stop start JAGUAR XK 2011 1.G Quick Start Guide

3
Opening the trunk
Engine start stop
TheSTART STOP button is operational only
when the Jaguar Smart Key is inside the
vehicle.
Ignition only on:
• A single press of the START STOP
button will switch on the ignition.
• A second press will switch off the ignition.
Engine start:
• With the footbrake depressed and the gear selector in Park, press and release the
START STOP button to start the engine.
The JaguarDrive Selector will rise from the
center console in readiness for gear selection.
• With the gear selector in Park, press the
button again to stop the engine and switch off
the ignition.
Cold climate starting
In extreme low temperatures, there may be a
delay of up to \f2 seconds between the START
STOP button being pressed and the engine
cranking. Ensure the footbrake remains
depressed. Do NOT press the START STOP
button again. Cranking time will be increased.
Operating note
The START STOP button must be pressed to stop
the engine. If not, it will continue to run even if the
Jaguar Smart Key is removed from the vehicle.
1. Press the release button indicated.
Front windows
The front windows can be fully opened or closed
with a single operation of the switch.
• To open a window, press the respective
switch briefly. Press the switch again to stop
the window from fully opening.
• To close a window, pull the switch up briefly. Pull the switch again to stop the window from
fully closing.Reminder Global closing
If a front window has been left open when leaving
the vehicle and global closing is enabled, press
and hold the Jaguar Smart Key lock button to close
them. Alternatively, press and hold the button on
the door handle.
2. Alternatively, press the button on the facia.
jjm 18 96 30 101:XK NAS 10MY.qxd 04/09/2008 15:23 Page 31 2

Operating note
To prevent automatic movement of the steering
column, turn the control to theCOLUMNposition.
4
Comfort adjustments
Steering column adjustment
Steering wheel adjustment
• Turn the control to COLUMNthen move the
control to adjust the height and reach.
Exit mode
• With the control set to AUTO, the steering column will move to provide greater clearance
for exiting when the driver's door is opened.
Entry mode
After the driver's door is closed and the START
STOP button is pressed the column will return to
its previous position.
Seat adjustment
Seat adjustment may vary dependent upon
vehicle specification.
The control panel is on the door.
1. Cushion extension. Forward and back.
2. Lumbar support. 4 way switch \b Up inflates upper lumbar, Down inflates lower lumbar,
Forward inflates both lumbars and Back
deflates both lumbars.
\f. Recline adjustment. Forward and back.
4. Side bolster adjustment. Rotate to adjust in or out.
5. Cushion height \b front of switch, cushion front tilt \b rear of switch.
Operating note
The controls for seat heating and cooling are
accessed via the touch\bscreen.
Door mirrors adjustment
Door mirror adjustment
1.Press to select a mirror.
2. Use to adjust the mirror position.
Powerfold mirrors
• Press both buttons 1simultaneously to fold the mirrors
inward. Press again to unfold.
The mirrors can be programmed to unfold/fold automatically
at vehicle unlock/lock. See your Owner’s Handbook.
Mirror dip when reversing
Reverse dip can be enabled or disabled via the touch screen.
From the Homescreen, select Vehicle, thenVeh. settings,
then Parking.
jjm 18 96 30 101:XK NAS 10MY.qxd 04/09/2008 15:23 Page 4 321
54 2
1
1

When you have found your ideal driving
position, the vehicle can memorise the settings
for future use.
1.Press the Mbutton. The red LED will
illuminate for a five second period.
2. Press button 1,2, or \fto store your driving
position.
The LED will extinguish and a chime will sound
to confirm that the settings have been
memorised. If the ignition is on, the message
center will display a confirmation message.
5
Operating note
A seat position will only be memorised during the
five second period that the LED is illuminated.
An existing memory setting can be over\bwritten
with a new memory position.
Driving position memory
Recalling a seat position
To recall a memorised seat position simply
press and hold button 1,2, or \funtil the seat
has finished moving.
Convertible top
The vehicle must be stationary with the engine
running.
Note: The luggage separator MUST be in the
correct position before the top will retract.
• To open, press and hold the REAR of switch 1
in the overhead console.
An audible chime indicates start of opening.
Rear windows will open, the top unlatches and
starts to move. Front windows will fully lower.
When the process is complete another audible
chime will be given.
• Release the switch.
• To close, press and hold the FRONT of switch 1.
Convertible top operation
• DO NOT press the engine START STOP
button while the top is operating. Doing so will
cause the system to lose its position memory.
• DO NOT operate the top while the vehicle is in motion. Doing so may damage the top and/or its
operating mechanism.
• DO NOT open the trunk while the top is operating. This will cause the operation to stop.
Once again an audible chime is given and the
windows will lower before the roof moves back
into position. When the process is complete
another audible chime will be given.
• Release the switch.
jjm 18 96 30 101:XK NAS 10MY.qxd 04/09/2008 15:23 Page 5 1

7
Facia
1.Direction indicators/exterior lighting/
trip computer
2. Instrument pack, warning indicators,
message center and turn by turn navigation
\f. Wiper/washers
4. Audio system
5. Touch\bscreen display
6. Hazard warning switch
7. Home screen button
8. Climate control system
9. Engine start/stop button
10. DSC/Trac switch
11. Automatic speed limiter12.Electric parking brake
1\f. Dynamic mode switch
14. Winter mode switch
15. Jaguar Drive Selector
16. Cruise control
17. Horn
18. Steering column adjuster
19. Audio/telephone controls
20. Rear fog lamps
21. Trunk release
22. Fuel filler flap release
jjm 18 96 30 101:XK NAS 10MY.qxd 04/09/2008 15:23 Page 71234567
8
16171820
21
22
9
10
11
14
13
15
12
19

Manual gear changes
The steering wheel paddles allow manual gear
changing with eitherDrive orSport selected.
• To shift down, briefly pull the paddle.
• To shift up, briefly pull the +paddle.
When the paddles are used in Drive, gear
selection will revert to automatic mode if use of
the paddles is not maintained.
With Sport selected, continuous manual
operation is initiated if the paddles are used.
In both Dand Smode, automatic operation can
be reinstated by pulling the +paddle for two
seconds.
9
Electric parking brake
• Apply manually when stationary in Park,Drive
or Reverse by pulling up the parking brake
switch.
• Can be manually released when the engine is running and the foot brake is applied. Press
the parking brake switch down to release.
• If manually applied whilst in Drive orReverse,
the parking brake will automatically
release when the accelerator is applied.
• Releases automatically when the gear selector is moved from Park.
Transmission
Gearshift interlock
The ignition must be on and the footbrake
depressed before the selector can be rotated
from thePark position. Maintain brake pressure
until a gear is selected.
Instrument pack message center
The current gear selection will be displayed at
the top of the message center.
Sport mode
To move from Drive toSport, press the gear
selector down and rotate. Automatic gear
changing continues but the gearshift points are
modified for full use of the engine's power.
Do NOT use the recess in the electric parking
brake as a storage area.
If the engine is switched off with Neutral selected,
automatic selection of Pis delayed for \f0 minutes.
Do NOT use this feature during vehicle recovery.
jjm 18 96 30 101:XK NAS 10MY.qxd 04/09/2008 15:24 Page 9 PR NDS
START
ENGIN E
STOP