display Lexus IS250 2015 Navigation Manual

Page 298 of 406

297
1. LEXUS PARKING ASSIST MONITOR
PERIPHERAL MONITORING SYSTEM
IS250/350_Navi_U
7
Guide lines are not displayedThe trunk is open.Close the trunk.
If this does not resolve the
symptom, have the vehicle in-
spected by your Lexus dealer.
The estimated course lines
are not displayed•The steering wheel has
been moved while the bat-
tery was being reinstalled.
• Battery power is low.
• The steering sensor has
been reinstalled.
• There is a malfunction in the
signals being output by the
steering sensor.Stop the vehicle, and turn the
steering wheel as far as it will
go to the left and right.
If this does not resolve the
symptom, have the vehicle in-
spected by your Lexus dealer.
SymptomLikely causeSolution

Page 300 of 406

299
2. INTUITIVE PARKING ASSIST
IS250/350_Navi_U
PERIPHERAL MONITORING SYSTEM
7
■MULTI-INFORMATION DISPLAY
Front corner sensors operation
Front center sensors operation
Rear corner sensors operation
Rear center sensors operation
■NAVIGATION DISPLAY
X When the vehicle is moving forward
: Select to mute the buzzer sounds.
zThe graphic is automatically displayed
when an obstacle is detected. The screen
can be set so that the graphic is not dis-
played. ( →P. 3 0 6 )
XWhen the vehicle is moving backward
zA simplified image is displayed on the
right upper corner of the screen when
an obstacle is detected.
DISPLAY
When the sensors detect an obstacle,
the graphic is shown on the multi-infor-
mation display and navigation display
according to position and distance to
the obstacle.

Page 301 of 406

300
2. INTUITIVE PARKING ASSIST
IS250/350_Navi_U
■CORNER SENSORS
■ CENTER SENSORS
THE DISTANCE DISPLAY AND BUZZER
When a sensor detects an obstacle, the direction of and the approximate distance to
the obstacle are displayed and the buzzer sounds.
Level1234
Display example
BuzzerMediumFastContinuous
Level1234
Display example
BuzzerSlowMediumFastContinuous

Page 305 of 406

304
2. INTUITIVE PARKING ASSIST
IS250/350_Navi_U
NOTICE
●Notes when washing the vehicle
● Do not apply intensive bursts of water or
steam to the sensor area.
● Doing so may result in the sensor mal-
functioning.
● As the intuitive pa rking assist-sensor
might be malfunctioning in the following
cases, have it checked by your Lexus
dealer.
• The graphic which indicates that an obstacle has been detected does not
come on and a beep does not sound
even when the intuitive parking assist
mode is turned on.
• The graphic which indicates that an obstacle has been detected comes on
despite no obstacle around the vehicle.
• If your vehicle has been involved in an accident.
• If the graphic which indicates that an obstacles has been detected remains
on without a beeping sound.
INTUITIVE PARKING ASSIST-
SENSOR FAILURE WARNING
If an error is detected when the intuitive
parking assist-sensor is turned on, the
vehicle symbol comes on or flashes with
beeping sounds.
INFORMATION
● The intuitive parking assist-sensor failure
warning display is not given in either of
the following operations:
• Changing to another screen
• Turning off the main switch for the intui-
tive parking assist-sensor
WHEN SNOWFLAKES OR
MUD GETS ON THE SENSORS
INFORMATION
● If this screen appears, remove the foreign
matter from the sensor.
● If the failure warning does not go off even
after the foreign matter is removed, the
intuitive parking assist-sensor may be
malfunctioning. Have it checked by your
Lexus dealer.

Page 307 of 406

306
2. INTUITIVE PARKING ASSIST
IS250/350_Navi_U
2. INTUITIVE PARKING ASSIST SETTING
1Press the “MENU” button on the
Remote Touch.
2Select “Setup” .
3Select “Vehicle” .
4Select “LEXUS Park Assist” .
5Select the desired button.
The volume of the beeps, turning on or
off of the display, etc. can be set.

Page 308 of 406

307
2. INTUITIVE PARKING ASSIST
IS250/350_Navi_U
PERIPHERAL MONITORING SYSTEM
7
1Display the “LEXUS Park Assist Set-
tings” screen. (→P. 306)
2Select the desired screen button.
zThe volume has 5 levels, increasing with
higher value.
1Display the “LEXUS Park Assist Set-
tings” screen. ( →P. 306)
2Select “Display Off” to turn off the
parking sonar display.
SETTING AN ALERT VOLUME
The alert volume can be adjusted.
SETTING A PARKING SONAR
DISPLAY
Parking sonar display can be set to on or
off.
INFORMATION
● Although “Display Off” is selected, if the
obstacle is detected during the intuitive
parking assist monitoring, the warning
appears on the right top of the screen.

Page 309 of 406

308
2. INTUITIVE PARKING ASSIST
IS250/350_Navi_U
1Display the “LEXUS Park Assist Set-
tings” screen. (→P. 306)
2Select “Front” or “Rear”.
zSelecting “Front” or “Rear” to switch the
distance for the front or back sensors dis-
play and tone indication, from long distance
to short distance, or from short distance to
long distance.
SETTING A DISPLAY AND
TONE INDICATION
Front and back sensors display and tone
indication can be set.

Page 310 of 406

8
309
IS250/350_Navi_U
2
8
4
5
6
7
3
9
1
1. QUICK REFERENCE ............................ 310
2. SOME BASICS .......................................... 311
REGISTERING/CONNECTING A Bluetooth® PHONE ....................................... 312
USING THE PHONE SWITCH/ MICROPHONE ................................................... 312
VOICE COMMAND SYSTEM........................ 313
ABOUT THE CONTACTS IN THE CONTACT LIST......................................... 314
WHEN SELLING OR DISPOSING OF THE VEHICLE ....................................................... 315
3. CALLING ON THE Bluetooth®
PHONE..................................................... 316
BY FAVORITES LIST ............................................. 317
BY CALL HISTORY ............................................... 317
BY CONTACTS LIST ............................................ 318
BY DIAL PAD ............................................................ 321
BY OFF HOOK SWITCH ................................... 321
4. RECEIVING ON THE Bluetooth®
PHONE.................................................... 322
INCOMING CALLS ............................................. 322
5. TALKING ON THE Bluetooth®
PHONE.................................................... 323
INCOMING CALL WAITING ....................... 325
6. Bluetooth® PHONE MESSAGE
FUNCTION............................................ 326
RECEIVING A MESSAGE ................................ 327
CHECKING MESSAGES ................................. 328
REPLYING TO A MESSAGE
(QUICK REPLY)................................................. 329
CALLING THE MESSAGE SENDER ......... 330
1. PHONE/MESSAGE SETTINGS ....... 332
PHONE/MESSAGE SETTINGS SCREEN ................................................................. 332
“Sound Settings” SCREEN ................................. 333
“Contact/Call History Settings” SCREEN ................................................................. 334
“Messaging Settings” SCREEN ........................ 344
“Phone Display Settings” SCREEN ................. 345
1. TROUBLESHOOTING ........................ 346
1
PHONE OPERATION
(HANDS-FREE SYSTEM FOR
CELLULAR PHONES)
2SETUP
3WHAT TO DO IF...
PHONE

Page 311 of 406

310
IS250/350_Navi_U
1. PHONE OPERATION (HANDS-FREE SYSTEM FOR CELLULAR PHONES)
1. QUICK REFERENCE
The phone top screen can be used to make a phone call. To display this screen, press
the “MENU” button on the Remote Touch and select “Phone”, or the switch on the
steering wheel.
Several functions are available to operate on each screen that is displayed by selecting
the 4 tabs.
FunctionPage
Phone operation
Registering/connecting Bluetooth® device47
Calling on the Bluetooth® phone316
Receiving on the Bluetooth® phone322
Talking on the Bluetooth® phone323
Message functionUsing the Bluetooth® phone message function326
Setting up a phonePhone settings332
Bluetooth® settings55

Page 313 of 406

312
1. PHONE OPERATION (HANDS-FREE SYSTEM FOR CELLULAR PHONES)
IS250/350_Navi_U
XSteering switch
Volume control switch
z Press the “+” side to increase the volume.
z Press the “-” side to decrease the volume.
Off hook switch
On hook switch
REGISTERING/
CONNECTING A Bluetooth®
PHONE
To use the hands-free system for cellular
phones, it is necessary to register a cel-
lular phone with the system. ( →P. 47)
Bluetooth® PHONE
CONDITION DISPLAY
The condition of the Bluetooth
® phone
appears on the upper right side of the
screen. ( →P. 16)
USING THE PHONE SWITCH/
MICROPHONE
By pressing the phone switch, a call can
be received or ended without taking
your hands off the steering wheel.

Page:   < prev 1-10 ... 141-150 151-160 161-170 171-180 181-190 191-200 201-210 211-220 221-230 ... 240 next >