battery KIA SELTOS 2021 Navigation System Quick Reference Guide

3
ÜSystem handling
Do NOT apply excessive force to the system.
•When you apply excessive pressure to the screen, the LCD panel or touch
panel may get damaged.
To clean the screen or button panel, first turn off the vehicle
and then use a dry, soft cloth to wipe it.
•Do not wipe using a rough or hard cloth, chemical fiber, organic solvent (e.g.
alcohol, benzene, thinner), or air freshener. The panel surface may become
scratched or damaged due to a chemical reaction.
When you install an air freshener on the air conditioner vent,
the surface may be deformed due to leakage.
A
A
If you experience any problems with the system, contact your
place of purchase or dealer.
Safety Precautions
Be sure to keep the following instructions. Otherwise, it may
cause minor injury or system damage.
ÜOperation
Use the system with the vehicle started.
•When you use the system for a long time with the vehicle stopped, it may\

cause battery discharge.
Do NOT arbitrarily install an unauthorized aftermarket
product in your vehicle.
•Using unapproved products may cause an error while using the system.
•System errors caused by installing unapproved products are not covered
under the warranty.

7
ÝWarning
•Driving while distracted can result in a loss of vehicle control
that may lead to an accident, severe bodily injury, or death.
The driver's primary responsibility is the safe and legal
operation of the vehicle, and the use of any vehicle systems,
including the touch screen and steering wheel controls, which
take the driver's eyes, attention, and focus away from the safe
operation of the vehicle, or which are not permissible by law,
should never be used during the operation of the vehicle.
•Some functions may not be active while driving to ensure
safety. Those functions run only when the vehicle is stationary.
In order to use them, first stop the vehicle.
•When the screen is not displayed, the volume is muted, or
other system failures occur, immediately stop using the
system. When you use the faulty system continuously, it may
cause fire, electric shock, or fatal system failure.
ÜCaution
•The system can be turned on even when the ignition switch is
in “ACC” or “ON.” However, when you use the system without
turning on the vehicle for a long time, it may cause battery
discharge. To use the system for a long time, be sure to turn
on the vehicle.
•When you use the system with the vehicle turned off, the
battery warning message appears. The warning message
disappears as soon as you turn on the vehicle.
Turning the system on or off
Turning on the system
1 Turn on the vehicle.
2 When a safety warning message appears, read it
and press Confirm.
A
A
To change the display language, press Language.
Turning off the system
To turn off the system while driving, press and hold
the Power button on the panel.
The screen and sound will be turned off.
A
A
To use the system again, press the Power button.
A
A
When a specified period of time elapses after turning off the
vehicle, the system automatically shuts down. When you open
the driver's door, the system immediately shuts down.

5
ÜSystem handling
Do NOT apply excessive force to the system.
 When you apply excessive pressure to the screen, the LCD panel or touch
panel may get damaged.
To clean the screen or button panel, first turn off the vehicle
and then use a dry, soft cloth to wipe it.
Do not wipe using a rough or hard cloth, chemical fiber, organic solvent (e.g.
alcohol, benzene, thinner), or air freshener. The panel surface may become
scratched or damaged due to a chemical reaction.
When you install an air freshener on the air conditioner vent,
the surface may be deformed due to leakage.
A
A
If you experience any problems with the system, contact your
place of purchase or dealer.
Be sure to keep the following instructions. Otherwise, it may
cause minor injury or system damage.
ÜOperation
Use the system with the vehicle started.
 When you use the system for a long time with the vehicle stopped, it may
cause battery discharge.
Do NOT arbitrarily install an unauthorized aftermarket
product in your vehicle.
Using unapproved products may cause an error while using the system.
System errors caused by installing unapproved products are not covered
under the warranty.
Safety Precautions

1-6
Using the touch screen
This system is equipped with a touch-enabled screen. You can use
various practices by using this feature.
ÝWarning
Do not use the touch screen while driving as this will divert your
attention away from the safe operation of the vehicle. You may
lose your steering control which could cause an accident and
severe bodily injuries.
ÜCaution
Do not press the touch screen with excessive force or a sharp
object. The touch screen may become damaged.
Be careful for the touch screen not to contact any electrically
charged object. Static or other electric shock may cause the
system to malfunction or damage the touch screen.
A
A
The touch screen does not respond when you are wearing
gloves. Take off the gloves or wear electrostatic touch gloves.
ÜCaution
The system can be turned on even when the ignition switch is
in “ACC” or “ON.” However, when you use the system without
turning on the vehicle for a long time, it may cause battery
discharge. To use the system for a long time, be sure to turn
on the vehicle.
When you use the system with the vehicle turned off, the
battery warning message appears. The warning message
disappears as soon as you turn on the vehicle.
AA
The screen may differ depending on the vehicle model and
specifications.
A
A
When you turn off and on the vehicle, the system is turned on
with the mode and settings used when the vehicle was turned
off.
A
A
To prevent audio from playing loud when you turn on the
vehicle, adjust the system volume to an adequate level.
A
A
To automatically decrease the system volume, move to the All
Menus screen and press Setup >
Sound >
System Volumes
> Start-up Volume Limit to set the function.
> See “ Start-up
Volume Limit.”

5-5
A
A
Navigation service may not be provided correctly under the
following conditions:

When the vehicle drives on a straight road continuously,
the system may guide you to drive straight. It is not a
malfunction.

Guidance may not be followed immediately after the
vehicle makes a turn at an intersection or drives through an
intersection.

The system may guide you to make a U-turn in a prohibited
area.

The system may guide you to a traffic-blocked road (e.g. no-
entry road or road under construction).

The system may guide you to a road away from the
destination when there is no road to the destination or
there are only narrow roads on the way.

Guidance may not be proper when the vehicle is off the
route.

Guidance may not match the actual distance on an
overpass or underpass due to the difference of the start
point.

When you are driving at high speeds, route recalculations
may take longer.
A
A
Because the navigation system is used for information
purposes only, Kia does not assume responsibility of the
accuracy of the information.
A
A
When the traffic information is not received, the status icon
appears at the top of the map screen.

HD Radio: The system is using the HD radio data. If no
traffic information is available, the status icon (
)
will be
displayed instead.

The vehicle is driving in a rugged mountain area or on a
steep curve road.

The vehicle is entering a public road after making a turn
through the turntable in an underground parking lot or
multi-story parking lot.

The vehicle stops and starts repeatedly or moves slowly in
front of an intersection.

The system reboots after the vehicle battery has been
recharged or replaced.

The vehicle is driving on a slippery road due to heavy snow,
etc.

The tires have been replaced recently or spare tires (or
studless tires) are used.

Improper-sized tires are used or the pressure of each tire is
different.

The replaced tire is worn out or the studless tires have been
used for over two seasons.

A roof carrier is installed on the vehicle.

On a highway. continued driving causes the system to
perform map matching or apply the updated GPS data.

5-7
Using the detailed guidance
When the vehicle needs to change the driving direction or lanes,
a zoomed-in map automatically appears.A
A
To display or hide the detailed guidance, press
or .
When the detailed guidance appears while driving,
select and perform the desired function.
To check information on the zone for a turn, press Simple.
To check the types and locations of convenience facilities in a
rest area, press Rest Area.
For information details about each zone such as intersections,
interchanges, and rest areas, press Details.
j Displays quick menu items that can be used during guidance.
k Can cancel the route guidance. > See “
Stopping the route
guidance.”
l Displays the remaining distance to the destination and
the estimated time of arrival. For more details, press the
information item.
m Displays or hides the detailed guidance.
n You can see the system information on the map. (It can
display up to two items.)
 Traffic information (with an icon if there is no HD data
reception)
Bluetooth connection status
o Check the range you can drive with the current amount of
battery (EV only).
A
A
To see only the map with no destination, press the map area
on the Home screen or on the All menu screen, press Map. Or
press the [ MAP] button on the control panel.
A
A
The screen may differ depending on the vehicle model and
specifications.
ÝWarning
Be sure to check the road conditions while driving, because the
camera information may get changed occasionally after a map
update to the latest version. Relying solely on the driving assist
system may cause violation of traffic rules and regulations,
resulting in an accident.

10-5
Bluetooth connection
SymptomPossible cause Solution
The system is not detected by a
Bluetooth device. Registration mode needs to be
run. On the All Menus screen, press Setup
>
Device Connections
> Bluetooth >
Bluetooth Connections >
Add New to run the
registration mode and perform search again from the Bluetooth
device.
> See “ Connecting a Bluetooth device.”
The Bluetooth device is not
connected. The Bluetooth function should
be activated. Activate the Bluetooth function on the Bluetooth device to connect.
Any error occurs while using the
Bluetooth function.
 Turn the Bluetooth function OFF / ON on the Bluetooth device
and then connect the device again.
Turn the Bluetooth device off and on and then connect the device
again.
Remove the battery from the Bluetooth device and attach it back,
turn on the device, and then connect the device again.
Delete the system and Bluetooth device from the registration lists
respectively, and then connect the device again.

10-6
Phone projection
SymptomPossible cause Solution
The phone projection function
is not performed when a
smartphone is connected using
a USB cable. Phone projection is not
supported.
Visit the website to check whether your smartphone supports the
phone projection.

Android Auto: https://support.google.com/androidauto
Apple CarPlay: http://www.apple.com/ios/carplay
The function is inactive.
 On the All Menus screen, press Setup
>
Device Connections,
select the function to use, and then turn on the phone projection
option.
 Make sure that the phone projection is not disabled in the
application settings or block-out settings on your smartphone.
Smartphone is encountered with
poor operation or malfunction.
 Check that the smartphone battery level is not too low.
Recognition may not work properly when the battery level is too
low.
The phone projection may not work properly when the signal
strength is weak.
When the smartphone is locked, first unlock it.
Initialize the smartphone and connect the device again.
A black screen appears when
the phone projection is
activated or in use. The smartphone malfunctions.

Remove the USB cable from the smartphone and connect the
device again.
Initialize the smartphone and connect the device again.

10-20
Index
A
Advanced system settings 9-17
Android devicesAndroid Auto 2-4
Apple devices Apple CarPlay 2-6
B
Battery warning 1-6
BluetoothBluetooth phone
Answering a call 6-15
Call 6-7
Contacts list 6-11
Dial pad 6-13
Favorites settings 6-9
Options during a call 6-16
Recent calls list 6-7
Switching to another call 6-17
Text message 6-18
Specifications 10-16 Bluetooth connection
Adding a device 6-3
Deleting a device 6-6
Device connection 6-4
Disconnecting a device 6-6
C
ClimateClimate control system 2-13
Component Names and Functions Control panel
Custom button 1-2
MAP button 1-2
MEDIA button 1-2
NAV button 1-2
POWER button/VOLUME knob 1-2
RADIO button 1-2
SEEK/TRACK button 1-2
SETUP button 1-2
System Reset button 1-3
TUNE knob/FILE knob/
ENTER button 1-3
Steering wheel remote control
Call button 1-4
End Call button 1-4
MODE button 1-3
Move button 1-4
Voice Recognition button 1-3
Volume lever/Mute button 1-3
Contacts list 6-11
Control panel 1-2
D
Date and time settings 9-39
Deleting a location 5-26
Destination search 5-3
Driving assist display 2-8