engine Lancia Delta 2008 Owner handbook (in English)
Page 160 of 258
IN AN EMERGENCY159
4
If after several attempts the engine will not start, do not
keep trying but contact a Lancia Dealership.
IMPORTANT Never connect the negative terminals of the
two batteries directly: sparks could ignite explosive gas re-
leased from the battery. If the auxiliary battery is installed
on another car, prevent accidental contact between metal-
lic parts of the two cars.
BUMP STARTING
Never bump start the engine by pushing, towing or dri-
ving downhill.
This could cause a flow of fuel into the catalytic convert-
er and damage it beyond repair.
IMPORTANT Remember that the brake servo and the
power steering system (if present) are not operative until
the engine is started, a greater effort will therefore be re-
quired to press the brake pedal or turn the steering wheel.QUICK TYRE REPAIR KIT -
FIX & GO AUTOMATIC
The quick tyre repair kitFix & Go automatic is placed in
the luggage compartment.
The kit fig. 2 includes:
a cylinder A containing sealing liquid and fitted with:
– a filling pipe B;
– an adhesive label C bearing the words “max. 80
km/h”, to be attached in a position easily visible to
the driver (on the dashboard) after tyre repair;
fig. 2L0E0075m
Page 163 of 258
162IN AN EMERGENCY
INFLATION PROCEDURE
Put on the protective gloves provided togeth-
er with quick tyre repair kit.
Engage the handbrake. Unscrew the tyre valve cap,
take out the flexible filling pipe A-fig. 4 and screw
down the ring nut B on the tyre valve;
make sure that switch D-fig. 5 on the compressor is
in position 0 (off), start the engine, insert pin E-fig. 6
into the current socket and switch on the compressor
by placing switch D-fig. 5 in position 1 (on)
fig. 4L0E0077m
The cylinder contains ethylene glycol. Con-
tains latex: may cause an allergic reaction.
Harmful if swallowed. Irritates the eyes. May
cause sensitization by inhalation or contact. Avoid
contact with your eyes, skin and clothes. In the event
of contact, wash immediately with plenty of water.
Do not induce vomiting if swallowed. Rinse your
mouth and drink plenty of water. Call a doctor im-
mediately. Keep away from children. The product
must not be used by asthmatics. Do not breath in
the vapours during insertion and suction. Call a
doctor immediately if allergic reactions are noted.
Store the cylinder in the specific compartment, away
from sources of heat. The sealing fluid will expire.
Replace the cylinder containing expired seal-
ing liquid. Dispose of the cylinder and the
sealant liquid properly. Dispose according to
the national and local laws in force.
Page 165 of 258
164IN AN EMERGENCY
after driving for about 10 minutes, stop and check the
tyre pressure again; remember to engage the hand-
brake;if, on the other hand, a pressure of at least 1.8 bar pres-
sure is read, restore the correct pressure (with engine
running and handbrake on) and continue driving;
drive with the utmost care to the nearest Lancia Deal-
ership.
Apply the adhesive label in a position clear-
ly visible by the driver as a reminder that the
tyre has been treated with the quick repair
kit. Drive carefully, particularly on bends. Do not
exceed 80 km/h. Do not accelerate and brake sud-
denly.
Stop if the pressure has dropped to less than
1.8 bars: The automatic Fix & Go fast repair
kit cannot work properly because the tyre is
excessively damaged. Contact a Lancia Dealership.
Remember to inform the workshop that the
tyre has been treated with a quick repair kit.
Give the instruction booklet to the tyre repair
workshop personnel.
Page 171 of 258
170IN AN EMERGENCY
Taking out the small spare wheel
Important notes:
the jack weight is 1.76 kg;
the jack requires no adjustment;
the jack cannot be repaired; If it breaks it must be re-
placed with a new jack;
no tool other than the cranking device may be fitted
on the jack.
To replace a tyre proceed as follows:
stop the car in a position where it does not present a
danger for on-coming traffic and where you can re-
place the wheel safely. The ground must be flat and
compact.
turn the engine off and engage the handbrake;
engage first gear or reverse;
lift up the luggage compartment mat using handle A-
fig. 10 (in the presence of a double load platform, first
lift the upper cover and then the luggage compartment
mat).
loosen the fastener B-fig. 10;
take out the tool box C and place it next to the wheel
to be changed;
remove the small spare wheel D-fig. 10;
use the provided screwdriver to remove the hub cap,
levering the dedicated opening on the outer edge;
fig. 10L0E0081m
Page 190 of 258
IN AN EMERGENCY189
4
Engine compartment fuse box fig. 39 and 40
A second fuse box is located on the right side of the en-
gine compartment, next to the battery. To access this fuse
box release the side tabs and remove cover L. The ID num-
ber of the electrical component corresponding to each fuse
can be found on the back of this cover.
fig. 40L0E0089mfig. 39L0E0088m
If you need to wash the engine compartment,
take care not to directly hit the engine com-
partment control unit with the water jet.
Page 192 of 258
IN AN EMERGENCY191
4
FUSE SUMMARY TABLE - Dashboard control unit
F12
F12
F13
F13
F31
F32
F33
F34
F35
F36
F37
F38
F39
F40
F417.5
15
7.5
15
5
–
20
20
5
20
7.5
10
10
30
7.538
38
38
38
38
–
38
38
38
38
38
38
38
38
38
CONSUMERS FUSE AMPERE DIAGRAM
Right dipped beam headlight
Right dipped beam headlight (Xenon gas discharge bulb)
Left dipped beam headlight, headlight alignment corrector
Left dipped beam headlight (Xenon gas discharge bulb)
Climate control system fan relay coil, body computer
Spare
Left rear electric window
Right rear electric window
Reversing lights, engine compartment control unit relay coils,
brake light pedal control (normally closed contact),
water in the diesel fuel sensor, air flow meter
Central locking system control unit, fuel
butterfly, dead lock, tailgate release
Third brake light, instrument panel, Adaptive Headlights Node,
control unit on left-hand gas discharge headlight
Rear and front courtesy ligths (where fitted), sun visor lights,
glove compartment ligtht and luggage compartment light
Radio, radio-navigator, Blue&Me Node, alarm siren,
alarm system on courtesy light, climate control unit, tyre
pressure detection control unit, diagnostic connector,
rear courtesy light
Heated rear window
Electric door mirror demisters, demisters
on windscreen jets
Page 194 of 258
IN AN EMERGENCY193
4
–
40
40
40
40
40
40
40
40
40
40
40
40
40
40
40F08
F09
F10
F11
F14
F15
F16
F17
F18
F19
F22
F22
F23
F24
F30
F85–
20
10
10
15
30
7.5
10
7.5
7.5
15
20
20
5
15
15
FUSE SUMMARY TABLE - Engine compartment control unit
CONSUMERS FUSE AMPERE DIAGRAM
Spare
Headlight washer pump
Horn
Electronic injection secondary loads
Main beam headlights
PTC1 additional heater
Engine Management Node
Electronic injection primary loads
Engine Management Node
Air conditioning compressor
Electronic injection primary loads (1.4 engine)
Electronic injection primary loads (1.8 and diesel engine)
Brake Node (valves)
Electric Steering Node
Fog/cornering lights
Fuel pump
Page 200 of 258
CARE AND MAINTENANCE199
5
SCHEDULED SERVICING PLAN
Petrol versions
Thousands of kilometres
Check tyre condition/wear and adjust pressure if required
Check lighting system operation (headlights, direction indicators, hazard lights,
passenger compartment lights, boot lights, instrument panel warning lights, etc.)
Check windscreen wiper/washer operation
Check the position/wear of the windscreen/rearscreen wiper blades
Check condition and wear of front disc brake pads and
brake pad wear indication
Check rear disc brake pad condition and wear
Visually inspect the condition of: bodywork, underbody
protection, pipes and hoses
(exhaust - fuel - brakes), rubber parts
(boots, sleeves, bushes, etc.)
Check cleanness of bonnet and boot locks and
linkage cleanness and lubrication;
Check and top up, if required, fluid levels (engine coolant, brake/hydraulic
clutch fluid, windscreen washer fluid, battery fluid, etc)
Check the handbrake lever stroke and adjust it, if necessary
visually inspect the condition of the accessory drive belt
Visually inspect the condition of the toothed timing drive belt30 60 90 120 150 180
Page 201 of 258
200CARE AND MAINTENANCE
30 60 90 120 150 180
Thousands of kilometres
Check exhaust fumes/emissions
Check evaporation control system
Check engine management system operation (via diagnostic socket)
Replace auxiliary drive belt/s
Replace toothed timing drive belt (*)
Replace spark plugs
Replace air filter cartridge
Change engine oil and oil filter (or every 24 months)(**)
Change brake fluid (or every 2 years)
Change pollen filter (or every 15 months)
(*) Regardless of the km covered, the timing belt should be replaced every 4 years for particularly demanding use (cold climates,
driving in the city, idling for a long time) or in any case every 5 years.
(**) If the car is mainly used in cities or less than 10,000 km a year, change the engine oil and filter every 12 months.
For 1.4 Turbo Jet versions, in order to guarantee correct operation and prevent serious damage to the engine, it is essential to ob-
serve the following:
- only use spark plugs specifically certified for Turbo Jetengines; all spark plugs should be of the same type and brand (see the “En-
gine” paragraph);
- carefully observe the spark plug replacement intervals detailed in the Scheduled Service Plan;
- it is advisable to have this performed at a Lancia Dealership.
Page 202 of 258
CARE AND MAINTENANCE201
5
Diesel versions
Thousands of kilometres
Check tyre condition/wear and adjust pressure if required
Check lighting system operation (headlights, direction indicators, hazard lights,
passenger compartment lights, boot lights, instrument panel warning lights, etc.)
Check windscreen wiper/washer operation
Check the position/wear of the windscreen/rearscreen wiper blades
Check condition and wear of front disc brake pads and
brake pad wear indication
Check rear disc brake pad seal condition and wear
Visually inspect the condition of: bodywork, underbody
protection, pipes and hoses
(exhaust - fuel - brakes), rubber parts
(boots, sleeves, bushes, etc.)
Check cleanness of bonnet and boot locks and
linkage cleanness and lubrication
Check and top up, if required, fluid levels
(engine coolant, brake/hydraulic clutch fluid, windscreen washer fluid, battery fluid, etc)
Check the handbrake lever stroke and adjust it, if necessary
Check and if necessary adjust the auxiliary
drive belts (excluding engines equipped with automatic tensioners)
Check exhaust fumes/emissions
Visually inspect the condition of the auxiliary drive belt35 70 105 140 175