Lexus GS450h 2015 Owner's Manual

490
GS450h_OM_OM30F70U_(U)
6-3. Do-it-yourself maintenance
CAUTION
■Replacing light bulbs
●Turn off the lights. Do not attempt to replace the bulb immediately after turning
off the lights.
The bulbs become very hot and may cause burns.
●Do not touch the glass portion of the light bulb with bare hands. When it is
unavoidable to hold the glass portion, use and hold with a clean dry cloth to avoid
getting moisture and oils on the bulb.
Also, if the bulb is scratched or dropped, it may blow out or crack.
●Fully install light bulbs and any parts used to secure them. Failure to do so may
result in heat damage, fire, or water entering the headlight unit. This may damage
the headlights or cause condensation to build up on the lens.
●Vehicles with discharge headlights: While
the headlights are turned on, and for a short
time after they have been turned off, metal
components at the rear of the headlight
assembly will be extremely hot. To prevent
burns, do not touch these metal compo-
nents until you are certain they have cooled
down.
Metal components
GS450h_OM_OM30F70U_(U).book Page 490 Monday, January 19, 2015 9:34 AM

GS450h_OM_OM30F70U_(U)
4916-3. Do-it-yourself maintenance
6
Maintenance and care
CAUTION
■Discharge headlights (if equipped)
●Contact your Lexus dealer before replacing the discharge headlights (including
light bulbs).
●Do not touch the discharge headlight’s high voltage socket when the headlights
are turned on.
An extremely high voltage of 30000 V will be discharged and could result in
death or serious injury by electric shock.
●Do not attempt to take apart or repair the headlight bulbs, connectors, power
supply circuits, or related components.
Doing so could result in electric shock and death or serious injury.
■To prevent damage or fire
●Make sure bulbs are fully seated and locked.
●Check the wattage of the bulb before installing to prevent heat damage.
GS450h_OM_OM30F70U_(U).book Page 491 Monday, January 19, 2015 9:34 AM

492
GS450h_OM_OM30F70U_(U)
6-3. Do-it-yourself maintenance
GS450h_OM_OM30F70U_(U).book Page 492 Monday, January 19, 2015 9:34 AM

493
GS450h_OM_OM30F70U_(U)
7When trouble arises
7-1. Essential information Emergency flashers................... 494
If your vehicle has to be stopped in an emergency ....495 7-2. Steps to take in an emergency
If your vehicle needs to be towed ................................ 496
If you think something is wrong ................502
If a warning light turns on or a warning buzzer sounds .....503
If a warning message is displayed ................................. 513
If you have a flat tire.................... 541
If the hybrid system will not start................................ 554
If the shift lever cannot be shifted from P ..................... 556
If the parking brake cannot be released ................................ 557
If the electronic key does not operate properly ..................... 559
If the 12-volt battery is discharged ............................. 562
If your vehicle overheats ......... 566
If the vehicle becomes stuck ...............................................571
GS450h_OM_OM30F70U_(U).book Page 493 Monday, January 19, 2015 9:34 AM

494
GS450h_OM_OM30F70U_(U)
7-1. Essential information
Emergency flashers
Press the switch.
All the turn signal lights will flash.
To turn them off, press the switch once
again.
■Emergency flashers
If the emergency flashers are used for a long time while the hybrid system is not
operating (while the “READY” indicator is not illuminated), the 12-volt battery may
discharge.
The emergency flashers are used to warn other drivers when the vehi-
cle has to be stopped in the road due to a breakdown, etc.
GS450h_OM_OM30F70U_(U).book Page 494 Monday, January 19, 2015 9:34 AM

495
GS450h_OM_OM30F70U_(U)
7
When trouble arises
7-1. Essential information
If your vehicle has to be stopped in an emergency
Steadily step on the brake pedal with both feet and firmly depress it.
Do not pump the brake pedal repeatedly as this will increase the effort required to
slow the vehicle.
Shift the shift lever to N.
XIf the shift lever is shifted to N
After slowing down, stop the vehicle in a safe place by the road.
Stop the hybrid system.
XIf the shift lever cannot be shifted to N
Keep depressing the brake pedal with both feet to reduce vehicle
speed as much as possible.
To stop the hybrid system, press
and hold the power switch for 2
consecutive seconds or more, or
press it briefly 3 times or more in
succession.
Stop the vehicle in a safe place by the road.
Only in an emergency, such as if it becomes impossible to stop the vehi-
cle in the normal way, stop the ve hicle using the following procedure:
1
2
3
4
3
Press and hold for 2 seconds or more
or press briefly 3 times or more
4
CAUTION
■If the hybrid system has to be turned off while driving
Power assist for the steering wheel will be lost, making the steering wheel heavier
to turn. Decelerate as much as possible before turning off the hybrid system.
5
GS450h_OM_OM30F70U_(U).book Page 495 Monday, January 19, 2015 9:34 AM

496
GS450h_OM_OM30F70U_(U)
7-2. Steps to take in an emergency
If your vehicle needs to be towed
The following may indicate a problem with your transmission. Contact
your Lexus dealer or commercial towing service before towing.
●The hybrid warning message shows on the multi-information display
and the vehicle does not move.
●The vehicle makes an abnormal sound.
If towing is necessary, we recommend having your vehicle towed by
your Lexus dealer or commercial towing service, using a wheel-lift type
truck or flatbed truck.
Use a safety chain system for all towing, and abide by all state/provin-
cial and local laws.
Situations when it is necessary to contact dealers before towing
GS450h_OM_OM30F70U_(U).book Page 496 Monday, January 19, 2015 9:34 AM

4977-2. Steps to take in an emergency
GS450h_OM_OM30F70U_(U)
7
When trouble arises
Do not tow with a sling-type truck to
prevent body damage.
Towing with a sling-type truck
Towing with a wheel-lift type truck
XFrom the frontXFrom the rear
Use a towing dolly under the rear
wheels. Use a towing dolly under the front
wheels.
GS450h_OM_OM30F70U_(U).book Page 497 Monday, January 19, 2015 9:34 AM

4987-2. Steps to take in an emergency
GS450h_OM_OM30F70U_(U)If your vehicle is transported by a
flatbed truck, it should be tied down
at the locations shown in the illustra-
tion.
If you use chains or cables to tie
down your vehicle, the angles
shaded in black must be 45
°.
Do not overly tighten the tie downs
or the vehicle may be damaged.
If a tow truck is not available in an emergency, your vehicle may be tempo-
rarily towed using cables or chains secured to the emergency towing eye-
lets. This should only be attempted on hard surfaced roads for short
distances at under 3 mph (5 km/h).
A driver must be in the vehicle to steer and operate the brakes. The vehi-
cle’s wheels, drive train, axles, steering and brakes must be in good condi-
tion.
Using a flatbed truck
Emergency towing
GS450h_OM_OM30F70U_(U).book Page 498 Monday, January 19, 2015 9:34 AM

4997-2. Steps to take in an emergency
GS450h_OM_OM30F70U_(U)
7
When trouble arises
Take out the towing eyelet. (→P. 542)
Remove the eyelet cover using a
flathead screwdriver.
To protect the bodywork, place a rag
between the screwdriver and the vehi-
cle body as shown in the illustration.
Insert the towing eyelet into the
hole and tighten partially by hand.
Tighten down the towing eyelet
securely using a wheel nut
wrench or hard metal bar.
Securely attach cables or chains to the towing eyelet.
Take care not to damage the vehicle body.
Enter the vehicle being towed and start the hybrid system.
If the hybrid system does not start, turn the power switch to ON mode.
Shift the shift lever to N and release the parking brake.
When the shift lever cannot be shifted: →P. 5 5 6
Emergency towing procedure
1
2
3
4
5
6
7
GS450h_OM_OM30F70U_(U).book Page 499 Monday, January 19, 2015 9:34 AM