ECU ISUZU TF SERIES 2004 Workshop Manual
Page 4186 of 4264
7A4-12 UNIT REPAIR (JR405E)
06CV19
5. Solenoid
6. Oil pressure switch Remove the 6 solenoids together and the 3 oil pressure
switchs.
07CV17
7. Control valve upper body
8. Control valve lower body
9. Separation plate Remove the 17 bolts securing the control valve uppe
r
body, the control valve lower body, and the separation
plate.
08CV16
Separate the upper body, the lower body, and the
separation plate.
NOTE:
Take care not to drop or lose the parts at the inside of the
control valve.
Inspection
Inspect the separation plate for wear and other damage.
Page 4256 of 4264
7A4-82 UNIT REPAIR (JR405E)
244L300001
21.Oil pan
Install a new gasket and the oil pan.
Tighten the bolts to the specified torque.
Torque: 8 N
m (69 Ib
in)
47INH-SW01
22.Inhibitor switch
Secure the inhibitor switch (1) by hand-tightening the 2
bolts.
Use the inhibitor switch set plate to align the neutral
holes (manual shaft and inhibitor switch).
Turn the inhibitor switch to adjust it.
Inhibitor switch set plate: 5-8840-2763-0
NOTE:
Inhibitor switch adjustment is very important.
If the inhibitor switch is not correctly adjusted, the
automatic transmission will not function normally.
Tighten the 2 inhibitor switch bolts to the specified
torque.