fuse Lexus ES300 2002 Owner's Manuals (in English)

SWITCHES
31
HEADLIGHT DIMMER AND TURNSIGNAL SWITCH
For high beam, push the lever forward. Pull it back for low
beam. For the headlight flasher, pull it further back.
A blue light in the instrument cluster indicates high beam or
headlight flasher is on.
The headlight flasher works even when the headlight switch is
off.
For signaling turns, move the lever up or down in the
conventional manner.
The ignition key must be in the “ON” position.
The turn signal is selfcancelling after a turn, but after a lane
change, you may have to cancel it by hand. You can also signal
a lane change by moving the turn signal lever partway and
holding it there.
If the green light in the instrument cluster flashes faster than
normal, it indicates that the front or rear turn signal bulb has
burned out. If this indicator light does not come on, the fuse
or the indicator light itself has probably failed.

INTERIOR EQUIPMENT
67
POWER OUTLET
The power outlet is designed for power supply for car
accessories.
The ignition key must be in the “ACC” or “ON” position for t\
he
power outlet to be used.
NOTICE
To prevent the fuse from being blown, do not use the
electricity over the total vehicle capacity of
12V/120W.
 To prevent the battery from being discharged, do not
use the power outlet longer than necessary when the
engine is not running.
Close the power outlet lid when the power outlet is
not in use. Inserting a foreign object other than the
appropriate plug that fits the outlet, or allowing any
liquid into the outlet may cause electrical failure or
short circuits.

AIR CONDITIONING
161
(a) Climate control
SETTING OPERATION automatic control
1. Push the “AUTO” button.
An indicator light will illuminate to show that the automatic
operation mode has been selected.
Air flow quantity, switching of the diffusers, onoff of the air
conditioning and switching of the air intake between
RECIRCULATED AIR and OUTSIDE AIR are automatically
adjusted. The operation status is shown by each indicator.
When one of the manual control buttons is depressed while
operating in automatic mode, the operation corresponding to
the button depressed is set. Other conditions continue to be
adjusted automatically.
Push the “OFF” button to turn the air conditioning system off.
2. Use the “TEMP” or “PASSENGER TEMP” button to set
the desired temperature.
The “TEMP” or “PASSENGER TEMP” button is used to set the
desired temperature. The temperature will be controlled on the
driver and passenger sides simultaneously or individually.
“TEMP” button—Changes the temperature on the driver and
passenger sides simultaneously or the driver side only.
“PASSENGER TEMP” button—Changes the temperature on
the passenger side only.
“DUAL” button— Changes the mode of the temperature
setting.
The indicator on the “DUAL” button has two modes:
 With the indicator on— For individual temperature setting
 With the indicator off— For simultaneous temperature
setting

AUDIO
179
(b) Presetting a station
1. Tune in the desired station.
2. Push
one of the station selector buttons ( 16 ) and hold
it until a beep is heard. This sets the station to the button
and the button number ( 16 ) appears on the display.
Each button can store one AM station and two FM stations. To
change the preset station to a different one, follow the same
procedure.
The preset station memory is cancelled when the power
source is interrupted by battery disconnection or a blown fuse. (c) Selecting a station
Your Lexus has an electronic tuning radio (ETR). Tune in the
desired station using one of the following methods.
Seek tuning: Push the “SEEK” button. The radio will begin
seeking up
or down for a station of the nearest frequency and
will stop on reception. Each time you push the button, the
stations will be searched out one after another.
Preset tuning: Push the button ( 16 ) for the station you want.
The button number ( 16 ) and station frequency appear on the
display.
Manual tuning: Turn the “TUNE” knob. The radio will step up
or down to another frequency.

AUDIO
199
Turn this knob to the right to step up the station band or
to the left to step down.
Your radio automatically changes to stereo reception when a
stereo broadcast is received. “ST” appears on the display. If
the signal becomes weak, the radio reduces the amount of
channel separation to prevent the weak signal from creating
noise. If the signal becomes extremely weak, the radio
switches from stereo to mono reception. In this case, “ST”
disappears from the display.(b) Presetting a station
1. Tune in the desired station.
2. Push
one of the station selector buttons ( 16 ) and hold
it until a beep is heard. This sets the station to the button
and the button number ( 16 ) appears on the display.
Each button can store one AM station and two FM stations. To
change the preset station to a different one, follow the same
procedure.
The preset station memory is cancelled when the power
source is interrupted by battery disconnection or a blown fuse.

INTRODUCTION
289
ENGINE COMPARTMENT OVERVIEW
1 Power steering fluid
reservoir
2 Engine oil filler cap
3 Brake fluid reservoir
4 Fuse box
5 Battery
6 Fuse box
7 Radiator
8 Condenser
9 Electric cooling fans
10 Engine oil level
dipstick
11 Washer fluid tank
12 Engine coolant
reservoir

INTRODUCTION
292
Checking brake fluid
Parts (if level is low):
FMVSS No. 116 DOT 3 or SAE J1703 brake fluid
Tools:
 Funnel (only for adding fluid)
Checking power steering fluid
Parts (if level is low):
Automatic transmission fluid DEXRON
II or III
Tools:
 Rag or paper towel
 Funnel (only for adding fluid)
Checking battery condition
Tools:
Warm water
 Baking soda
 Grease
 Conventional wrench (for terminal clamp bolts)
Checking and replacing the blade type fuses
Parts (if replacement is necessary):
Fuse with same amperage rating as original
Checking the cartridge type fuses
Parts (if replacement is necessary):
Genuine Lexus fuse or equivalent with same amperage
rating as original
Adding washer fluid
Parts:
Water
 Washer fluid containing antifreeze (for winter use)
Tools:
 Funnel

SECTION 6 – 4
323
SERVICE PROCEDURES AND
SPECIFICATIONS
Electrical components
Specifications324
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .\
. . . . . .
Checking battery condition 329
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Battery recharging precautions 332
. . . . . . . . . . . . . . . . . . . . . . . . . . . .
Checking and replacing the blade type fuses 332
. . . . . . . . . . . . . . . .
Checking the cartridge type fuses 335
. . . . . . . . . . . . . . . . . . . . . . . . . .
Adding washer fluid 336
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .\
.
Checking the headlight aim 336
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Replacing light bulbs 338
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .\

ELECTRICAL COMPONENTS
324
SPECIFICATIONS
FUSE LOCATIONS
64E092
 1 2 Engine compartment
3 Driver’s side instrument panel FUSES
64E119
1
Engine compartment

ELECTRICAL COMPONENTS
326
No.FUSEAMPERECIRCUIT
1 ABS NO.47.5
Antilock brake system,
vehicle skid control system,
traction control system, brake
assist system
2 A/F25Multiport fuel injection
system/sequential multiport
fuel injection system
3 DOOR125
Multiplex communication
system (power door lock
system, autodoor locking
system, wireless remote
control system)
4 TEL5No circuit
5 AM230All components in “IGN” and
“IG2” fuses and starting system
6 EFI20Multiport fuel injection
system/sequential multiport
fuel injection system
7 ALTS5Charging system
8 HEAD LHUPR10Lefthand headlight (high
beam)
9 ETCS10Multiport fuel injection
system/sequential multiport
fuel injection system
10 HORN10Horns
11 IGN15Starting system
12 HEAD RH UPR10Righthand headlight (high
beam)
No.FUSEAMPERECIRCUIT
13 HAZ15Emergency flashers
14 D.C.C30All components in “ECUB”,
“RAD NO.1” and “DOME” fuses
15 IG210
Multiport fuel injection
system/sequential multiport
fuel injection system, SRS
airbag system, front seat belt
pretensioners, cruise control
system
16 ST5Starting system
17 ADJ PDL30Power adjustable pedals
18 CDS30Electric cooling fan
19 ABS NO.240
Antilock brake system,
vehicle skid control system,
traction control system, brake
assist system
20 MAIN40
All components in “HEAD LH
LWR”, “HEAD RH LWR”, “HEAD
LH UPR”, “HEAD RH UPR” and
“DRL” fuses
21 ABS NO.340
Antilock brake system,
vehicle skid control system,
traction control system, brake
assist system
22 HTR50Air conditioning system
23 RDI30Electric cooling fan