Switch Lexus ES300 1999 s (in English) Owner's Guide

SWITCHES
33
FOG LIGHT SWITCH
12E005±1
To turn on the fog lights, turn the switch to the ºONº
position. The fog lights come on only when the
headlights are on low beam.WINDSHIELD WIPER ANDWASHER SWITCH
12E006

SWITCHES
34

1Interval adjuster 2Washer on
To turn the wipers on, move the lever down until you
reach the desired speed setting.
The ignition key must be in the ºONº position.
There are 3 settings:
ºINTº position: Intermittent operation
ºLOº position: Low speed operation
ºHIº position: High speed operation
Twist the interval adjuster upward to increase the
wiping time interval between sweeps, and
downward to decrease it.
The wiper lever must be in the ºINTº position.
To make the washer squirt, pull the lever toward you
and release it.
Also, the wipers will automatically operate a couple of
times after the washer squirts even with the lever in the
ºOFFº position.
The low washer fluid warning light in the instrument
cluster comes on when the fluid level in the tank
becomes nearly empty. For information on adding
washer fluid, see ºAdding washer fluidº on page 432.
In cold weather, warm the windshield with the defroster
before using the washer. This will help prevent icing,
which could block your vision.NOTICE
Do not operate the wipers if the windshield is dry.
It may scratch the glass.

SWITCHES
35
Shifting the windshield wiper position
12E032a

1Rest position 2Retracted position
The wiper blades retract under the hood when the
wipers are turned off. If retraction is obstructed by snow,
etc., at the bottom of the windshield, the wipers should
be shifted from the retracted position to the rest position
above the hood level. When the snow season is over,
manually return the wipers to the retracted position
following the procedure given below.

SWITCHES
36
12E033a
To shift the windshield wipers from retracted to rest
position, hold the connection of the wiper arm and
wiper blade and pull it upward along the windshield
glass.
NOTICE
To prevent the wiper blades from being deformed,be sure to hold the connection of the wiper armand wiper blade securely.

SWITCHES
37
12E034a
To return the windshield wipers to retracted
position, push the connection of the wiper arm and
wiper blade downward.
NOTICE
To prevent the wiper blades from being deformed,be sure to hold the connection of the wiper armand wiper blade securely.

SWITCHES
38
REAR WINDOW AND OUTSIDEREAR VIEW MIRRORDEFOGGER SWITCH
12E011±1
To turn the electric rear window and outside rear
view mirror defogger on, push the switch.
The ignition key must be in the ºONº position.
The thin heater wires on the inside of the rear window
and the heater panels in the outside rear view mirrors will
quickly clear the surface. An indicator light is on when
the defogger is operating.
The system will automatically shut off when the defogger
has operated about 15 minutes.

SWITCHES
39
CAUTION
Since the mirror surfaces can get hot, keep your hands
off them when the rear window and outside rear view
mirror defogger switch is on.
If further defrosting or defogging is desired, simply
actuate the switch again. When the surface has cleared,
push the switch once again to turn the defogger off.
Continuous use may cause the battery to discharge,
especially during stop±and±go driving. The rear window
defogger is not designed to dry rain water or to melt
snow.
If the outside rear view mirrors are heavily coated with
ice, use a spray de±icer before operating the switch.
NOTICE
When cleaning the inside of the rear window, be
careful not to scratch or damage the heater wires.
To prevent the battery from being discharged,do not operate the defogger continuouslylonger than necessary.
POWER WINDOW SWITCHES
12E012±2

SWITCHES
40

1For driver's window
2For front passenger's window
3For left rear window
4For right rear window
To raise or lower the windows, use the switch on
each door. The passengers' windows can also be
controlled by the switches on the driver's door.
The ignition key must be in the ºONº position. However,
even if the ignition key is turned to the ºACCº or ºLOCKº
position with all the doors closed, the window can be
operated until a front door is opened (or for about 45
seconds).
12L010

SWITCHES
41
Operating the driver's and front
passenger's switch
To lower the window, push the switch halfway down.
Pull it up to raise the window. The window glass
moves as long as the switch is operated.
Automatic operation: To fully raise or lower the
window automatically, pull the switch fully up or push it
fully down.
To stop the window partway, lightly push or pull the
switch in the opposite direction and then release it.
Operating the rear passengers' switches
To lower the window, push the switch down. Pull it
up to raise the window. The window moves as long
as the switch is operated.
Operating the window lock switch
12E013±2

Indicator light
With the window lock switch pressed in, only the
driver's window can be raised or lowered.
The indicator lights on the switch tell you which of the
switches can be operated.

SWITCHES
42
Operating the driver's and front
passenger's windows from outside the
vehicle
The windows can be operated using an ignition key.
12E036
Insert the ignition key into the key hole on the
driver's side.
To close the windows: Turn the key in the locking
direction and hold it.
After the door is locked, the window begins to close. To
stop in the middle, return the key.
To open the windows: Turn the key in the unlocking
direction and hold it.
After the door is unlocked, the window begins to open.
To stop in the middle, return the key.