run flat KIA RIO 2020 Features and Functions Guide

RIO FEATURES & FUNCTIONS GUIDE26
OTHER KEY FEATURES
*IF EQUIPPED †LEGAL DISCL AIMERS ON BACK INSIDE COVER
(Lever located on the driver’s floor near door sill; Image shown is 4-door model)
B
A
D
C
(Lever located under Driver’s Panel buttons)
(Latch located inside hood)
REMINDERS:
•Sunvisor may not shield all direct light
•
The Sunvisor may impair visibility if not adjusted properly . Do not operate the vehicle if Sunvisor is impairing your visibility
•
Be aware of seating position when adjusting or swinging Sunvisor around to or from the front or side windows
Hood Release Lever and Latch
Opening the Hood:
1 . Pull the Hood Release Lever A
to unlatch the Hood
2 . In the front of the vehicle, lift the
Hood slightly, push the secondary
Latch B to the left inside of the
hood’s center and lift the Hood
3 . Pull out the support rod from the
Hood and set into place to hold
the Hood open
Fuel Door Release Lever
Pull the lever C upwards to release the
fuel door .
REMINDER: Open the Hood only after turning the engine off, on a flat surface, with the gear shift in P (Park) position and setting the parking brake .
Closing the Hood:
Lower the Hood by pressing the front center of the Hood . Then, press
down to securely lock in place .
REMINDER: While lowering and closing, keep hands away from under the Hood .
Tr u n k* Release Lever
(4-door model)
Pull the lever D upwards to open the
trunk lid .
Sunvisor†19
Use the Sunvisor to shield direct light through the front or side
windows . Slide the Sunvisor out and adjust as needed .
For illustrative purposes only. Your actual display, buttons and/or features may vary.