garage door opener KIA CADENZA 2016 Features and Functions Guide
Page 35 of 46
33
How to Sync Transmitter with HomeLink®
If programming for the first time, begin with Step 1 (repeating this step will 
delete all information) .
To program non-rolling and rolling code garage door openers and other devices:
1 . Press and hold the left A and center D buttons simultaneously until the 
indicator light C begins to flash (to reprogram buttons, skip this step)
2  . Press and hold the desired button A, B or D and hold the button on the 
transmitter while it is approximately 1 to 3 inches away from the mirror  . 
The HomeLink® Indicator light C will flash rapidly once the frequency 
signal has been successfully programmed
To finish programming rolling code garage door openers, complete these steps:
3 . Locate the “learn” or “smart” button on the garage door’s motor head 
unit  . Press and release the button and complete Step 4 within 30 seconds
4 . Firmly press and release the programmed HomeLink® button up to three times
Operating HomeLink®: 
Press one of the programmed HomeLink® buttons  .
Erasing programmed buttons:
Press and hold the left A and center D buttons simultaneously for 
approximately 20 seconds, and then release both buttons within 30 seconds  .
REMINDER: Mirror indicator light C will illuminate when automatic dimming is ON .
If your garage door opener was manufactured in 2011 or later, and you’re unable to program your vehicle’s HomeLink® system, you may need to purchase a HomeLink Repeater Kit. For more information, go to www.HomeLink.com or call (800) 355-3515.
The HomeLink® / Auto-Dimming Rearview Mirror is designed to reduce 
glare from a vehicle’s headlights located in the rear and also connect up 
to three electronic transmitters into one location  .
HomeLink® with Auto-Dimming Rearview Mirror 
A HomeLink® button 
B HomeLink® button 
C Indicator light 
D HomeLink® button 
E Glare detection sensor 
F Automatic dimming ON/OFF 
G Compass control button 
 
	•You can reprogram a single HomeLink® button by repeating Step 2 	•Erasing programmed buttons will delete all trained transmitters
   QUICK TIPS
ABCDEFG
ALWAYS CHECK THE OWNER’S MANUAL FOR COMPLETE OPER ATING INFORMATION AND SAFET Y WARNINGS. *IF EQUIPPED  
OTHER KEY FEATURES