JEEP WRANGLER 2006 TJ / 2.G Owners Manual

Tuck the top material between the 2 bow and the 3 bow
as it folds. 13. Tuck the top material between the 2 bow and the
header.
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 101
3

14. After the top is folded down, ensure that the drip rail
retainers are tucked in inward as shown. This is to avoid
unnecessary wear to the fabric. 15. After the top is folded down, tuck the check straps so
that they are not hanging and flapping outside the
vehicle.
102 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

Putting Up The Soft Top
NOTE:Be sure the wire harness is not attached to the
soft top bows before you lift the top.
1. Begin working from the rear of the vehicle, with the
tailgate open. Lift the plastic header (with latches) up and
over the sport bar. As the header reaches the top, locate
the 2 bow and push it up and over the sport bar. 2. Move to the side of the vehicle and pull the side bow
forward and down. Be sure the check straps are not
tangled around the 2 bow. You will see the 3 bow rise
from the rear of the vehicle.
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 103
3

3. Unclip and move the sun visor to the side. 4. Open the header latches and engage the hook on each side into the windshield slot.
104 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

5. Grasp the drip rail retainer and untuck them from the
door frame.
NOTE: Do not tuck the drip rails into the door frame at
this time. 6. Move to the rear of the vehicle and gently pull the sail
panels over the 3 bow letting them hang down.
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 105
3

7. Align the sail panel retainer to the edge of the bodys-
ide retainer at the rear. Tuck the sail panel into the
bodyside retainer beginning from the rear and working
to the corner. Tuck the retainer around the corner and
continue forward. NOTE:
This may be difficult due to fabric tension. If
difficulty is experienced with fabric tension, place your
hand on top of the 3 bow and gently pull down to help
tuck in the sail panel retainers.
106 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

8. To install the quarter window, affix the rear corner of
the window temporarily to the Velcro . Start and zip the
zipper only about 1 inch (2.5 cm). At this time it is
necessary to tuck in the door frame retainer. 9. After the door frame retainer has been completely
tucked in, finish zipping in the window. Then affix the
Velcro 
flaps around the window.
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 107
3

10. Tuck the bottom retainer of the quarter window into
the bottom retainer, beginning from the rear and working
to the front of the vehicle. Repeat this step for the other
side. 11. To assist in getting the zipper started, lay the retainer
bar inside the vehicle on the wheel wells and uninstall
half of the left sail panel from the bodyside retainer
beginning at the tailgate to expose zipper ends.
108 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

12. Zip in the rear window beginning from the left using
both zipper ends. Run the upper zipper around the
window leaving the lower zipper at the start. 13. Tuck the retainer bar into the tailgate clips.
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 109
3

14. Tuck the lower retainers of the rear window under
the tailgate clips. Reinstall the left corner if it was
untucked to get the rear window zipper started. 15. Tuck the drip rail retainers into the door frame slot
above the door on both sides.
110 UNDERSTANDING THE FEATURES OF YOUR VEHICLE