key KIA SPORTAGE 2014 Navigation System Quick Reference Guide
Page 54 of 76
51
B l u e t o o t h ® W i r e l e s s T e c h n o l o g y
C o n t a c t s
Downloading Mobile Phone
Contacts
Press the C o n t a c t s button Ü
Press the
D o w n l o a d button Ü
Press
Y e s .
Contacts Sync (Phonebook Download)
The Contacts Sync feature allows you to
choose whether your phone contact list
will transfer to your vehicle contacts each
time your phone is connected or only at
the initial phone pairing. To enable or dis-
able Contacts Syncing:
1. Depending on the equipped
options of your
multimedia sys-
tem,
press the S E T U P key, then
S e t u p
Ü P h o n e
Ü
C o n t a c t S y n c S e t t i n g s .
2. On the display screen, press Phone,
Settings, Advanced Setup and
Contacts Sync, then press On or
Off to change the setting.
!Ÿ If Contact Sync is set to ON, con-
tacts stored y
our phone will down-
load each time your phone is
connected. There may be a delay before
the system is available to place a call.
!Ÿ If Contact Sync is set to OFF,
y
our phone contacts will down-
load only at the initial pairing. This
allows you to make calls without waiting
for your phone contact list to download. , @ 4 - @ ( < & / > " 7 / 2 3 ( @ * 2 4 J O E E
Page 60 of 76
57
B l u e t o o t h ® W i r e l e s s T e c h n o l o g y
Device Information
Press the S E T U P
key Ü Press
S e t u p Ü Press P h o n e Ü
D e v i c e I n f o r m a t i o n
!Ÿ
This feature allows you to check
device information.
Adjusting the Ring/Call Volume
While on a call Ü Use the VOL
knob on the head unit or the
V O L + , V O L - keys on the
steering wheel to adjust the ring/
call volume. , @ 4 - @ ( < & / > " 7 / 2 3 ( @ * 2 4 J O E E
Page 61 of 76
58
B l u e t o o t h ® W i r e l e s s T e c h n o l o g y
Setting Mic Volume
While on a call Ü Press the
O u t g o i n g V o l . Ü Set Outgoing
Volume Ü Press
O K.
If you press the
M u t e button, the
outgoing volume is muted and blocked
to the other party.
Restore Factory Settings
Press the S E T U P
key Ü Press
S e t u p Ü Press P h o n e Ü
Press
R e s t o r e F a c t o r y S e t t i n g s . , @ 4 - @ ( < & / > " 7 / 2 3 ( @ * 2 4 J O E E
Page 62 of 76
59
V o i c e R e c o g n i t i o n
Starting Voice Recognition
Shortly press the key on the
steering wheel (under 0.8 seconds)
Ü Say a command.
Once voice recognition starts, the voice
command entry window and the six rep-
resentative commands are displayed.
!Ÿ
If voice recognition is in [Normal
Mode], then the system will say
“Please say a command after the
beep,” followed by a beep tone.
!Ÿ If voice recognition is in [Expert
Mode], then you will only hear a
beep a “Beep~”.
Skipping Prompt Messages
While prompt message is being stated
Ü Briefly press the
key on the
steering wheel. (under0.8 second)
The prompt message is immediately
ended and the beep tone will sound.
After the “beep”, say the voice command.
Re-starting Voice Recognition
While system waits Ü Briefly press
the
key on the
(under 0.8 seconds)
The command wait state will end and
the beep tone will sound. After the
“beep”, say the voice command.
Voice Recognition and
Phone Contact Tips
The Kia Voice Recognition System may
have difficulty understanding some accents
or uncommon names When using Voice
Recognition to place a call, speak in a
moderate tone, with clear pronunciation.
To maximize the use of Voice Recognition,
con sider these guidelines when storing
contacts:
!Ÿ Do not store single-name entries (e.g.,
“Bob”,
“Mom”, etc.). Instead, always use
full names (including first and last names)
for these contacts
!Ÿ Do not use special characters (e.g., ‘@’, ‘-’,
‘*’, ‘&’,
etc.)
!Ÿ Do not use abbreviations (i.e., use
“Lieutenant”
instead of “Lt.”) or acronyms
(i.e., use “County Finance Department”
instead of “C. F. D.”; Be sure to say the
name exactly as it is entered in the con-
tacts list. , @ 4 - @ ( < & / > " 7 / 2 3 ( @ * 2 4 J O E E
Page 63 of 76
60
V o i c e R e c o g n i t i o n
E n d i n g V o i c e
R e c o g n i t i o n
While Voice Recognition is operating
Ü Press and hold the
key on the
steering wheel. (over 0.8 seconds)
While using voice recognition, press-
ing a steering wheel remote control or
a different key will end voice recogni-
tion.
I l l u s t r a t i o n o n U s i n g
V o i c e
R e c o g n i t i o n
( S e t t i n g H o m e a s t h e
D e s t i n a t i o n )
Press the key. (under 0.8 seconds)
The system awaits for your command
and display a list of accessible com-
mands on the screen.
Destination
Please say a command after the beep
BEEP
Destination
Please say a command
after the beep
Go Home
BEEP , @ 4 - @ ( < & / > " 7 / 2 3 ( @ * 2 4 J O E E