display lexus LS400 1998 Engine / LEXUS 1998 LS400 (OM50498U) User Guide

GAUGES, METERS AND SERVICE REMINDER INDICATORS
42
(a) Cruise information
13L0491
The following information is shown with the ignition switch
turned on. Each time you push the ”MODE” button, the
displayed information is changed.
Available driving distance
Average fuel consumption
Current fuel consumption
Average fuel consumption after being refueled
Driving distance after being refueled
Elapsed time
Average vehicle speed
The displayed values of cruise information indicate the general
driving condition, so those may not show precise and actual
condition.
Available driving distance
W24
When the fuel gauge indicates around ”F”
W25W25
When the fuel gauge indicates around middle
W26
When the fuel gauge indicates around ”E”
Available driving distance with the remaining fuel is calculated
and displayed depending on the amount of remaining fuel.
Average fuel consumption
W27
W27
The average fuel consumption is calculated and displayed based
on the total driving distance and the total fuel consumption with
the engine running.
The value is updated every 10 seconds.
To calculate from the beginning, push the ”RESET” button.

GAUGES, METERS AND SERVICE REMINDER INDICATORS
43
Current fuel consumption
W28
W28
The current fuel consumption is calculated and displayed based
on the driving distance and the fuel consumption for 2 seconds
with the engine running.
The value is updated every 2 seconds.
If you are driving at low speeds just before stopping, the accurate
figure may not be shown.
Average fuel consumption after being refueled
W29
W29
The average fuel consumption after being refueled is calculated
and displayed based on the total driving distance and the total
fuel consumption after being refueled.
The value is updated every 10 seconds.
To calculate from the beginning, push the ”RESET” button.
Driving distance after being refueled
W30
W30
The driving distance after being refueled is displayed.
Elapsed time
W31
W31
The total time during the engine running is displayed.
When the engine is started again after the ignition is off, the driving
time is added to the previous value. Up to 99 hours 59 minutes can
be displayed. When the driving time exceeds 99 hours 59 minutes,
the display returns to 0 and recounting starts.
To count from the beginning, push the ”RESET” button.
Average vehicle speed
W32
W32
The average vehicle speed is calculated and displayed based on
the total driving distance and the total driving time with the
engine running.
The displayed value is updated every 10 seconds.
To calculate from the beginning, push the ”RESET” button.

GAUGES, METERS AND SERVICE REMINDER INDICATORS
44
(b) Warning messages
13L052
Reminder light
W40
W40
When the engine oil pressure becomes too low, the above
message appears, the reminder light flashes and the warning
tone sounds.
If this message appears while you are driving, pull off the road to a
safe place and stop the engine immediately. Call a Lexus dealer or
qualified repair shop for assistance.
The message may appear when the oil level is extremely low. It is
not designed to indicate low oil level, and the oil level must be
checked using the oil level dipstick.
NOTICE
Do not drive the vehicle with the warning message displayed
even for one block. It may ruin the engine.
W41 W41
When your brake pads are worn enough to require replacement,
the above message appears, the reminder light flashes and the
warning tone sounds.
If this message appears while you are driving, have the brake pads
checked and replaced by your Lexus dealer as soon as possible.
W43 W43
W42
W42
W451
W44
W44
W46
W46
When any door or trunk is open with the ignition switch turned
on, the message which door or trunk is open appears, and the
reminder light comes on.

SECTION 1 4
47
INSTRUMENTS AND CONTROLS
Interior equipment
Vanity mirrors 48. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Interior lights 49. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Personal lights 50. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Ignition switch light 50. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Clock 51. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Outside temperature display 51. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Cigarette lighter and ashtray 52. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Power outlet 53. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Glovebox 54. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Garage door opener 54. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Cup holder 56. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Coin box 57. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Penlight 58. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Floor mat 58. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Luggage stowage precautions 59. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

INTERIOR EQUIPMENT
51
CLOCK
14L46
The digital clock indicates the time with the ignition key at the
”ACC” or ”ON” position. To reset the hour, press the ”H”
button. To reset the minutes, press the ”M” button. To adjust
the time to the nearest hour, press the ”:00” button.
For example, if the ”:00” button is pressed when the time is between
9:30 9:59 or between 10:01 10:29, the time will change to 10:00.
Once the electrical power source has been disconnected from the
clock, the time is automatically set to 1:00.
For vehicles equipped with Navigation System, refer to the
separate ”Owner’s Manual for Navigation System”.
OUTSIDE TEMPERATURE DISPLAY
14L026-4
This display shows the outside temperature when the ignition
switch is on.
The displayed temperature ranges from 30C (22F) up to 50C
(122F). If the temperature does not appear on the display or it
shows ” ”, take your vehicle to your Lexus dealer.

AIR CONDITIONING AND AUDIO
122
1
Driver side temperature control button
2
Front windshield button
3
Driver side temperature display (in degrees Fahrenheit or
Centigrade)
4
Fan speed display
5
Air intake control button
6
Air flow display
7
Air conditioning onoff button
8
Passenger side temperature control button
9
Passenger side temperature display (in degrees Fahrenheit
or Centigrade)
10Separate/dual control button
11Air flow control button
12Fan speed control button
13OFF button
14Automatic control button

AIR CONDITIONING AND AUDIO
126If quick heating or cooling is desired
Push the ”TEMP” or ”PASSENGER TEMP” button on either side
and hold it until ”MAX. HOT” or ”MAX. COLD” appears on the
display.
If manual fan speed control is desired
21L007-3
1
Fan speed at low 2
Fan speed at high
The fan speed can be set to your desired speed by pushing the
appropriate side of fan speed control button. The higher the fan
speed is, the more air is delivered. Pushing the ”OFF” button turns
off the fan.
To remove exterior windshield frost, use the high speed setting.If manual switching of air intake is desired
21L008-4
Each time you push the air intake control button, the mode changes
in order from the RECIRCULATED AIR mode to AUTOMATIC
mode to OUTSIDE AIR mode, then back to the RECIRCULATED
AIR mode. Each indicator light shows which mode is now selected.
1
RECIRCULATED mode If quick circulation of cooled air
is desired, select this mode.
2
AUTOMATIC mode When driving where the outside air is
dirty (i.e., when the vehicle running just in front of your vehicle
accelerates rapidly), the system changes automatically from
the OUTSIDE AIR mode to the RECIRCULATED mode.
3
OUTSIDE AIR mode The system will take fresh outside air
into the vehicle.

AIR CONDITIONING AND AUDIO
127 For normal use, it is best to keep the air intake control button set to
OUTSIDE AIR mode. If recirculated air is used during heating, the
windows will fog up more easily.
To change the sensitivity of the sensor switching between the
RECIRCULATED and OUTSIDE AIR in the AUTOMATIC
mode, push the air intake control button until you hear a beep.
The display changes as illustrated below.
21L044
Each time you push the ”TEMP” button, the sensitivity changes from
”+3” down to ”3”. If you do not operate any button for a few
seconds, the previous display returns.If manual onoff of the air conditioning is desired
Push the ”A/C” button to turn the air conditioning on and push it
again to turn the air conditioning off.
The air conditioning does not work if the outside temperature is
lowered down to around 0C (32F).
If the system is used for ventilation, heating in dry weather or
removing frost or exterior fog on the windshield, turn the air
conditioning off once it is no longer required. This will improve fuel
economy. The air conditioning can be used for yearround
automatic temperature control including cooling and dehumidifying
operation.
If the air conditioning compressor does not operate, the indicator of
the ”A/C” button will blink. If the indicator of the ”A/C” button
blinks even when the ”A/C” button is pushed again, have the
compressor checked by your nearest Lexus dealer.

AIR CONDITIONING AND AUDIO
133
1
Turning the system on and adjusting volume
(See page 134 for details.)
2
Stopping and ejecting a cassette tape
(See page 140 for details.)
3
Function buttons
1 6:Station selector buttons
(See page 138 for details.)
SCAN:Scan tuning
(See page 139 for details.)
P. SCAN: Preset scan tuning
(See page 139 for details.)
4
Display of functions in TAPE mode

:
Side change
(See page 141 for details.)
:DOLBY NR
(See page 140 for details.)
:Rewinding
(See page 141 for details.)

:Fast forwarding
(See page 141 for details.)
RPT:Automatic repeat
(See page 141 for details.)
SKIP:Automatic skip of blank portions of tape
(See page 141 for details.)
SCAN:Scan selection
(See page 142 for details.)
4
Display of functions in CD mode
:Disc selection
(See page 146 for details.)
:Reversing
(See page 147 for details.)

:Fast forwarding
(See page 147 for details.)
RPT:Automatic repeat
(See page 148 for details.)
RAND:Random access
(See page 148 for details.)
SCAN:Scan selection
(See page 146 for details.)
5
Mode selectors
(See page 134 for details.)
6
Cassette tape slot
(See page 140 for details.)
7
Automatic sound levelizer
(See page 136 for details.)
8
Tone and balance knobs
(See page 135 for details.)
9
Radio mode:Frequency tuning
(See page 137 or 139 for details.)
TAPE mode:Direct access to a desired program
(See page 142 for details.)
CD mode:Direct access to a desired program
(See page 147 for details.)

AIR CONDITIONING AND AUDIO
135
20L043
In the ”TAPE” or ”CD” mode, the applicable functions are
shown in the lowest part of the display. Push the switch just
below to turn on each function.
(b) Tone and balance
How good an audio program sounds to you is largely determined by
the mix of the treble, midrange, and bass levels. In fact, different
kinds of music and vocal programs usually sound better with
different mixes of treble, midrange, and bass.
A good balance of the left and right stereo channels and of the front
and rear sound levels is also important.
Keep in mind that if you are listening to a stereo recording or
broadcast, changing the right/left balance will increase the volume
of one group of sounds while decreasing the volume of another.
20L044-2
”BASS” knob: Use this knob to adjust lowpitched tones.
”MID” knob: Use this knob to adjust midpitched tones.
”TREBLE” knob: Use this knob to adjust highpitched tones.
”BALANCE” knob: Use this knob to adjust the sound balance
between the right and left speakers.
”FADER” knob: Use this knob to adjust the sound balance between
the front and rear speakers.