly.
 The control cable should not be bent or kinked.
 The control cable should not be damage o
r
corrosion.
Installation
1. Install the accelerator control cable to accelerator
control pedal dash panel.
2. Install the accelerator control cable to throttle.
Attach T-END and inner cable to throttle cam o
f
engine.
3. Install accelerator control cable to accelerato
r
bracket.
1) Rotate the ratchet ring in direction an arrow 90

until both white marking are aligned.
2) Confirm marking of outer cap must be uppe
r
side.
3) Slider the lock in direction B.
4) Confirm ratchet ring is locked.

6H-4 ENGINE SPEED CONTROL SYSTEM (C24SE)
MEMO

0B-2 MAINTENANCE AND LUBRICATION
MAINTENANCE SCHEDULE (For GENERAL EXPORT)
Items followed by an asterisk (*) require more frequent maintenance if the vehicle is driven under severe conditions.
Refer to "SEVERE CONDITIONS MAINTENANCE SCHEDULE."

I : Inspect and correct or replace as necessary A : Adjust
R : Replace or change T : Tighten to specified torque L : Lubricate


SERVICE INTERVAL:

1,000 km 5 10 15 20 25 30 35 40 45 50 55 60 65 70 75 80 85 90 95 100(Use odometer reading
1,000 miles 3 6 9 12 15 18 21 24 27 30 33 36 39 42 45 48 51 54 57 60or months whichever
comes fi rst)
or months 6 12 18 24 30 36 42 48 54 60 66 72 78 84 90 96 102 108 114 120
ENGINE Idling speed and acceleration
(GASOLINE) I I - I - I - I - I - I - I - I - I - I
(DIESEL) I I I I I I I I I I I I I I I I I I I I * Air cleaner element
(GASOLINE) - I - I - I - R - I - I - I - R - I - I
(DIESEL) I I I I I I I R I I I I I I I R I I I I * P Engine oil (6VE1) - R - R - R - R - R - R - R - R - R - R * P Engine oil (C24SE) Replace every 12,000km * D Engine oil (4JH1-TC) - R - R - R - R - R - R - R - R - R - R * D Engine oil (4JA1-TC) - - R - - R - - R - - R - - R - - R - - * D Engine oil (4JA1-T) RR R R RR RRRRRRRR R R R RRR * P Engine oil filter (6VE1) - R - R - R - R - R - R - R - R - R - R * P Engine oil filter (C24SE) Replace every 12,000km * D Engine oil filter (4JH1-TC, 4JA1-T) - R - R - R - R - R - R - R - R - R - R * D Engine oil filter (4JA1-TC) - - R - - R - - R - - R - - R - - R - - Oil leakage and contamination
(GASOLINE) - I - I - I - I - I - I - I - I - I - I
(DIESEL) I I I I I I I I I I I I I I I I I I I I Fuel leakage I I - I - I - I - I - I - I - I - I - I Fuel tank - - - | - - - | - - - | - - - | - - - | P O2 Sensor Replace every 160,000km P Valve clearances (6VE1) Check and adjust if noisy D Valve clearances A - - A - - - A - - - A - - - A - - - A P Spark plugs (C24SE) (for leaded
fuel use) - R - R - R - R - R - R - R - R - R - R
P Spark plugs (C24SE) (for unleaded
fuel use) - - - - - R - - - - - R - - - - - R - -
P Spark plugs (6VE1) Replace every 160,000km Spark plug wire | | - | - | - | - | - | - | - | - | - | Fuel filter (GASOLINE) - - - R - - - R - - - R - - - R - - - R Fuel filter (DIESEL) - - R - - R - - R - - R - - R - - R - - Engi ne / Accessory dri ve belt
(GASOLINE) - - - - - - - - - R - - - - - - - - - R
Fan belt tension and damage
(DIESEL) I I I I I I I I I I I I I I I I I I I I
* Exhaust system I I - I - I - I - I - I - I - I - I - I Engine coolant concentration (6VE1) - - - - - - - - - R - - - - - - - - - R (C24SE) - | - | - | - | - R - | - | - | - | - R Engine coolant level concentration
(DESEL) I I I I I I I I I R I I I I I I I I I R
Cooli ng sy stem for water l eakage - I - I - I - I - I - I - I - I - I - I All hoses and pipes in engine
compartment for clogs or damage - I - I - I - I - I - I - I - I - I - I
P Timing belt (C24SE) - - - - - - - - - - - - - - - I - - - - (Replace every 120,000km) P Timing belt (6VE1) Replace every 160,000km CLUTCH Cl utch fl ui d I I - I - I - I - I - I - I - I - I - I Clutch pedal travel and free play I I - I - I - I - I - I - I - I - I - I

HEATER AND AIR CONDITIONING 1-1
SECTION 1
HEATER AND AIR CONDITIONING
TABLE OF CONTENTS
PAGE
General Description......................................................................................................... 1- 3
Parts Location ................................................................................................................. 1- 5
Main Data and Specifications ......................................................................................... 1- 15
Special Parts Fixing Nuts and Bolts .............................................................................. 1- 17
ON-Vehicle Service .......................................................................................................... 1- 26
Precautions For Replacement or repair of air conditioning parts .......................... 1- 26
Condenser ........................................................................................................................ 1- 36
Removal and Installation (4JA1-TC, 4JH1-TC).......................................................... 1- 36
Removal and Installation (Except 4JA1-TC, 4JH1-TC) ............................................. 1- 37
Condenser Fan Motor ...................................................................................................... 1- 38
Removal and Installation ............................................................................................ 1- 38
Receiver/drier ................................................................................................................... 1- 39
Removal and Installation ............................................................................................ 1- 39
Compressor...................................................................................................................... 1- 40
Removal and Installation (4J ENGINE) ...................................................................... 1- 40
Removal and Installation (6VE1) ................................................................................ 1- 42
Removal and Installation (C24SE) ............................................................................. 1- 44
Disassembly ................................................................................................................ 1- 50
Reassembly ................................................................................................................. 1- 52
Heater Unit........................................................................................................................ 1- 54
Removal and Installation ............................................................................................ 1- 54
Disassembly and Reassembly ................................................................................... 1- 56
Vent Unit (Without Heater) ............................................................................................. 1- 57
Removal and Installation ............................................................................................ 1- 57
Disassembly and Reassembly ................................................................................... 1- 59
Evaporator (With A/C)...................................................................................................... 1- 60
Removal and Installation ............................................................................................ 1- 60
Disassembly and Reassembly ................................................................................... 1- 61

HEATER AND AIR CONDITIONING 1-3
GENERAL DESCRIPTION
SYSTEM COOLING LINE










1.
Compressor 8.
Evaporator core
2.
Magnetic clutch 9.
Blower motor
3.
Receiver/Drier 10.
Heater unit
4.
Dual pressure switch or Trinary 11.
Mode (DEF/FOOT) control door

pressure switch (4J

-TC, 6VE1, 12.
Mode (VENT) control door
C24SE) 13.
Electronic thermostat
5.
Condenser 14.
Heater core
6.
Evaporator assembly
7.
Expansion valve

RTW310LF001001

1-12 HEATER AND AIR CONDITIONING
(C24SE WITH A/C)


RTW48AXF029401

HEATER AND AIR CONDITIONING 1-13
(C24SE WITH COOLER)


RTW48AXF005701

HEATER AND AIR CONDITIONING 1-19

(6VED1, C24SE RHD MODEL)





RTW410LF000301

HEATER AND AIR CONDITIONING 1-21

(6VE1, C24SE LHD MODEL)




RTW410LF000201