CD changer LEXUS RX330 2006 Owners Manual

SECTION 2 – 2
261
AIR CONDITIONING AND AUDIO
Audio
Audio system (with single−CD player) 262
. . . . . . . . . . . . . . . . . . . . . .
Audio system (with six− CD changer) 282
. . . . . . . . . . . . . . . . . . . . . . .
Audio remote controls 304
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Rear seat entertainment system 306
. . . . . . . . . . . . . . . . . . . . . . . . . . .
Audio/video system operating hints 373
. . . . . . . . . . . . . . . . . . . . . . . . .

AUDIO
269
(e) Your CD player
When you insert a
CD, gently push it in with the label face up.
(The player will automatically eject a CD if the label face is
down.) The CD player will play from track 1 through the end
of the CD. Then it will play from track 1 again. On models with
the CD auto changer, next CD will be played from track 1.
NOTICE
Never try to disassemble or oil any part of the CD player.
Do not insert anything other than CD into the slot.
The player is intended for use with 12 cm (4.7 in.) CDs only.
Radio operation
(a) Listening to the radio
Push these buttons to choose either an AM or FM station.
“AM”, “FM1”, “FM2” or “FM TYPE” appears on the d\
isplay.

AUDIO
282
AUDIO SYSTEM (with sixCD changer)
Quick reference for your audio system
You can adjust the brightness of the display. See “Instrument panel light control” on page 90 for details.
If a Mark Levinson brand audio system is installed, the “Mark Levinso\
n” logo is shown on the panel.

AUDIO
288(e) Your CD player with changer
Your CD player with changer can store up to 6 CDs and play
selected
CDs or continuously play all the CDs set in the player.
When you set CDs into the player, make sure their labels face
up. If not, the player will display “ERROR 1” and the CD
number.
NOTICE
 Do not stack up two CDs for insertion, or it will cause
damage to the CD changer. Insert only one CD into
slot at a time.
 Never try to disassemble or oil any part of the CD
player. Do not insert anything other than CDs into the
slot.
The player is intended for use with 12 cm (4.7 in.) CDs only.

AUDIO
297
CD player operation
(a) Inserting or ejecting CDs
The ignition switch must be in the “ACC” or “ON” position.
Your CD player with changer can store up to 6 CDs.
Setting a single CD:
1. Push the “LOAD” button briefly.
The umber indicators at both ends of the slot start blinking and
“WAIT” appears on the display. After the blinking indicators
change to green and stay on, and “WAIT” changes to the
“LOAD”, the CD door opens. 2. Insert only one CD while the CD door is open.
You can set a CD at the lowest empty CD number.
After insertion, the set CD is automatically loaded.
If the label faces down, the CD cannot be played. In this case,
“ERROR 1” and CD number appear on the display.
If you need to insert the next CD, repeat the same procedure
to insert another CD.

Setting all the CDs:
1. Push the “LOAD” button until you hear a beep.
The umber indicators at both ends of the slot start blinking and
“WAIT” appears on the display. After the blinking indicators
change to green and stay on, and “WAIT” changes to the
“LOAD”, the CD door opens.
2. Insert only one CD while the CD door is open.
The CD door closes and “WAIT” appears again.
3. Insert the next CD after the “WAIT” changes to the
“LOAD” and the CD door opens.
4. Repeat this procedure until you insert all the CDs.
To cancel the operation, push the “LOAD” or “DISC” button.
If you do not insert CDs within 15 seconds after pushing the
“LOAD” button and “LOAD” is displayed, the operation will be
canceled automatically.

AUDIO
300(d) Searching for a desired track or CD
Searching for a desired track:
Push the “SCAN” button briefly. “SCAN” will appear on the
display.
The CD player will play the next track for 10 seconds,
then scan again. To select a track, push the “SCAN” button a
second time. If the player reaches the end of the CD, it will
continue scanning at track 1.
After all the tracks are scanned in one pass, normal play
resumes. Searching for a desired CD:
Push
the “SCAN” button until you hear a beep. With “
”
on the display, the program at the beginning of each CD will be
played for 10 seconds. To continue listening to the program of
your choice, push the button a second time.
After all the CDs in the automatic changer are scanned in one
pass, the scan function is cancelled.

AUDIO
302(g) Random playing
“RAND” button: There are 2 random features — you can
either
listen to the tracks on all the CDs in the player in random
order, or only listen to the tracks on a specific CD in random
order.
Random playing for the tracks on a CD: Push the “RAND”
button briefly. “
” will appear on the display and play
the CD you are listening to in random order. Random playing for all the tracks in the automatic
changer:
Push the “RAND” button and hold it until you hear a
beep. “
” will appear on the display and the player will
perform all the tracks on all the CDs in the changer in random
order. To turn off the random feature, push “RAND” a second
time.
When a track is skipped or the system is inoperative, push the
button to reset.

AUDIO
305
“
+” switches: Use these switches to adjust the volume.
To increase the volume, push the “+”. To decrease the volume,
push the “–”. The volume continues to increase or decrease
while the switch is being pressed.
(a) When the radio mode is selected
“
” or “” switch: Use these switches for seek tuning or to
select a preset station.
 To select a preset station, push this switch briefly. The
station you assigned to a switch on the audio system will be
selected.
 To seek a station, push and hold this switch until you hear
a beep. The radio will begin seeking up or down for a station,
and will stop on reception.
(b) When the “TAPE” mode is selected
“
” or “” switch: Use these switches to fast forward or
rewind the tape or for automatic program selection.
 To skip forward or reward for automatic program selection,
push this switch briefly. When automatically selecting a
program, you can skip up to 9 programs at a time. See page
276 or 296 for details.
 To fast forward or rewind the tape, push this switch until you
hear a beep. To stop fast forwarding or rewinding, push the
same side on the switch briefly. (c) When the “CD” mode is selected
“
” or “” switch: Use this switch to select a desired track.
Push this switch briefly, to select a desired track.
With a CD changer only —
“
” or “” switch: Use this switch to select a desired track
or CD.
 To select a desired track, push this switch briefly.
 To select a desired CD, push and hold this switch until the
desired number of the CD appears and you hear a beep.
Vehicles with rear seat entertainment system —
While the DVD player is in operation, the chapter or track can
be changed by pushing the “ ” or “” side of the switch.
CAUTION
Operate the switches with due care while you are
driving to avoid accidents.

AUDIO
316CD or DVD
mode: Use this switch to fast forward/rewind a disc
or select a desired track (“CD” mode)/chapter·track (“DVD\
”
mode).
 To select a desired track (“CD” mode) or chapter/track
(“DVD” mode), push this switch briefly.
 To fast forward or rewind a disc, push and hold this switch
until you hear a beep. To stop fast forwarding or rewinding,
push and hold the same side of the switch until you hear a
beep.
4“DISC/CH/PROG” switch: Use this switch to select a
preset station (radio mode), reverse side of a tape
(“TAPE” mode) or a desired CD (“CD” mode).
Radio mode: Push this switch to select a preset station. The
station you assigned to that particular switch on the audio
system will be selected.
“TAPE” mode: Push this switch to select the reverse side of
a cassette tape.
“CD” mode: Push this switch to select a desired CD (for a CD
changer only). Push until the desired CD number appears.
5“CURSOR (REMOTE)” switch: Use this switch to
display the DVD control switches or to locate the remote
control when you lose sight of the remote control.
6Joy stick and “ENT” switch: Use this joy stick to select
a control switch, mode switch on the screen or the menu
for a disc. Push the “ENT” switch to input the selected
switch or menu.
7“DISC” indicator light: This light indicates that the disc
is loaded.

AUDIO
317
Using your audio system: some basics
The following instructions are for the rear passengers.
Please let the rear passengers read and follow the
instructions when the rear passengers use the rear seat
entertainment system.
This section describes some of the basic features of the rear
seat entertainment system. Some information may not pertain
to your system.
Your audio system adjusts to the optimum volume and tone
quality automatically. While the system is adjusting the audio
sound, the audio sound fades out and then fades in.
The rear seat entertainment system is designed for the rear
passengers to enjoy audio and DVD video separately from the
front audio system.
The rear seat entertainment system can be operated when the
ignition key is in the “ACC” or “ON” position.
The rear passengers can enjoy all modes (AM and FM radio,
cassette tape player, CD player with changer and DVD player)
on the rear seat entertainment system only if a cassette tape
and a CD are loaded in the front audio system.
The rear seat entertainment system can play DVD video, audio
CD, video CD, CD text, dts −CD or DVD audio only when a disc
is loaded in the DVD player. You can enjoy videos and sound when your personal audio
system is connected to the input terminal adapter. For details,
refer to the manufacturer’s instructions.
You can enjoy the rear seat entertainment system with
commercial
headphone. See “Headphone jacks” on page 371
in this Section for details.
You can also enjoy the rear seat entertainment system with a
wireless headphone. The wireless headphone can be used
within rear seat. If the signal becomes weak, the headphone
will mute. For details, refer to the manufacturer’s instructions.
With some wireless headphone generally available in the
market, it may be difficult to catch sound properly. Lexus
recommends the use of Lexus genuine wireless headphone.
You can purchase a wireless headphone at a Lexus dealer.