LEXUS SC400 1991 Service Repair Manual
Page 2651 of 4087
Location of Connectors in Engine Compartment (Cont'd)
TR±40±
ENGINE TROUBLESHOOTING Location of Connectors
WhereEverybodyKnowsYourName
Page 2652 of 4087
±
ENGINE TROUBLESHOOTING Locations of ConnectorsTR±41
WhereEverybodyKnowsYourName
Page 2653 of 4087
Location of Connectors in Instrument Panel
TR±42±
ENGINE TROUBLESHOOTING Locations of Connectors
WhereEverybodyKnowsYourName
Page 2654 of 4087
±
ENGINE TROUBLESHOOTING Locations of ConnectorsTR±43
WhereEverybodyKnowsYourName
Page 2655 of 4087
Location of Connectors in Instrument Panel (Cont'd)
TR±44±
ENGINE TROUBLESHOOTING Locations of Connectors
WhereEverybodyKnowsYourName
Page 2656 of 4087
±
ENGINE TROUBLESHOOTING Locations of ConnectorsTR±45
WhereEverybodyKnowsYourName
Page 2657 of 4087
Location of Connectors in Body
TR±46±
ENGINE TROUBLESHOOTING Locations of Connectors
WhereEverybodyKnowsYourName
Page 2658 of 4087
±MEMO ±
±
ENGINE TROUBLESHOOTINGTR±47
WhereEverybodyKnowsYourName
Page 2659 of 4087
CIRCUIT INSPECTIONDiag. Code 12
RPM Signal Circuit (No.1)
CIRCUIT DESCRIPTION
Cam position sensors (G1 and G2 signals) and engine speed sensor (NE sig\
nal) consist of a signal plate
and a pick up coil.
The G1, G2 signal plates have one tooth each on its outer circumference and\
are mounted on the left and
right bank camshafts.
When the camshafts rotate, the protrusion on the signal plate and the air gap on the pick up coil change,
causing fluctuations in the magnetic field and generating an electromotive forc\
e in the pick up coil.
The NE signal plate has 12 teeth and is mounted on the crankshaft. The NE s\
ignal sensor generates 12
NE signals per engine revolution. The ECU detects the standard crankshaf\
t angle based on the G1, G2
signals, and the actual crankshaft angle and the engine speed by the NE \
signals.
Code No.Diagnostic Code Detecting ConditionTrouble Area
wOpen or short in engine speed sensor, No. 1,w Oen or short in engine s eed sensor, No. 1,
No. 2 cam position sensor circuit
12No ºNEº or ºG1º and ºG2º signal to ECU
No. 2 cam osition sensor circuit
w Engine speed sensor12No NE or G1 and G2 signal to ECU
within 2 sec. after cranking.
wEngine s eed sensor
wNo. 1, No. 2 cam position sensorgNo. 1, No. 2 cam osition sensor
wStarter
wECU
TR±48±
ENGINE TROUBLESHOOTING Circuit Inspection
WhereEverybodyKnowsYourName
Page 2660 of 4087
DIAGNOSTIC CHART
WIRING DIAGRAM
±
ENGINE TROUBLESHOOTING Circuit InspectionTR±49
WhereEverybodyKnowsYourName