key lexus LS400 1998 Engine / LEXUS 1998 LS400 (OM50498U) User Guide

KEYS AND DOORS
14
Unlocking the trunk lid
11L0132
When you keep the button pushed for about 1 second, you can
unlock the trunk lid.* One beep sounds.
This function does not work when the ignition key is in the ”ON”
position.
NOTE: *The operation method can be changed. Ask your Lexus
dealer for details.
Sounding an alarm*
11L0143
When you push the ”LOCK” button for about 2 to 3 seconds, an
alarm sounds to deter any person trying to break into or damage
your vehicle.
If you want to stop the alarm, push any button.
This function does not work when the ignition key is in the ”ON”
position.
NOTE: *The alarm can be set not to sound. Ask your Lexus
dealer for details.

KEYS AND DOORS
15
Operating the windows and moon roof
The windows and moon roof can be operated using a wireless key
from outside the vehicle.*
NOTE: *The windows can be set inoperative. The moon roof can
be set to slide open, tilt up or inoperative. Ask your Lexus dealer
for details.
11L0322
Push the ”UNLOCK” button until the windows and moon roof start
to move. When you release the button, the windows and moon roof
stop operating.
For vehicles sold in U.S.A.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) this
device must accept any interference received, including
interference that may cause undesired operation.This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause
harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more
of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and
receiver.
Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
Consult the dealer or an experienced radio / TV
technician for help.

KEYS AND DOORS
16
CAUTION
Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to
operate the equipment.
For vehicles sold in Canada
This device complies with RSS210 of Industry and
Science Canada.
Operation is subject to the following two conditions: (1)
this device may not cause interference, and (2) this device
must accept any interference, including interference that
may cause undesired operation of the device.
Replacing the battery
When you replace the battery, prepare a lithium battery CR1616 and
a special screwdriver.
CAUTION
Special care should be taken that small children do not
swallow the removed battery or components.
NOTICE
When replacing the battery, be careful not lose the components,
screws and Oring.
11L0281
1. Remove the screw, and then the cover while pushing it in the
arrow direction.

KEYS AND DOORS
17
11L0291
2. Remove the module from the key frame.
11L0301
3. Remove the 2 screws to take out the lid of the module.
4. Take out the discharged battery and put a new battery with the
positive side up.
NOTICE
Make sure the positive side and negative side of the battery
should be faced correctly.
Be careful not to bend the electrode of the battery insertion
and that dust or oils do not adhere to the inside of the module.
Take care not to lose the screws and Oring.
5. Install the lid with the Oring and 2 screws.
NOTICE
Take care not to damage or bend the Oring when installing.
6. Install the module into the key frame and secure the cover with
the screw.
7. When pushing any switch on the wireless key, make sure the
indicator light comes on.

KEYS AND DOORS
18
DOORS
Locking with key
11L0261
1
Lock 2
Unlock
Turn the key towards the front of the vehicle to lock and towards
the back to unlock.
The doors lock and unlock simultaneously with either front door. In
the driver’s door lock, turning the key once will unlock the driver’s
door and twice in succession will unlock all doors simultaneously.*
In the passenger’s door lock, turning the key once will unlock all
doors simultaneously.
NOTE: *Unlocking by a 2time operation can be changed. Ask
your Lexus dealer for details.
Locking with inside lock button
11L006
1
Lock 2
Unlock
Push in the lock button to lock and unlock the door.
When locked, the door cannot be opened with either the outside or
inside door handle.
Closing the door with the lock button pushed in will also lock the
door. Be careful not to lock your keys in the vehicle. The door will
not lock if the key is left in the ignition switch when closing the front
doors.

KEYS AND DOORS
19
CAUTION
Before driving, make sure the doors are closed and locked,
especially when small children are in the vehicle. Along with
the proper use of seat belts, locking the doors helps prevent the
driver and passengers from being thrown out from the vehicle
during an accident. It also helps prevent the doors from being
opened unintentionally.
Locking with power door lock switch
11L007-2
1
Lock 2
Unlock
To lock all the doors simultaneously, push the power door lock
switch on the front side. Pushing on the rear side will unlock
them.
The same switch is also equipped on the front passenger’s side.
Locking with rear door childprotector
11L009-2
Whenever small children are in the vehicle, lock the rear door so
that it does not open from the inside. To do this, turn the knob
to the ”LOCK” position as shown and then close the door.

KEYS AND DOORS
20

SWITCHES
22
HEADLIGHT SWITCH
12L001
To turn the lights on, twist the knob on the end of the lever.
FIRST CLICKSTOP: Only the parking, tail, license plate, side
marker and instrument panel lights turn on.
SECOND CLICKSTOP: Headlights also turn on.
THIRD CLICKSTOP (”AUTO”): The headlights and all other
lights automatically turn on depending on the darkness of the
surroundings.*
Vehicles sold in U.S.A.: When the headlights are on, the headlight
indicator lights up in the instrument cluster.
Vehicles sold in Canada: When the tail lights are on, the tail light
indicator lights up in the instrument cluster.
Manually twist the knob to the second clickstop to turn on the
headlights if they are needed immediately when entering a dark
tunnel, parking structure, etc.
12L002
The automatic light control sensor is on top of the driver’s side
instrument panel.
Do not place anything on the instrument panel, and/or do not affix
anything on the windshield to block this sensor.
When the headlights come on, the lights automatically turn off about
30 seconds after any of the doors is opened and closed with the
ignition key turned to the ”ACC” or ”LOCK” position.** To turn
them on again, turn the ignition key to the ”ON” position, or turn the
headlight switch off and then twist the knob until the first or second
clickstop. If you are going to park for over one week, make sure the
headlight switch is off.
When the headlight switch is on with all the doors locked, pushing
the ”LOCK” button on the wireless remote control key turns off the
headlights.
NOTE: *The operating condition or sensitivity can be changed.
**The time before turning off the lights can be changed. Ask your
Lexus dealer for details.

SWITCHES
24
HEADLIGHT DIMMER AND TURN
SIGNAL SWITCH
12L003
For high beam, push the lever forward. Pull it back for low
beam. For the headlight flasher, pull it further back.
A blue light in the instrument cluster indicates high beam or
headlight flasher is on.
The headlight flasher works even when the headlight switch is off.
12L004
For signaling turns, move the lever up or down in the
conventional manner.
The ignition key must be in the ”ON” position.
The turn signal is selfcancelling after a turn, but after a lane change,
you may have to cancel it by hand. You can also signal a lane change
by moving the turn signal lever partway and holding it there.
If the green light in the instrument cluster flashes faster than normal,
it indicates that the front or rear turn signal bulb has burned out. If
this indicator light does not come on, the fuse or the indicator light
itself has probably failed.

SWITCHES
25
FOG LIGHT SWITCH
12L005
To turn on the fog lights, turn the switch to the ”ON” position.
The fog lights come on only when the headlights are on low beam.
WINDSHIELD WIPER AND
WASHER SWITCH
12L0061
1
Interval adjuster 2
Washer on
To turn the wipers on, move the lever down until you reach the
desired speed setting.
The ignition key must be in the ”ON” position.
There are 3 settings:
”INT” position: Intermittent operation
”LO” position: Low speed operation
”HI” position: High speed operation
Twist the interval adjuster upward to increase the wiping time
interval between sweeps, and downward to decrease it.
The wiper lever must be in the ”INT” position.