engine ISUZU TFS SERIES 1997 Owner's Guide

CLUTCH 7C-27
CLUTCH CONTROL
REMOVAL AND INSTALLATION
Except 6VD1 Engine
Removal Steps
1. Pin
2. Jaw joint pin
3. Pedal assembly
4. Oil line
5. Master cylinder assembly
6. Oil line
7. Slave cylinder assembly
8. Damper cylinder assembly
Installation Steps
To install, follow the removal steps in the
reverse order.

7C-30 CLUTCH
MASTER CYLINDER (Except 6VD1 Engine)
DISASSEMBLY
Repair Kit
Disassembly Steps
1. Oil tank band
2. Oil tank assembly
3. Joint
4. Lock nut
5. Dust cover6. Stopper ring
7. Stopper
8. Push rod
9. Piston assembly
10. Cylinder body
Important : Take care not to disassemble the push rod stopper for master cylinder which calk to the master cylinder
body due to the component parts do not disassemble.

CLUTCH 7C-35
SLAVE CYLINDER (Except 6VD1 Engine)
DISASSEMBLY
Disassembly Steps
1. Boot
2. Push rod
3. Piston and piston cup4. Spring
5. Cylinder body
6. Solenoid switch
Important Operations
1. Boot
Brake fluid spilled on painted or plastic surfaces will cause
serious damage.
Take care not to spill brake fluid.

7C-38 CLUTCH
SLAVE CYLINDER (6VD1 Engine)
6VD1
Disassembly Steps
1. Boot
2. Push rod
3. Piston and piston cup
4. Spring
5. Cylinder body
Reassembly Steps
To reassemble, follow disassembly steps in
the reverse order.
DISASSEMBLY
1. Boot
2. Push Rod
3. Piston and Piston Cup
4. Spring
5. Cylinder Body
INSPECTION AND REPAIR
Make the necessary adjustments, repairs, and part
replacements if excessive wear or damage is discovered
during inspection.
6VD1Cylinder body
1) Clean the cylinder body.
2) Check the fluid return port for restrictions and clean it if
necessary.

7C-40 CLUTCH
HYDRAULEC DAMPER CYLINDER (Except 6VD1 Engine)
INSPECTION AND REPAIR
Make the necessary adjustments, repairs, and part replacements if excessive wear or damage is discovered during
inspection.
Visually check for oil leakage and other damage.
If oil leakage or other damage is discovered during the
inspection; the damper cylinder assembly must be replaced as
a unit.

7C-50 CLUTCH
SPECIAL SERVICE TOOL
ITEM NO. ILLUSTRATION PART NO. PART NAME
5-8840-2634-0Clutch pilot aligner
(HEC Engine Series)
CLL-3
5-8840-0013-0
(J-22888)Bearing puller
(Except 6VD1 Engine)
CLL-4
5-8840-0124-0
(J-2241-11)Bearing puller adapter
(Except 6VD1 Engine)