DVD LEXUS RX330 2006 Owner's Manual

AUDIO
327
(c) Selecting a desired track
1Remote control button
2DVD player unit
To select a desired track: Push the “
” or “”
(TUNE/TRACK) button until the number of the track you want
to listen to appears on the screen. If you want to return to the
beginning of the current track, quickly push the “
”
(TUNE/TRACK) button or switch one time.
“Fast forward” button: Push the “
” (TUNE/TRACK) button
and hold it to fast forward the CD. When you release the
button, the CD player will resume playing from that position.
“Reverse” button: Push the “
” (TUNE/TRACK) button and
hold it to reverse the CD. When you release the button, the CD
player will resume playing.
Replacing remote control battery
For replacement, use 3 AA batteries.
CAUTION
Special care should be taken that small children do not
swallow the removed battery or components.
NOTICE
 When replacing the battery, be ca reful not to lose the
components.
 Replace only with the same or equivalent type of
battery recommended by a Lexus dealer.
 Dispose of used batteries according to local
regulations.

AUDIO
329
DVD player operation
The DVD player can play audio CDs, DVD video discs, CD
texts, dtsCDs, DVD audio discs and video CDs.
For appropriate discs for this player, see “Audio/video system
operating hints” on page 373.
The DVD player works when the ignition key is in the “ACC” or
“ON” position.
To turn on the DVD player, a disc must be loaded in the player.
To turn off the player, eject the disc.(a) Inserting the disc
Insert the disc into the slot with the label side up.
If the label faces down, the disc cannot be played. In this case,
“DISC CHECK” appears on the screen.
If a disc which is not playable is inserted, “DISC CHECK” will
also appear on the screen. For appropriate discs for this
player,
see “Audio/video system operating hints” on page 373.

AUDIO
330
The “DISC” indicator light turns on while the disc is loaded.
The player will play the track or chapter, and it will play from the
beginning of the track or chapter again after it reaches the end.
NOTICE
Never try to disassemble or oil any part of the DVD
player. Do not insert anything other than a disc into the
slot.
8 cm (3 in.) CD singles
Your player does not need an adaptor to play CD singles. CD
singles are about 8 cm (3 in.) in diameter−smaller than
standard discs.
NOTICE
Do not use an adaptor for CD singles — it could cause
tracking errors or interfere with the ejection of CDs.

AUDIO
331
(b) Ejecting the disc
Push the “” (eject) button.
(c) Selecting the DVD mode1Remote control button
2Mode selection screen
To select the DVD mode, push the “DVD” button on the
remote control.
You can also select the DVD mode on the mode selection
screen mentioned above.
“DVD” appears on the screen.

AUDIO
332
The “DVD Hint!” screen appears when the DVD mode is
first selected after you turn the ignition key to the “ACC”
or “ON” position.
Push the “OK” switch when you read the message.(d) DVD player operation switches
The DVD player can be operated with the remote control
buttons directly.

AUDIO
333
1Remote control button
2DVD player unit
The player can also be operated with the switches on the
screen.
To operate the switches on the screen, select the switch by the
joy stick and push the “ENT” button. You cannot select the
switches on the screen by touching them directly.
When the switch is selected by the joy stick, the outline of the
switch changes to blue. Push the “ENT” button, and the switch
will be highlighted in green. (e) Turning the operation switches on and off1Remote control button
2DVD player unit
To turn on the operation switches, push the “CURSOR”
button on the remote control.

AUDIO
334
1Page 1 (DVD video operation switch)2Page 2 (DVD video operation switch)
3Page 1 (DVD audio operation switch)4Page 2 (DVD audio operation switch)
5Page 1 (video CD)6Page 2 (video CD)

AUDIO
336
1Screen switch2Remote control button
3DVD player unit
To turn off the switches on the screen, push the
“CURSOR” button once again or push the “Hide Buttons”
on the screen.

AUDIO
337
DVD video/DVD audio player operation
NOTE: The playback condition of some DVD discs may be
determined by a DVD software producer . This DVD player
plays a disc as the software producer intended. So, some
functions may not work properly. Be sure to read the
instruction manual for the DVD disc separately provided.
For the detailed information about DVD video discs, see
“DVD video disc information” on page 366.
Precautions for DVD video discs
When recording on a DVD video, DVD audio, video CD or
audio tracks may not record in some cases while the menu is
displayed. As audio will not play in this case, verify that the
video tracks are playing and then activate playback.
When playback of a disc is completed:
 If an audio CD is playing, the first track starts.
 If a DVD video, DVD audio or video CD is playing, playback
will stop or the menu screen will be displayed.
The title/chapter number and playback time display may not
appear while playing back certain DVD video discs.CAUTION
Conversational speech on some DVDs is recorded at a
low volume to emphasize the impact of sound effects.
If you adjust the volume assuming that the
conversations represent the maximum volume level
available for the DVD, you may be startled by louder
sound effects or when you change to a different audio
source. Loud sounds may have a significant impact on
the human body or pose a driving hazard. Keep this in
mind when you adjust the volume.

AUDIO
338(a) Turning the menu screen for the disc on or off
1For DVD video2For DVD audio
3Remote control button
DVD video: To turn on the menu screen for the disc, push
the “Top Menu” or “Menu” switch on the screen, or the
“MENU” or “TOP MENU” button on the remote control.
DVD audio: To turn on the menu screen for the disc, push
the “Top Menu” switch on the screen or the “TOP MENU”
button on the remote control.
For the operation of the menu screen, see the separate manual
for the DVD disc.
To turn on the selecting switch, push the “” switch.