engine oil JEEP WRANGLER 2022 Owners Manual
Page 13 of 464
: $ 5 1 , 1 *
$ Q \ P R G L I L F D W L R Q V R U D O W H U D W L R Q V W R W K L V Y H K L F O H F R X O G V H U L R X V O \ D I I H F W L W V
U R D G Z R U W K L Q H V V D Q G V D I H W \ D Q G P D \ O H D G W R D F R O O L V L R Q U H V X O W L Q J L Q V H U L-
ous injury or death.
Red Warning Lights
Air Bag Warning Light
Úpage 122
Brake Warning Light Úpage 122
Battery Charge Warning Light Úpage 123
Door Open Warning Light
Úpage 123
Electric Power Steering (EPSyf ) D X O W : D U Q L Q J Light
Ú page 123
Electronic Throttle Control (ETCyf : D U Q L Q J / L J K t Úpage 123
Engine Coolant Temperature Warning Light Úpage 124
Hood Open Warning Light Úpage 124
Oil Pressure Warning Light Úpage 124
Oil Temperature Warning Light Úpage 124
Seat Belt Reminder Warning Light Úpage 123
Red Warning Lights
1
21_JL_OM_EN_USC_t.book Page 11
Page 120 of 464
: $ 5 1 , 1 *
$ K R W H [ K D X V W V \ V W H P F D Q V W D U W D I L U H L I \ R X
S D U N R Y H U P D W H U L D O V W K D W F D Q E X U Q 6 X F K P D W H-
rials might be grass or leaves coming into
contact with your exhaust system. Do not
park or operate your vehicle in areas where
your exhaust system can contact anything
that can burn.
CAUTION!
The engine may be switched off even if the
warning light is on: repeated interruptions of
the regeneration process could cause an
early deterioration of engine oil. For this rea -
son it is always advisable to wait for the sym -
bol to go off before turning off the engine,
following the instructions above. Do not com -
plete the DPF regeneration process when the
vehicle is stopped.
Page 433 of 464
TEC \b \f SPECIFICATIONS
VE \b \fE IDENTIFICATION NUMBER
The Vehicle Identification Number (VINyf L V I R X Q G
on the left front corner of the A-pillar, visible
from outside of the vehicle through the
windshield.
Vehicle Identification Number
NOTE:
It is illegal to remove or alter the VIN plate.
BRAKE SYSTEM
Your vehicle is equipped with dual hydraulic
brake systems. If either of the two hydraulic
systems loses normal capability, the remaining
system will still function. However, there will be some loss of overall braking effectiveness. You
may notice increased pedal travel during
application, greater pedal force required to slow
or stop, and potential activation of the Brake
Warning Light.
In the event power assist is lost for any reason
(i.e., repeated brake applications with the
engine offyf W K H E U D N H V Z L O O V W L O O I X Q F W L R Q
However, the effort required to brake the
vehicle will be much greater than that required
with the power system operating.
W \b \f AND TIRE TORQUE SPECIFICATIONS
Proper lug nut/bolt torque is very important to
ensure that the wheel is properly mounted to
the vehicle. Any time a wheel has been removed
and reinstalled on the vehicle, the lug nuts/
bolts should be torqued using a properly
calibrated torque wrench using a six sided (hexyf
deep wall socket.
TORQUE SPECIFICATIONS
**Use only authorized dealer recommended lug nuts/
bolts and clean or remove any dirt or oil before tightening.
Inspect the wheel mounting surface prior to
mounting the tire and remove any corrosion or
loose particles.
Spare Tire Torque Specifications
**Use only authorized dealer recommended lug nuts/
bolts and clean or remove any dirt or oil before tightening.
Lug Nut/Bolt
Torque **Lug Nut/
Bolt Size Lug Nut/Bolt
Socket Size
130 Ft-Lbs (176 N·myf M14 x 1.50 22 mm
Lug Nut/Bolt Torque **Lug Nut/
Bolt Size Lug Nut/Bolt
Socket Size
59 Ft-Lbs (80 N·myf M14 x 1.50 22 mm
9
21_JL_OM_EN_USC_t.book Page 431