ABS LEXUS RX270 2014 User Guide

Page 277 of 652

277
2-4. Using other driving systems
2
When driving
RX350/270_EE
All-wheel drive lock switch (AWD models)
■All-wheel drive lock mode
●All-wheel drive lock mode is canceled when the brakes are applied to ensure
the ABS and VSC systems operate effectively.
●All-wheel drive lock mode is canceled when the vehicle speed exceeds 40
km/h (25 mph).
All-wheel drive lock mode can be used when a large amount of drive power
needs to be applied to all the wheels, such as when the vehicle gets stuck in
mud and you need to free it.
Press the switch.
The torque of the engine is dis-
tributed to the rear wheels to
the maximum extent possible in
accordance with driving condi-
tions.
Pressing the switch again can-
cels all-wheel drive lock mode
and returns the active torque
control 4WD system to normal
mode. (→P. 2 7 1 )
RX350_270_EE_48D77E.book 277 ページ 2014年1月24日 金曜日 午前10時4分

Page 287 of 652

287
2-4. Using other driving systems
2
When driving
RX350/270_EE
CAUTION
■Limitations of the pre-crash safety system
Do not overly rely on the pre-crash safety system. Always drive safely, taking care to
observe your surroundings and checking for any obstacles or other road hazards.
Failure to do so may cause an accident resulting in death or serious injury.
■Cautions regarding the assist contents of the system
By means of alarms and brake control, the pre-crash safety system is intended to
assist the driver in avoiding collisions through the process of LOOK-JUDGE-ACT.
There are limits to the degree of assistance the system can provide, so please keep
in mind the following important points.
●Assisting the driver in watching the road
The pre-crash safety system is only able to detect obstacles directly in front of the
vehicle, and only within a limited range. It is not a mechanism that allows careless
or inattentive driving, and it is not a system that can assist the driver in low-visibil-
ity conditions. It is still necessary for the driver to pay close attention to the vehi-
cle’s surroundings.
●Assisting the driver in making correct judgment
When attempting to estimate the possibility of a collision, the only data available
to the pre-crash safety system is that from obstacles it has detected directly in
front of the vehicle. Therefore, it is absolutely necessary for the driver to remain
vigilant and to determine whether or not there is a possibility of collision in any
given situation.
●Assisting the driver in taking action
The pre-crash safety system’s braking assist feature is designed to help reduce
the severity of a collision, and so only acts when the system has judged that a col-
lision is unavoidable. This system by itself is not capable of automatically avoiding
a collision or bringing the vehicle to a stop safely. For this reason, when encoun-
tering a dangerous situation the driver must take direct and immediate action in
order to ensure the safety of all involved.
RX350_270_EE_48D77E.book 287 ページ 2014年1月24日 金曜日 午前10時4分

Page 507 of 652

507
4-3. Do-it-yourself maintenance
4
Maintenance and care
RX350/270_EE
Fuse layout and amperage ratings
■Engine compartment
FuseAmpereCircuit
1RDI FAN NO. 180 AElectric cooling fans
2RR DEF50 ARear window defogger
3AIR SUS50 AElectronically modulated air suspen-
sion
4HEATER50 AAir conditioning system
5SPARE30 A
6SPARE40 A
7ABS NO. 230 AVehicle stability control
8H-LP CLN30 AHeadlight cleaner
9PBD30 APower back door
10ST30 AStarter system
11PD50 A
A/F, H-LP RH HI, H-LP LH LO, H-LP
RH LO, H-LP LH HI, HORN, S-
HORN, EFI MAIN NO. 2
RX350_270_EE_48D77E.book 507 ページ 2014年1月24日 金曜日 午前10時4分

Page 508 of 652

508
4-3. Do-it-yourself maintenance
RX350/270_EE
12ABS NO. 150 AVehicle stability control
13EPS60 AElectric power steering system
14ALT140 A
IG1 MAIN, TOWING BATT,
DEICER, TOWING, STOP, RDI FAN
NO. 1, FILTER, RR DEF, AIR SUS,
HEATER, ABS NO. 2, H-LP CLN,
PBD, ECU-IG1 NO. 1, ECU-IG1 NO.
3, GAUGE NO. 1, ECU-IG1 NO. 2,
E P S , F R W I P, R R W I P, F R WA S H , R R
WASH, RH S-HTR, LH S-HTR, TAIL,
PANEL, D/L ALT B, FR FOG, FR
DOOR, FL DOOR, RR DOOR, RL
DOOR, PSB, P-SEAT LH, P-SEAT
RH, TI&TE, FUEL OPN, DR LOCK,
OBD, RR FOG, S/ROOF, 4WD,
INVERTER, ECU-ACC, P/POINT,
CIG, RADIO NO. 2
15AMP130 AAudio system
16EFI MAIN30 A
Multiport fuel injection system/
sequential multiport fuel injection sys-
tem, electronic controlled transmis-
sion, EFI NO. 1, EFI NO. 2, F/PMP
17AMP230 AAudio system
18IG2 MAIN30 AIGN, GAUGE NO. 2, ECU IG 2
19IP J/B25 APow e r d o o r l o c k s y s t e m
20STR LOCK20 AStarter system
21RAD NO. 315 AMeters and gauges, navigation sys-
tem, audio system
22HAZ15 AEmergency flashers
FuseAmpereCircuit
RX350_270_EE_48D77E.book 508 ページ 2014年1月24日 金曜日 午前10時4分

Page 519 of 652

519
4-3. Do-it-yourself maintenance
4
Maintenance and care
RX350/270_EEReplace the light bulb, and install
the bulb base.
Align the 3 tabs on the light bulb
with the mounting, and insert.
Turn and secure the bulb base.
Connect the connector.
Shake the bulb base gently to
check that it is not loose, turn the
headlight high beams on once and
visually confirm that no light is leak-
ing through the mounting.
When replacing the right side bulb, install by conducting
with the directions reversed.
STEP4
STEP5
STEP5STEP6STEP5STEP1
RX350_270_EE_48D77E.book 519 ページ 2014年1月24日 金曜日 午前10時4分

Page 520 of 652

520
4-3. Do-it-yourself maintenance
RX350/270_EE■Halogen headlight low beams (if equipped)
Turn the bulb base counterclock-
wise.
Unplug the connector while
depressing the lock release.
Replace the light bulb, and install
the bulb base.
Align the 3 tabs on the light bulb
with the mounting, and insert.
Turn and secure the bulb base.
Shake the bulb base gently to
check that it is not loose, turn the
headlight low beams on once and
visually confirm that no light is leak-
ing through the mounting.
STEP1
STEP2
STEP3
STEP4
RX350_270_EE_48D77E.book 520 ページ 2014年1月24日 金曜日 午前10時4分

Page 523 of 652

523
4-3. Do-it-yourself maintenance
4
Maintenance and care
RX350/270_EEReplace the light bulb, and install
the bulb base.
Align the 3 tabs on the light bulb
with the mounting, and insert.
Turn and secure the bulb base.
Connect the connector.
Shake the bulb base gently to
check that it is not loose, turn the
front fog lights on once and visually
confirm that no light is leaking
through the mounting.
When replacing a light bulb, install by conducting with the
directions reversed.
STEP4
STEP5
STEP5STEP6STEP5STEP1
RX350_270_EE_48D77E.book 523 ページ 2014年1月24日 金曜日 午前10時4分

Page 544 of 652

544
5-2. Steps to take in an emergency
RX350/270_EE
Have the vehicle inspected immediately.
Failing to investigate the cause of the following warnings may lead to the
system operating abnormally and possibly cause an accident. Have the
vehicle inspected by any authorized Lexus dealer or repairer, or another
duly qualified and equipped professional immediately.
Warning lightWarning light/Details
Malfunction indicator lamp
Indicates a malfunction in:
• The electronic engine control system;
• The electronic throttle control system; or
• The electronic automatic transmission control system
SRS warning light
Indicates a malfunction in:
• The SRS airbag system; or
• The seat belt pretensioner system
ABS warning light
Indicates a malfunction in:
•The ABS; or
• The brake assist system
Electric power steering system warning light (warning
buzzer)
Indicates a malfunction in the EPS (Electric Power Steering)
system
RX350_270_EE_48D77E.book 544 ページ 2014年1月24日 金曜日 午前10時4分

Page 556 of 652

556
5-2. Steps to take in an emergency
RX350/270_EE
Indicates a malfunction in the cruise control system
or the radar cruise control system (If equipped)
Press the “ON-OFF” button once to deactivate the
system, and then press the button again to reactivate
the system.
(If equipped)
Indicates a malfunction in the automatic headlight
leveling system
Indicates a malfunction in:
• The SRS airbag system; or,
• The seat belt pretensioner system
Indicates a malfunction in:
•The ABS; or,
• The brake assist system
Indicates a malfunction in the EPS (Electric Power
Steering) system
Warning messageDetails
RX350_270_EE_48D77E.book 556 ページ 2014年1月24日 金曜日 午前10時4分

Page 585 of 652

5
585
5-2. Steps to take in an emergency
When trouble arises
RX350/270_EE
CAUTION
■When using the compact spare tire
●Remember that the compact spare tire provided is specifically designed for use
with your vehicle. Do not use your compact spare tire on another vehicle.
●Do not use more than one compact spare tire simultaneously.
●Replace the compact spare tire with a standard tire as soon as possible.
●Avoid sudden acceleration, abrupt steering, sudden braking and shifting opera-
tions that cause sudden engine braking.
■When the compact spare tire is attached
The vehicle speed may not be correctly detected, and the following systems may
not operate correctly:
●ABS & Brake assist
●VSC
●VSC+ (if equipped)
●TRC
●VDIM (if equipped)
●Lexus parking assist-sensor (if equipped)
●Navigation system (if equipped)
●Cruise control (if equipped)
●Dynamic radar cruise control (if equipped)
●Electronically modulated air suspension (if equipped)
●PCS (Pre-Crash Safety system) (if equipped)
Also, not only can the following system not be utilized fully, but it may even nega-
tively affect the drive-train components:
●AWD system (if equipped)
■Speed limit when using the compact spare tire
Do not drive at speeds in excess of 80 km/h (50 mph) when a compact spare tire is
installed on the vehicle.
The compact spare tire is not designed for driving at high speeds. Failure to observe
this precaution may lead to an accident causing death or serious injury.
RX350_270_EE_48D77E.book 585 ページ 2014年1月24日 金曜日 午前10時4分

Page:   < prev 1-10 11-20 21-30 next >