navigation Lexus GX460 2017 Navigation Manual

Page 152 of 403

150
6. TIPS FOR THE NAVIGATION SYSTEM
GX460_Navi_OM60N98U_(U)16.05.30 14:27
zAccurate current position may not be
shown in the following cases:
• When driving on a small angled Y-shaped
road.
• When driving on a winding road.
• When driving on a slippery road such as in sand, gravel, snow, etc.
• When driving on a long straight road.
• When freeway and surface streets run in parallel.
• After moving by ferry or vehicle carrier.
• When a long route is searched during high speed driving.
• When driving without setting the current position calibration correctly.
• After repeating a change of direction by going forward and backward, or turning
on a turntable in a parking lot.
• When leaving a covered parking lot or parking garage.
• When a roof carrier is installed.
• When driving with tire chains installed.
• When the tires are worn.
• After replacing a tire or tires.
• When using tires that are smaller or larger than the factory specifications.
• When the tire pressure in any of the 4 tires is not correct. z
Inappropriate route guidance may occur in
the following cases:
• When turning at an intersection off the
designated route guidance.
• If you set more than 1 destination but skip any of them, auto reroute will display a
route returning to the destination on the
previous route.
• When turning at an intersection for which there is no route guidance.
• When passing through an intersection for which there is no route guidance.
• During auto reroute, the route guidance may not be available for the next turn to
the right or left.
• During high speed driving, it may take a long time for auto reroute to operate. In
auto reroute, a detour route may be
shown.
• After auto reroute, the route may not be changed.
• If an unnecessary U-turn is shown or announced.
• If a location has multiple names and the system announces 1 or more of them.
• When a route cannot be searched.
• If the route to your destination includes gravel, unpaved roads or alleys, the route
guidance may not be shown.
• Your destination point might be shown on the opposite side of the street.
• When a portion of the route has regula- tions prohibiting the entry of the vehicle
that vary by time, season or other reasons.
• The road and map data stored in the navi- gation system may not be complete or
may not be the latest version.
z If the vehicle cannot receive GPS signals,
the current position can be adjusted
manually. For information on setting the
current position calibration: →P.1 4 5
GX_Navi_OM60N98U_(U).book Page 150 Monday, May 30, 2016 2:28 PM

Page 153 of 403

151
6. TIPS FOR THE NAVIGATION SYSTEM
GX460_Navi_OM60N98U_(U)16.05.30 14:27
3
NAVIGATION SYSTEM
zAfter replacing a tire: →P.1 4 6
INFORMATION

This navigation system uses tire turning
data and is designed to work with factory-
specified tires for the vehicle. Installing
tires that are larger or smaller than the
originally equipped diameter may cause
inaccurate display of the current position.
The tire pressure also affects the diame-
ter of the tires, so make sure that the tire
pressure of all 4 tires is correct.
GX_Navi_OM60N98U_(U).book Page 151 Monday, May 30, 2016 2:28 PM

Page 154 of 403

152
6. TIPS FOR THE NAVIGATION SYSTEM
GX460_Navi_OM60N98U_(U)16.05.30 14:27
2. MAP DATABASE VERSION AND COVERED AREA
1Press the “NAV” button.
2Select “Options” .
3Select “Map Data” .
4Check that the map data screen is dis-
played.
MAP INFORMATION
Coverage areas and legal information
can be displayed and map data can be
updated.
No.Function
Map version
Select to update map.
Select to display map coverage ar-
eas.
Select to display legal information.
INFORMATION

Map data updates are available for a fee.
Contact your Lexus dealer for further
information.
GX_Navi_OM60N98U_(U).book Page 152 Monday, May 30, 2016 2:28 PM

Page 155 of 403

153
6. TIPS FOR THE NAVIGATION SYSTEM
GX460_Navi_OM60N98U_(U)16.05.30 14:27
3
NAVIGATION SYSTEM
ABOUT THE MAP DATA
Map data for the navigation system is
contained in a SD card that is inserted in
the SD card slot located at the bottom of
the audio control panel.
Do not eject the SD card, as doing so
may deactivate the navigation system.
NOTICE
●Do not edit or delete the map data on the
SD card, as doing so may deactivate the
navigation system.
INFORMATION

microSDHC Logo is a trademark of
SD-3C, LLC.
GX_Navi_OM60N98U_(U).book Page 153 Monday, May 30, 2016 2:28 PM

Page 156 of 403

154
6. TIPS FOR THE NAVIGATION SYSTEM
GX460_Navi_OM60N98U_(U)16.05.30 14:27
GX_Navi_OM60N98U_(U).book Page 154 Monday, May 30, 2016 2:28 PM

Page 190 of 403

188
2. RADIO OPERATION
GX460_Navi_OM60N98U_(U)16.05.30 14:27
3. INTERNET RADIO
1Select the desired application screen
button.
zThe internet radio application screen is dis-
played.
z Perform operations according to the dis-
played application screen.
z If a compatible phone is already registered,
it will be connected automatically.
z By pressing the “A U D I O ” button, the
“Audio” screen can be returned to.
LISTENING TO INTERNET
RADIO
One of LEXUS App Suite’s features is
the ability to listen to internet radio. In or-
der to use this service, a compatible
phone and the navigation system needs
to be set up. For details: →P.357
INFORMATION

Other applications can be activated
while listening to internet radio.
●An iPhone cannot be connected via
Bluetooth® and USB connection at the
same time. However, it is possible to
recharge an iPhone while using applica-
tions by connecting via USB. The system
uses the connection method that was
used last. Therefore, if connected via
USB after Bluetooth
® connection, it is
necessary to reconnect the iPhone via
Bluetooth
®.
●Some parts of applications can be
adjusted using the switches on the steer-
ing wheel.
●For additional information, refer to
http://www.lexus.com/enform/
or call
1-800-255-3987.
GX_Navi_OM60N98U_(U).book Page 188 Monday, May 30, 2016 2:28 PM

Page 240 of 403

238
4. REAR SEAT ENTERTAINMENT SYSTEM OPERATION
GX460_Navi_OM60N98U_(U)16.05.30 14:27
1Select Apps mode on the source screen
to display the control screen.
■CONTROL SCREEN
1Display the audio source selection
screen. ( →P.232)
2Select “DISC” .
zEven the “DISC” button is pressed, the
mode can be changed to the DISC mode.
■ CONTROL SCREEN
■ CONTROLLERUSING THE RADIO (INTERNET
RADIO BROADCAST)
One of Apps’s features is the ability to
listen to internet radio. In order to use
this service, an Apps compatible phone
and the navigation system needs to be
set. ( →P.357)
PLAYING AN AUDIO CD/CD
TEXT
No.Function
Select to set repeat playback.
Select to set random playback.
No.Function
Press to play/pause.
Press to fast forward/rewind.
zPress to select a track.
z Press and hold to fast forward/
rewind.
GX_Navi_OM60N98U_(U).book Page 238 Monday, May 30, 2016 2:28 PM

Page 282 of 403

280
GX460_Navi_OM60N98U_(U)16.05.30 14:27
1. VOICE COMMAND SYSTEM OPERATION
1. VOICE COMMAND SYSTEM
Talk switch
zPress the talk switch to start the voice com-
mand system.
z To cancel voice recognition, press and hold
the talk switch. z
It is unnecessary to speak directly into the
microphone when giving a command.
The voice command system enables the
navigation, audio/visual, hands-free and
air conditioning systems to be operated
using voice commands.
Refer to the command list for samples of
voice commands. ( →P.289)
USING THE VOICE
COMMAND SYSTEM
STEERING SWITCH
MICROPHONE
INFORMATION

Wait for the confirmation beep before
speaking a command.
●Voice commands may not be recognized
if:
•Spoken too quickly.
• Spoken at a low or high volume.
• The roof or windows are open.
• Passengers are talking while voice com- mands are spoken.
• The air conditioning speed is set high.
• The air conditioning vents are turned towards the microphone.
●In the following conditions, the system
may not recognize the command prop-
erly and using voice commands may not
be possible:
• The command is incorrect or unclear.Note that certain words, accents or
speech patterns may be difficult for the
system to recognize.
• There is excessive background noise, such as wind noise.
GX_Navi_OM60N98U_(U).book Page 280 Monday, May 30, 2016 2:28 PM

Page 284 of 403

282
1. VOICE COMMAND SYSTEM OPERATION
GX460_Navi_OM60N98U_(U)16.05.30 14:27
■DISPLAYING THE “Voice Settings”
SCREENS
zSelecting can be displayed the
“Voice Settings” screen.
INFORMATION

If the navigation system does not respond
or the confirmation screen does not dis-
appear, press the talk switch and try
again.
●If a voice command cannot be recog-
nized, voice guidance will say “Pardon?”
(“Command not recognized.” will be dis-
played on the screen) and voice com-
mand reception will restart.
●If a voice command cannot be recog-
nized 2 consecutive times, the voice
command guidance system will say
“Paused. To restart voice recognition,
push the talk switch. To cancel voice rec-
ognition, press and hold the talk switch.”
Then voice recognition will be sus-
pended.
●“Voice Recognition Prompts” can be set
to on or off on the “Voice Settings”
screen. ( →P. 6 2 )
●Voice guidance can be canceled by set-
ting voice prompts to off. Use this setting
when it is desirable to say a command
immediately after pressing the talk switch
and hearing a beep.
GX_Navi_OM60N98U_(U).book Page 282 Monday, May 30, 2016 2:28 PM

Page 291 of 403

289
1. VOICE COMMAND SYSTEM OPERATION
GX460_Navi_OM60N98U_(U)16.05.30 14:27
5
VOICE COMMAND SYSTEM
3. COMMAND LIST
zFrequently used commands are listed in the following tables.
z For devices that are not installed in the vehicle, the related commands will not be dis-
played in the shortcut menu screen. Also, according to conditions, other commands
may not be displayed in the shortcut menu screen.
z The functions available may vary according to the navigation system installed.
XBasic
X Apps
When the voice recognition la nguage is set to English.
Recognizable voice commands and their actions are shown below.
zVoice recognition language can be changed. (→ P. 5 5 )
CommandAction
“Help”Prompts voice guidance to offer examples of commands
or operation methods
“Go Back”Returns to the previous screen
“Go to <tab>”Displays the command list of the selected tab
“More Hints”Displays more commonly used commands
“Cancel”Cancels the voice command system
CommandAction
“Launch <apps>”Activates the LEXUS App Suite application
GX_Navi_OM60N98U_(U).book Page 289 Monday, May 30, 2016 2:28 PM

Page:   < prev 1-10 ... 31-40 41-50 51-60 61-70 71-80 81-90 91-100 101-110 110 next >