wheel KIA CARNIVAL 2007 Workshop Manual

2007 > 2.7L V6 GASOLINE >
REPLACEMENT
1.Remove a transaxle assembly (refer to 'MT'- group).
2. Remove the clutch cover bolts. Not to be bent or twisted, loosen them in diagonal directions.
3.Remove the clutch cover and disc.
4. Using the SST(09411- 43000), install a clutch disc and cover.
a. Replace a clutch cover and disc as a set.
* Possible problems when not following the caution
a. When replacing only a disc, slip problem can occur because of the initial clamp load loss by the adjusting
ring's unusual work.
b. When replacing only a disc, it can be difficult to cut power because the thickness of the disc cannot be
permitted.
b. Apply grease on a disc spline part and transmission input shaft spline part as required.
* Possible problems when not following
a. When not applying: Excessively wear of splines and bad clutch operation
b. When excessively applying: Scattered grease by centrifugal force conteminates the clutch disc. Loss of friction
force can cause a slip
c. The 'T/M SIDE' marked surface should face the transaxle.
→ If the surface face the opposite side, there can be an interference between a disc and a flywheel surface.