JEEP WRANGLER 2009 Owners Manual
Page 141 of 502
3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 139
Page 142 of 502
12. The swing gate brackets do not need to be removed
unless the hard top is being installed. To remove the
swing gate brackets, pull the front of the bracket forward
while rolling the entire bracket back in toward the vehicle
to disengage.13. Completely release the latches from the loops on the
windshield frame.
If your vehicle is not equipped with
the Sunrider package, proceed to Step 16.
Page 143 of 502
3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 141
Page 144 of 502
NOTE:Help from another person will ease this opera-
tion.
17. Tuck the fabric and the check straps between the
bows and as far inward as possible. This will keep any
portion of the top from flapping outside of the vehicle. When the top is completely down, position the drip rails
so they make a “v-shape”; this prevents damage to the
soft top material.
18. Close the front header latches.
19. Remove the door frames, if desired. Refer to “Door
Frame” in this section.
Page 145 of 502
Page 146 of 502
1 — Zipper Start
2 — Zipper Finish
3 — Swing Gate Bar
4 — Swing Gate Brackets
5 — Sail Panels
144 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
Page 147 of 502
3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 145
Page 148 of 502
6. Make sure the Sunriderbracket on the side bows
latches to the door rails (Sunrider Models only).
7. Open the header latches and engage the hook on each
side onto the windshield loops (do not close the latches). 8. If the swing gate brackets were removed, install them
by hooking the rear edge of the bracket on the interior
side of the body channel. Then, rotate it rearward and
over the channel until it snaps onto the exterior part of
the rail. To be properly located, the bracket must only be
clipped to the shortened rail edge.
Page 149 of 502
3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 147
Page 150 of 502
11. To install the side windows, affix the window tem-
porarily by attaching to the Velcroin the rear corner.
Start the zipper but close only about 1 in (2.5 cm). 12. Insert the front retainer of the window into the door
channel, making sure the retainer is fully seated and
properly positioned on the door frame. Failure to do so
can result in wind and water leaks or damage to the
window.