reset JAGUAR XF 2012 1.G Quick Start Guide
Page 3 of 9
JAGUAR XF JAGUAR XF JAGUAR XF
JAGUAR XF JAGUAR XF JAGUAR XF
Setting the driving position Setting the driving position See page 3, items See page 3, items 25, 30 25, 30 and 31and 31and Engine start/stop Engine start/stop See page 3, item See page 3, item 22
Transmission See page 3, items See page 3, items 2, 6 2, 6 and 16and 16and
Restraints
Comfort adjustmentsStarting and driving
5
4
Driver’s seat
Set the seat position using the following controls.
Cushion length.1.
Side bolster - inflate.2.
Side bolster - deflate.3.
Lumber support.4.
Seat back angle and head restraint.5.
Seat forwards and back, cushion height and cushion 6. angle.
Note:Seat heater controls are accessed via the touch screen.
Steering column
With the vehicle stationary, adjust the steering column 7. to your ideal driving position.
Door mirrors
1. Press the left or right mirror selector.
2. Use the mirror adjuster to set mirror position.
Storing the driving position to memory
Once you have adjusted the driver’s seat, steering column and door mirrors for your ideal driving position, the settings can be stored.
8. Press the SET button to activate the memory store function. The button will illuminate to indicate the memory store function is active.
9. Within 5 seconds, press button 1 or 2 to store the current driving position.
A stored memory position can now be recalled with a press of the appropriate button; 1 or 2. The seat, steering wheel and mirrors will move to their preset positions.
Operating note
Memory buttons must be pressed within five seconds after pressing the SET button otherwise the memory store function will cancel.
Operating note
The engine will continue to run even if the Smart Key is removed from the vehicle by more than 3ft (1 metre). However, if the engine is stopped, it cannot be restarted until the Smart Key is returned to the vehicle.
Operating note
If the engine is switched off with Neutral selected, automatic selection of P is delayed for 10 minutes. DONOTuse this feature to enable towing of the vehicle. Refer to Vehicle recovery in the Owner’s Handbook.A warning indicator on the instrument panel will illuminate if the seat belt of an occupied front seat is not fastened. This may be accompanied by an audible warning.
Using child seats
Refer to Child Seats in the Owner’s Handbook to determine the correct seat for your child.
If it becomes necessary to fit a child restraint on the front passenger seat, make the following seat adjustments.
Move the seat fully rearward.•
Lumber support to minimum setting.•
Seat cushion to highest position.•
Cushion front tilt to lowest position.•
Seat back to upright position.•
Adjust the upper seat belt anchorage to its lowest • position.
Ignition on:
With the Jaguar Smart Key inside the vehicle, press • the START/STOP button to switch on ignition.
A second press will switch off the ignition.•
Engine start
The selector lever must be in • Park or Neutral position to enable engine starting.
With the foot brake depressed, press and release the • START/STOP button to start the engine.
Press again to stop the engine and switch off the • ignition.
Rolling start
If the engine is switched off while the vehicle is moving, it can be restarted by selecting N position then pressing the START/STOP button.
Gearshift interlock
The brake pedal must be depressed before the selector can be moved from the Park position. Maintain brake pressure until a gear is selected.
Select P before switching off the engine. However, if the engine is switched off with Reverse, Drive or Sport selected, the selector will automatically return to P while retracting.
Automatic gear selection
Select D for fully automatic gear changes.
Sport mode
This is an automatic gear change mode, however, change points are modified to make full use of engine power.
Press the selector down and rotate from D to Sport.
Manual gear changes
Manual gear change mode is effective when rapid acceleration and engine braking are required.
To shift down, briefly pull the left-hand paddle.•
To shift up, briefly pull the right-hand paddle.•
P R N D S
STARTENGINESTOP
DSC
5432
1
6
8
7
9
Supercharged vehicles: When the paddles are used in D, gear selection will revert to automatic if use of the paddles is not maintained. With Sselected, continuous manual operation is initiated if the paddles are used.
Non Supercharged vehicles: Manual gear selection is only available in S.
Note:To return to automatic operation pull and hold the right-hand paddle for two seconds.
JJM189640121.indd 4-5JJM189640121.indd 4-5JJM189640121.indd 4-521/03/2011 13:48:3721/03/2011 13:48:3721/03/2011 13:48:3721/03/2011 13:48:3721/03/2011 13:48:3721/03/2011 13:48:3721/03/2011 13:48:3721/03/2011 13:48:3721/03/2011 13:48:3721/03/2011 13:48:3721/03/2011 13:48:3721/03/2011 13:48:37
Page 5 of 9
JAGUAR XF JAGUAR XF JAGUAR XF
JAGUAR XF JAGUAR XF JAGUAR XF
JaguarDrive control JaguarDrive control See page 3, items See page 3, items 17, 20 17, 20 and 21 and 21 and Parking aids Parking aids
Glovebox valet mode
Door mirrors and blind spot monitoring Door mirrors and blind spot monitoring
Driving aidsDriving aids
Winter mode, Dynamic mode and Dynamic Stability Control (DSC) allow the driver to more finely tune the vehicle driving characteristics to suit prevailing conditions.
Winter mode.1. Use in slippery road conditions. Selects 2nd gear for driving away, moderates engine response and modifies gear change strategy to ensure maximum possible traction is achieved.
Dynamic mode.2. Optimises vehicle systems to deliver a high performance driving experience. If Sport mode is now used with paddle gear selection, there is no automatic gear change, even if the rev limit is reached. Dynamic mode remains selected for six hours after the engine is switched off
DSC.3. The default condition at engine start is DSC on and is designed to control vehicle stability.
2
13
TracDSC is an alternative setting that optimises the DSC settings for maximum traction in difficult conditions. TracDSC enables a more involving and focused driving experience. To select TracDSC, press and release the button. Touch again to return to DSC. To turn DSC off, press for more than 10 seconds.
Message centre
The message centre displays the JaguarDrive Selector position, P, R, N, D or S, the manual mode gear selections 1 to 6 (or 1 to 8) and the JaguarDrive Control mode selection.
When TracDSC is selected, the DSC warning lamp will illuminate and the message centre will briefly display TRAC DSC.
When DSC OFF is selected, the DSC warning lamp will illuminate and the message centre will display DSC OFF until DSC is reinstated.
Driving mode settings
Refer to the Owner’s Handbook section, Stability control, for examples of JaguarDrive settings.
Blind spot monitoring
Each mirror displays amber icons to warn of overtaking vehicles in adjacent lanes. The monitored area extends approximately 20 ft (6 meters) behind your rear wheels and 8.2 ft (2.5 meters) to the sides.
It switches on automatically at speeds above 10mph (16km/h) while in a forward gear. An amber dot illuminates when speed is below the threshold.
Mirror dip when reversing
This feature can be used to improve lower side views while reversing. It can be enabled or disabled via the touch screen. From the Home screen, select Vehicle, then Veh.settings, then Parking.
To set a dip position:
• with the electric parking brake on, select reverse gear
• adjust the mirror position to view the lower rear kerb and vehicle.
Subsequently, each time reverse gear is selected, the set dip position will be automatically selected. The mirrors will return to their normal position when another gear is selected.
8 9
When Reverse is selected, the rear and front parking aids and rear view camera will activate.
The touch screen will display a vehicle graphic and indicate the approximate distance to any object detected. An audible alert will increase in frequency as the object is approached.
When moving forward into a space, activate the front sensors with the parking aid switch in the overhead panel. Alternatively, select R then Drive.
Audible alert volume can be adjusted via the touch screen. From the Home screen, select Set-up, then System, then Volume presets. Use the + or - softkeys alongside Parking aid to adjust volume.
Cancelling the parking aid screen
Touch the screen to return to the previous view.
Rear view camera
Activates when Reverse is selected. Guidance lines to aid reversing appear on the touch screen. The camera display has priority over the parking aid display. To view the parking aid display instead, or cancel the display at any time, touch the display.
The camera is deactivated when Drive is selected and vehicle speed exceeds 10 mph (16 km/h).
Note:Sensors may activate when water, snow or ice are detected on the surface of the sensors. Ensure that the sensors are cleaned regularly.
To open the glovebox, press the facia mounted switch.
Valet mode
The glovebox and luggage compartment can be security locked to deny access to a parking attendant. Before handing over your Jaguar Smart Key, remove the emergency key blade and keep it in a safe place.
To set your Personal Identification Number (PIN) :
• On the touch screen select Home menu.
• Now select Valet.
• Enter a your four digit PIN (personally chosen) and touch OK. Valet on is displayed as a confirmation.
To deselect valet mode
Access the Valet screen and enter your PIN. Now press OK. Valet off is displayed and the glovebox and luggage compartment are now accessible.
Insert the emergency key blade back into the Jaguar Smart Key.
JJM189640121.indd 8-9JJM189640121.indd 8-9JJM189640121.indd 8-921/03/2011 13:48:4121/03/2011 13:48:4121/03/2011 13:48:4121/03/2011 13:48:4121/03/2011 13:48:4121/03/2011 13:48:4121/03/2011 13:48:4121/03/2011 13:48:4121/03/2011 13:48:4121/03/2011 13:48:4121/03/2011 13:48:4121/03/2011 13:48:41
Page 6 of 9
JAGUAR XF JAGUAR XF JAGUAR XF
JAGUAR XF JAGUAR XF JAGUAR XF
Audio controls See page 3, items See page 3, items 9, 10, 14 9, 10, 14 and 23and 23and 23 23
AM/FM and HD radio
Satellite radio
CD player and portable media CD player and portable media
Audio and touch screenAudio and touch screen
10
Satellite Radio subscription service
Use channel 184 to preview satellite radio. When the preview time expires you will need to subscribe to SIRIUS to enable further satellite reception.
Touch to select the satellite bands. Touch the 1. + icon to move through SAT 1, 2 and 3.
Use the seek arrows to move up or down to the next 2. or previous channel.
Channel information. Select if there is more 3. information than can fit in the display area.
Channel presets. Each 4. S AT band has 6 preset softkeys. Touch and hold a softkey to store the current channel. A brief touch will access the stored channel.
Select to make personal settings in 5. Options, Channel skip and Parental lock areas.
View a list of available categories.6.
Select to access the touch pad. Enter any 3 digit 7. channel number then select OK.
Touch to view a list of channel categories. Select one 8. to display full details of that channel and the current track.
Store the currently playing track to the song memory. 9. If the audio system subsequently finds a stored track playing on a subscribed channel, notification will be given.
11
Œ