clock JEEP COMMANDER 2010 1.G User Guide

Operating Instructions - uconnect™ studios
(Satellite) Mode
NOTE:The ignition switch must be in the ON or ACC
position to operate the radio.
SEEK Buttons
Press and release the SEEK buttons to search for the next
channel in Satellite mode. Press the right switch to seek
up and the left switch to seek down. The radio will
remain tuned to the new channel until you make another
selection. Holding either button will bypass channels
without stopping until you release it.
SCAN Button
Pressing the SCAN button causes the tuner to search for
the next channel, pausing for eight seconds before con-
tinuing to the next. To stop the search, press the SCAN
button a second time.
INFO Button
Pressing the INFO button will cycle the display informa-
tion between Artist, Song Title, and Composer (if avail-
able). Also, pressing and holding the INFO button for an
additional three seconds will make the radio display the
Song Title all of the time (press and hold again to return
to normal display).
RW/FF
Pressing the RW (Rewind) or FF (Fast Forward) buttons
causes the tuner to search for the next channel in the
direction of the arrows.
TUNE Control (Rotary)
Turn the rotary TUNE/SCROLL control knob clockwise
to increase or counterclockwise to decrease the channel.
MUSIC TYPE Button
Pressing this button once will turn on the Music Type
mode for five seconds. Pressing the MUSIC TYPE button
4
UNDERSTANDING YOUR INSTRUMENT PANEL 217

NOTE:Regardless of the type of operation, when a
temperature knob is set to the full clockwise or full
counterclockwise position, the system will deliver full
hot or full cold air out of the ducts, respectively.
The operator can override the AUTO mode setting and
select the direction of the air by rotating the right mode
knob to one of the following positions. When the Mode is
set to any position other than AUTO, the automatic
control of air temperature is disabled. The user must
adjust the temperature knobs to obtain the desired tem-
perature.
Defrost Air is directed to the windshield through the
outlets at the base of the windshield. Air is also
directed to the front door windows through the side
window demister grilles. Some airflow is delivered to the
floor while in defrost so that comfort can be maintained. NOTE:
The defrost mode is not automatically selected.
It must be manually selected, when desired.
Defrost/Floor Air flows through the front and rear floor outlets
and the outlets at the base of the windshield. Air is
also directed to the front door windows through the
side window demister grilles. Some airflow is delivered
to the floor while in defrost so that comfort can be
maintained.
Floor Air flows through the floor outlets located under
the instrument panel and into the rear seating area
through vents under the front seats. Some airflow is
delivered to defrost while in floor mode, so that comfort
can be maintained.
4
UNDERSTANDING YOUR INSTRUMENT PANEL 231

Spare Tire Removal
Fit the jack handle extension over the drive nut. Use the
lug wrench to rotate the nut counterclockwise until the
spare is on the ground with enough slack in the cable to
allow pulling the tire out from under the vehicle.
CAUTION!
The winch mechanism is designed for use with the
jack extension tube only. Use of an air wrench or
other power tools is not recommended and can dam-
age the winch.
When the spare is clear, tilt the retainer at the end of the
cable and pull it through the center of the wheel.
Preparations For Jacking
1. Park the vehicle on a firm, level surface. Avoid ice and
slippery areas.
Lowering/Raising Spare Tire6
WHAT TO DO IN EMERGENCIES 345

5. Raise the vehicle by turning the jack screw clockwise.
Raise the vehicle only until the tire just clears the surface
and enough clearance is obtained to install the spare tire.
Minimum tire lift provides maximum stability.
WARNING!
Raising the vehicle higher than necessary can make
the vehicle less stable. It could slip off the jack and
hurt someone near it. Raise the vehicle only enough
to remove the tire.
6. Remove the lug nuts and wheel.
7. Position the spare wheel/tire on the vehicle and install
the lug nuts with the cone-shaped end toward the wheel.
Lightly tighten the nuts. To avoid the risk of forcing the
vehicle off the jack, do not tighten the nuts fully until the
vehicle has been lowered.
8. Lower the vehicle by turning the jack screw counter-
clockwise, and remove the jack and wheel blocks.
Rear Jacking Location6
WHAT TO DO IN EMERGENCIES 349

NOTE:Numbers refer to commercial bulb types that
can be purchased from your authorized dealer.
If a bulb needs to be replaced, visit your authorized
dealer or refer to the applicable Service Manual.
BULB REPLACEMENT
Head Lamp
1. Open the hood.
2. Disconnect the electrical connector.
3. Turn the low or high beam bulb 1/4 turn counterclock-
wise to unlock it from the housing.
4. Pull the bulb and base straight out from the opening in
the reflector.
1 — Low Beam Bulb
2 — High Beam Bulb
3 — Front Park/Turn Signal Bulb
7
MAINTAINING YOUR VEHICLE 401

4. Turn the socket on the bottom of the front lamp unit
housing 1/4 turn counterclockwise to unlock it.5. Pull the socket and bulb straight out from the opening
in the housing.
6. Disconnect the electrical connector.
7. Pull the base of the bulb straight out of the socket.
CAUTION!
Do not touch the new bulb with your fingers. Oil
contamination will severely shorten bulb life. If the
bulb comes in contact with any oily surface, clean the
bulb with rubbing alcohol.
Front Fog Lamp
1. Turn the steering wheel all the way to the left or right.
1 — Low Beam Bulb
2 — High Beam Bulb
3 — Front Park/Turn Signal Bulb
7
MAINTAINING YOUR VEHICLE 403

2. Reach into the front wheel house ahead of the front
wheel to unsnap and lift the cover over the access hole in
the front of the wheel house splash shield. Access to the
bulb can be gained through the wheel liner hole.
3. Reach through the access hole to access the back of the
front fog lamp housing on the back of the front fascia.
4. Disconnect the electrical connector.5. Turn the socket on the back of the housing 1/4 turn
counterclockwise to unlock it.
6. Pull the socket and bulb straight out from the opening
in the housing.
7. Pull the base of the bulb straight out of the socket.
CAUTION!
Do not touch the new bulb with your fingers. Oil
contamination will severely shorten bulb life. If the
bulb comes in contact with any oily surface, clean the
bulb with rubbing alcohol.
Rear Tail, Stop, Turn Signal, and Backup Lamps
1. Raise the liftgate.
2. Remove the two push-pins that secure the rear lamp
unit to the side of the liftgate opening.
404 MAINTAINING YOUR VEHICLE

3. Pull the outboard side of the rear lamp unit rearward
far enough to unsnap the two ball studs on the outboard
side of the lamp housing from the two plastic grommets
in the quarter outer panel. Pull the lamp unit rearward
far enough away to access the bulbs.4. Firmly grasp the appropriate bulb socket on the back
of the rear lamp unit housing, and turn 1/4 turn coun-
terclockwise to unlock it.
1 — Rear Backup Lamp Bulb
2 — Rear Park/Stop Lamp Bulb
3 — Rear Park/Turn Signal Bulb
4 — Rear Side Marker Lamp Bulb
7
MAINTAINING YOUR VEHICLE 405

Cargo Load Floor........................ 147
Cargo (Vehicle Loading) ................... 320
Cellular Phone ........................ 85,223
Center High Mounted Stop Light ............ 406
Certification Label ....................... 320
Chains, Tire ............................ 301
Changing A Flat Tire ..................... 343
Chart, Tire Sizing ........................ 287
Check Engine Light (Malfunction Indicator Light) . 360
Checking Your Vehicle For Safety ............. 73
Checks, Safety ........................... 73
Child Restraint .................... 63,64,69,71
Child Restraint Tether Anchors .............68,69
Child Safety Locks ........................ 30
Climate Control ......................... 223
Clock ........................... 186,190,199
Cold Weather Operation ................... 244
Command View Skylights .................. 139
Compact Disc (CD) Maintenance ............. 222Compact Spare Tire
...................... 297
Compass .............................. 179
Compass Calibration ..................... 179
Compass Variance ....................... 180
Computer, Trip/Travel .................... 176
Connector UCI ................................ 209
Universal Consumer Interface (UCI) ......... 209
Conserving Fuel ........................ 176
Console, Overhead ....................... 130
Contract, Service ........................ 435
Cooling System ......................... 374
Adding Coolant (Antifreeze) .............. 376
Coolant Capacity ...................... 407
Coolant Level ......................... 378
Disposal of Used Coolant ................ 377
Drain, Flush, and Refill .................. 375
Inspection ........................... 374
Points to Remember .................... 378
444 INDEX

Pretensioners.......................... 46
Reminder ............................ 168
Shoulder Belt Anchorage ................. 44
Seats ................................. 85
Adjustment ........................... 86
Cleaning ............................ 390
Easy Entry ........................... 102
Fold and Tumble Rear ................... 93
Head Restraints ........................ 89
Heated ............................ 90,91
Lumbar Support ....................... 87
Memory ............................. 98
Power ............................... 88
Rear Folding ........................ 93,97
Reclining ............................. 86
Seatback Release ....................... 97
Security Against Theft ..................... 19
Security Alarm (Theft Alarm) .............19,163
Selection of Oil ......................... 364 Sentry Key (Immobilizer)
................... 17
Sentry Key Programming ................... 18
Sentry Key Replacement ................... 18
Service Assistance ....................... 433
Service Contract ......................... 435
Service Engine Soon Light (Malfunction
Indicator) ............................. 162
Service Manuals ........................ 437
Setting the Clock .................. 186,190,199
Settings, Personal ........................ 181
Shift Lock Manual Override ................ 247
Shifting ............................... 246
Automatic Transmission ................. 246
Shoulder Belts ........................... 40
Signals, Turn ................. 76,110,161,402,404
Sirius Backseat TV™ (uconnect studios)....... 219
Skylights, Command View ................. 139
SmartBeams ........................... 106
Snow Chains (Tire Chains) ................. 301
456 INDEX