Seat lexus LC500 2018 Owner's Guide

52
-$@-$I@0.@0.&@ &&

1-2. Child safety
WARNING
●Never use a rear-facing child restraint system on the front passenger seat when the airbag manual on-off switch
is on. ( P.46) The force of the rapid inflation of the front passenger airbag can cause
death or serious injury to children in the event of an accident.
●There is a label(s) on the passenger side sun visor, indicating it is forbidden to attach a rear-facing child restraint
system to the front passenger seat. Details of the label(s) are shown in the illustration below.

53
1
-$@-$I@0.@0.&@ &&

1-2. Child safety
For safety and security
WARNING
WARNING
■When installing a child restraint sys-
tem
●Only put a forward-facing child
restraint system on the front seat when unavoidable. When installing a for-
ward-facing child rest raint on the front passenger seat, move the seat as far back as possible. Failing to do so may
result in death or serious injury if the airbags deploy (inflate).
●Do not allow the child to lean his/her head or any part of his/her body
against the door or the area of the seat, front or rear pillars or roof side rails from which the SRS side airbags or
SRS curtain shield airbags deploy even if the child is seated in the child restraint system. It is dangerous if the
SRS side and curtain shield airbags inflate, and the impact could cause death or serious injury to the child.
●When a junior seat is installed, always ensure that the shoulder belt is posi-
tioned across the center of the child’s shoulder. The belt should be kept away from the child’s neck, but not so that it
could fall off the child’s shoulder.
●Use child restraint system suitable to the age and size of the child and install it to the rear seat.

54
-$@-$I@0.@0.&@ &&

1-2. Child safety
■Confirming the possible installa-
tion seating positions and the Mass
Group for the seat belt installation
type child restraint systems
1 Confirm the corresponding [Mass
group] from the weight of the child
( P.50)
(Ex. 1) When the weight is 12 kg (27
lb.), [Mass group 0+]
(Ex. 2) When the weight is 15 kg
(34 lb.), [Mass group I]
2 Confirm and select the appropriate
possible seating position for the
child restraint system and the cor-
responding type of system from the
[Child restraint systems fastened
with SEAT BELT - Compatibility
table].
■Child restraint systems fastened with SEAT BELT - Compatibility table
If your child restraint system is of “universal” category, you can install it on the posi-
tions mentioned by U or UF in the table below (UF is for forward-facing child
restraint systems only). Child restraint systems category and mass group can be
found in the child restraint system manual.
If your child restraint system is not of the “universal” category (or if you cannot find
information in the table below), please refer to the child restraint system “vehicle
list” for compatibility information or ask the retailer of your child seat.
WARNING
●If the driver’s seat interferes with the child restraint system and prevents it from being attached correctly, attach
the child restraint system to the right- hand rear seat (left-hand drive vehi-cles) or the left-hand rear seat (right-
hand drive vehicles). ( P.54, 58)
●Adjust the front passenger seat so that
it does not interfere with the child restraint system.
Child restraint system fixed with
a seat belt

55
1
-$@-$I@0.@0.&@ &&

1-2. Child safety
For safety and security
Key of letters inserted in the above table:
X: Not suitable seat position for children in this mass group.
U: Suitable for “universal” category child restraint systems approved for use in this
mass group.
UF: Suitable for forward-facing “unive rsal” category child restraint systems
approved for use in this mass group.
*1: Adjust the seatback angle to the most upright position. Move the front seat fully rear-
ward. If the passenger seat height can be ad justed, move it to the upper most position.
*2: If the head restraint interferes with your child restraint system, and the head restraint can
be removed, remove the head restraint. Otherwise, put the head restraint in the upper
most position.
 When installing a child restraint in
the rear seats, adjust the front seat
so that it does not interfere with the
child or child restraint system.
 When installing a child seat with
support base, if the child seat inter-
feres with the seatback when latch-
ing it into the support base, adjust
the seatback rearward until there is
no interference.
Mass groups
Seating position
Front passenger seat
Rear seatAirbag manual on-off switch
ONOFF
0
Up to 10 kg
(22 lb.)
XU*1X
0+
Up to 13 kg
(28 lb.)
XU*1X
I
9 to 18 kg
(20 to 39 lb.)
Rearward-facing 
X
U*1, 2XForward-facing 
UF*1, 2
II, III
15 to 36 kg
(34 to 79 lb.)
UF*1, 2U*1, 2X

56
-$@-$I@0.@0.&@ &&

1-2. Child safety
When installing a forward-facing
child seat, if there is a gap between
the child seat and the seatback,
adjust the seatback angle until good
contact is achieved.
 If the seat belt shoulder anchor is
ahead of the child seat belt guide,
move the seat cushion forward.
 When installing a junior seat, if the
child in your child restraint system is
in a very upright position, adjust the
seatback angle to the most comfort-
able position. And if the seat belt
shoulder anchor is ahead of the
child seat belt guide, move the seat
cushion forward.
■Installing child restraint system
using a seat belt
Install the child restraint system in
accordance to the operation manual
enclosed with the child restraint sys-
tem.
1 If installing the child restraint sys-
tem to the front passenger seat is
unavoidable, refer to P.51 for front
passenger seat adjustment.
2 If the head restraint interferes with
the child restraint system installa-
tion and the head restraint can be
removed, remove the head
restraint. Otherwise, put the head
restraint in the upper most position.
( P.143)
3 Run the seat belt through the child
restraint system and insert the plate
into the buckle. Make sure that the
belt is not twisted. Securely fix the
seat belt to the child restraint sys-
tem in accordance to the directions
enclosed with the child restraint
system.
4 If your child restraint system is not
equipped with a lock-off (a seat belt

57
1
-$@-$I@0.@0.&@ &&

1-2. Child safety
For safety and security
locking feature), secure the child
restraint system using a locking clip.
5 After installing the child restraint
system, rock it back and forth to
ensure that it is installed securely.
( P.57)
■Removing a child restraint system
installed with a seat belt
Press the buckle release button and
fully retract the seat belt.
When releasing the buckle, the child
restraint system may spring up due to the
rebound of the seat cushion. Release the
buckle while holding down the child
restraint system.
Since the seat belt automatically reels itself,
slowly return it to the stowing position.
■When installing a child restraint system
You may need a locking clip to install the child restraint system. Follow the instruc-tions provided by the manufacturer of the
system. If your child restraint system does not provide a locking clip, you can purchase the following item from any authorized
Lexus retailer or Lexus authorized repairer, or any reliable repairer: Locking clip for child restraint system (Part
No. 73119-22010)
■ISOFIX rigid anchors (ISOFIX
child restraint system)
Lower anchors are provided for the
each rear seat. (Buttons displaying the
location of the anchors are attached to
the seats.)
WARNING
■When installing a child restraint sys- tem
Observe the following precautions. Failure to do so may result in death or serious injury.
●Do not allow children to play with the
seat belt. If the seat belt becomes twisted around a child’s neck, it may lead to choking or other serious inju-
ries that could result in death. If this occurs and the buckle cannot be unfastened, scissors should be used to
cut the belt.
●Ensure that the belt and plate are securely locked and the seat belt is not twisted.
●Shake the child restraint system left
and right, and forward and backward to ensure that it has been securely installed.
●After securing a child restraint system,
never adjust the seat.
●When a junior seat is installed, always ensure that the shoulder belt is posi-tioned across the center of the child’s
shoulder. The belt should be kept away from the child’s neck, but not so that it could fall off the child’s shoulder.
●Follow all installation instructions pro-
vided by the child restraint system manufacturer.
Child restraint system fixed with
an ISOFIX rigid anchor

58
-$@-$I@0.@0.&@ &&

1-2. Child safety
■Confirming the Mass group and
Size class for ECE R44 ISOFIX
corresponding child restraint sys-
tems
1 Confirm the corresponding [Mass
group] from the weight of the child
( P.50)
(Ex. 1) When the weight is 12 kg (27
lb.), [Mass group 0+]
(Ex. 2) When the weight is 15 kg
(34 lb.), [Mass group I]
2 Confirming Size class
Select the Size class corresponding
to [Mass group] confirmed in step 1
from the [Child restraint systems
fastened with ISOFIX (ECE R44) -
Compatibility table]*.
(Ex. 1) When [Mass group 0+], the
corresponding size class is [C], [D],
[E].
(Ex. 2) When [Mass group I], the
corresponding size class is [A], [B],
[B1], [C], [D].
*: However, listings that are marked with
[X] cannot be selected, despite having
the corresponding size class in the suit-
ability table of the [Seating position].
■Child restraint systems fastened
with ISOFIX (ECE R44) - Compat-
ibility table
ISOFIX child restraint systems are
divided in different “size class”.
According to this “size class”, you will
be allowed to use it in the vehicle seat-
ing position mentioned in the table
below. To know your child restraint sys-
tem “size class” and “mass group”,
please refer to the child restraint sys-
tem manual.
If your child restraint system has no
“size class” (or if you cannot find infor-
mation in the table below), please refer
to the child restraint system “vehicle
list” for compatibility information or ask
the retailer of your child seat.
Size classDescription
AFull-height, forward-fac-
ing child restraint systems
B
Reduced-height forward-
facing child restraint sys-
tems
B1
Reduced-height forward-
facing child restraint sys-
tems
CFull-size rearward-facing
child restraint systems
D
Reduced-size rearward-
facing child restraint sys-
tems
ERearward-facing infant
seat

59
1
-$@-$I@0.@0.&@ &&

1-2. Child safety
For safety and security
Key of letters inserted in the above table:
X: Not suitable seat position for ISOFIX child restraint systems in this mass group
and/or size class.
IUF: Suitable for ISOFIX forward-facing ch ild restraint systems of “universal” cate-
gory approved for use in this mass group.
 When installing a child restraint in
the rear seats, adjust the front seat
so that it does not interfere with the
child or child restraint system.
■Installation with ISOFIX rigid
anchor (ISOFIX child restraint sys-
tem)
Install the child restraint system in
accordance to the operation manual
FLeft lateral-facing
(carrycot) infant seat
GRight lateral-facing
(carrycot) infant seat
Size classDescription
Mass groupsSize class
Seating position
Front seatRear seatPassenger seat
CarrycotFXX
GXX
0
Up to 10 kg
(22 lb.)
EXX
0+
Up to 13 kg
(28 lb.)
EXX
DXX
CXX
I
9 to 18 kg
(20 to 39 lb.)
DXX
CXX
BXX
B1XIUF
AXX

60
-$@-$I@0.@0.&@ &&

1-2. Child safety
enclosed with the child restraint sys-
tem.
1 Check the positions of the exclu-
sive fixing bars, and install the child
restraint system to the seat.
The bars are installed in the clearance
between the seat cushion and seatback.
2 After installing the child restraint
system, rock it back and forth to
ensure that it is installed securely.
( P.57)
■Anchor brackets (for top strap)
Anchor brackets are provided for each
rear seat.
Use anchor brackets when fixing the
top strap.
Top strap
Anchor brackets
■Fixing the top strap to the anchor
bracket
Install the child restraint system in
accordance to the operation manual
enclosed with the child restraint sys-
tem.
Open the anchor bracket cover, latch
the hook onto the anchor bracket and
tighten the top strap.
Make sure the top strap is securely latched.
WARNING
■When installing a child restraint sys- tem
Observe the following precautions. Failure to do so may result in death or
serious injury.
●After securing a child restraint system, never adjust the seat.
●When using the lower anchors, be sure that there are no foreign objects
around the anchors and that the seat belt is not caught behind the child restraint system.
●Follow all installation instructions pro-
vided by the child restraint system manufacturer.
Using an anchor bracket (for top
strap)
A
B

61
1
-$@-$I@0.@0.&@ &&

1-2. Child safety
For safety and security
(P.57)
Top strap
Hook
WARNING
■When installing a child restraint sys- tem
Observe the following precautions. Failure to do so may result in death or serious injury.
●Firmly attach the top strap and make
sure that the belt is not twisted.
●Do not attach the top strap to anything other than the anchor bracket.
●After securing a child restraint system, never adjust the seat.
●Follow all installation instructions pro-
vided by the child restraint system manufacturer.
NOTICE
■Anchor brackets (for top strap)
When not in use, make certain to close the lid. If it remains open, the lid may be damaged.
A
B