bulb MAZDA MODEL 3 HATCHBACK 2018 (in English) User Guide

5. Disconnect the bulb by pulling it out.Rear turn signal lights, Brake lights/
Taillights/Rear side-marker lights
(Bulb type)

6. Install the new bulb in the reverseorder of the removal procedure.
7. Insert the cover tabs and install the cover.
Tabs
NOTE
Verify that the cover is securely
installed.
(Right side)
1. Make sure the ignition is switched off,and the headligh t switch is off.
2. Turn the knob and remove the cover.
3. Turn the wing bolt and jack screw
counterclockwise.

4. Remove the jack
5. Turn the socket and bulb assemblycounterclockwise and remove it.
Maintenance and Care
Owner Maintenance
6-50
Mazda3_8GE4-EA-17F_Edition1 2017-4-7 11:59:21

Rear turn signal lights

Brake lights/Taillights/Rear
side-marker lights (Bulb type)

6. Disconnect the connector from the unitby pressing the tab on the connector
with your finger and pulling the
connector.
Rear turn signal lights

Brake lights/Taillights/Rear
side-marker ligh ts (Bulb type)

7. Disconnect the bulb by pulling it out. Rear turn signal lights, Brake lights/
Taillights/Rear side-marker lights
(Bulb type)

8. Install the new bulb.
9. Insert the wing bolt into the jack with
the jack screw pointing to the down
and turn the wing bolt clockwise to
temporarily tighten it.
Maintenance and Care
Owner Maintenance
6-51
Mazda3_8GE4-EA-17F_Edition1 2017-4-7 11:59:21

10. Turn the jack screw in the directionshown in the figure.

11. Turn the wing bolt completely tosecure the jack.
NOTE
If the jack is not completely secured, it
could rattle while driving. Make sure
the jack screw is sufficiently tightened.
12. Install the cover in the reverse order of the removal procedure.
13. Insert the cover tabs and install the cover.
Tabs
NOTE
Verify that the cover is securely
installed.
Reverse lights
4–Door
1. Make sure the ignition is switched off,
and the headligh t switch is off.
2. Pull the center of each plastic retainer
and remove the retainers.
3. Peel back the trunk lid trim.

Removal
Installation
4. Disconnect the electrical connectorfrom the bulb by pressing the tab on
the connector with your finger and
pulling the connector.

5. Turn the socket and bulb assemblycounterclockwise and remove it.
Maintenance and Care
Owner Maintenance
6-52
Mazda3_8GE4-EA-17F_Edition1 2017-4-7 11:59:21

6. Disconnect the bulb from the socket.
7. Install the new bulb in the reverseorder of the removal procedure.
5–Door
1. Make sure the ignition is switched off, and the headlight switch is off.
2. Remove the cover.

3. Disconnect the electrical connectorfrom the bulb by pressing the tab on
the connector with your finger and
pulling the connector.

4. Turn the socket and bulb assemblycounterclockwise and remove it.
5. Disconnect the bulb from the socket.

6. Install the new bulb in the reverseorder of the removal procedure.
Maintenance and Care
Owner Maintenance
6-53
Mazda3_8GE4-EA-17F_Edition1 2017-4-7 11:59:21

License plate lights
4–Door
1. Make sure the ignition is switched off,and the headlight switch is off.
2. Pull the center of each plastic retainer
and remove the retainers.
3. Peel back the trunk lid trim.

Removal
Installation
4. Disconnect the connector from the unit by pressing the tab on the connector
with your finger and pulling the
connector.

5. Turn the socket and bulb assembly
counterclockwise and remove it.
6. Disconnect the bulb from the socket.
7. Install the new bulb in the reverseorder of the removal procedure.
5–Door
1. Make sure the ignition is switched off, and the headligh t switch is off.
2. Wrap a flathead screwdriver with a
soft cloth to prevent damage to the
lens, and then remove the lens by
carefully prying on the edge of the lens
with a flathead screwdriver.
3. Disconnect the bulb by pulling it out.
4. Install the new bulb in the reverse
order of the removal procedure.
Maintenance and Care
Owner Maintenance
6-54
Mazda3_8GE4-EA-17F_Edition1 2017-4-7 11:59:21

▼Replacing Interior Light Bulbs
Overhead lights (F
ront)/Map lights*,
Overhead lights (Front)*, Overhead
lights (Rear)*, Vanity mirror lights*
1. Wrap a small flathead screwdriver with
a soft cloth to prevent damage to the
lens, and then remove the lens by
carefully prying on the edge of the lens
with the flathead screwdriver.
2. Disconnect the bulb by pulling it out.
Overhead lights (F ront)/Map lights
*


Overhead lights (Front)*

Edge
Overhead lights (Rear)*

Edge
Vanity mirror lights*

3. Install the new bulb in the reverse
order of the removal procedure.
Maintenance and Care
Owner Maintenance
*Some models.6-55
Mazda3_8GE4-EA-17F_Edition1 2017-4-7 11:59:21

Trunk light (4–Door)
1. Press both sides of the lens cap to
remove it.
2. Disconnect the bulb by pulling it out.
3. Install the new bulb in the reverseorder of the removal procedure.
Luggage compartment light (5–Door)
1. Wrap a small flathead screwdriver with a soft cloth to prevent damage to the
lens and remove the lens by carefully
prying on the edge of the lens with the
flathead screwdriver.

2. Disconnect the connector from the unit
by pressing the tab on the connector
with your finger and pulling the
connector.

3. Disconnect the bulb by pulling it out.
4. Install the new bulb in the reverseorder of the removal procedure.
Maintenance and Care
Owner Maintenance
6-56
Mazda3_8GE4-EA-17F_Edition1 2017-4-7 11:59:21

SKYACTIV-G 2.5
ItemWeight
GVW (Gross Vehicle Weight) Total
1,865 kg (4,112 lbs)
Front 970 kg (2,138 lbs)
Rear 895 kg (1,973 lbs)
GAW (Permissible axle load) Front
995 kg (2,194 lbs)
Rear 945 kg (2,083 lbs)
▼Air Conditioner
The type of refrigerant used is indicated on a label attached t
o the inside of the engine com-
partment. Check the label before recharging the refrigerant. Refer to Climate Control Sys-
tem on page 5-2.
Item Classification
Refrigerant Type HFC134a (R-134a)
▼Light Bulbs
Exterior light
Light bulb Category
Wat t a ge UNECE*1 (SAE)
Headlights Halogen
High beam 65 HB3 (9005)
Low beam
55H11 (H11)
LED High/Low beam
LED
*2― (―)
Daytime running lights With halogen bulb headlights 65 HB3 (9005)
With LED headlights
LED
*2― (―)
Parking lights (Front side-marker
lights) With halogen bulb headlights 5 WY5W (―)
Front side-marker lights With LED headlights LED
*2― (―)
Parking lights With LED headlights LED
*2― (―)
Front turn signal lights 21 WY21W (7443NA)
Fog lights
*LED*2― (―)
Side turn signal lights
*LED*2― (―)
High-mount brake light LED
*2― (―)
Rear turn signal lights 21 WY21W (7443NA)
Brake lights/Taillights/Rear
side-marker lights LED type
LED
*2― (―)
Bulb type 21/5 W21/5W (7443)
Taillights (Liftgate side/Trunk lid side)
*LED*2― (―)
Specifications
Specifications
*Some models.9-9
Mazda3_8GE4-EA-17F_Edition1 2017-4-7 11:59:21

Light bulbCategory
Wa t t ag e UNECE*1 (SAE)
Reverse lights 4–Door 18 W16W (921)
5–Door 21 W21W (7440)
License plate lights 5 W5W (―)
*1 UNECE stands for United Nations Economic Commission for Europe.*2 LED is the abbreviation for Light Emitting Diode.
Interior light
Light bulb Category
Wat tage UNECE*1
Trunk light (4–Door) 3―
Luggage compartment light (5–Door) 5―
Overhead lights (Front)/Map lights
*8―
Overhead light (Front)
*10 ―
Overhead light (Rear)
*10 ―
Vanity mirror lights
*2―
*1 UNECE stands for United Nations Economic Commission for Europe.
▼Tires
NOTE
The tires have been optimally matched with the chassis of your vehicle.
When replacing tires, Mazda recommends that you replace tires of the same type originally
fitted to your vehicle. For details, contact an Authorized Mazda Dealer.
Check the tire pressure label fo
r tire size and inflation pressure.
Refer to Tire Inflation Pressure on page 6-38.
After adjusting the tire pressur e, initialization of the tire pressure monitoring system is
necessary to make the system operates normally.
Refer to Tire Pressure Monitorin g System Initialization on page 4-148.
Standard tire
(U.S.A. and Canada)
Tire size Inflation pressure
Front Rear
P205/60R16 91H 250 kPa (36 psi)250 kPa (36 psi)
215/45R18 89W 250 kPa (36 psi)250 kPa (36 psi)
Specifications
Specifications
9-10*Some models.
Mazda3_8GE4-EA-17F_Edition1 2017-4-7 11:59:21

Index
When liftgate/trunk lid cannot be
opened..........................................7-43
Lighting Control................................4-43
Lights-on reminder............................7-38
Light Bulbs Replacement................................ 6-42
Specifications.................................9-9
Lubricant Quality................................ 9-4
Luggage Compartment.. ..................5-138
Luggage Compartment Light.......... 5-130
M
Maintenance
Information.................................... 6-2
Scheduled.......................................6-4
Maintenance Monitor........................ 6-16
Manual Transaxle Operation............. 4-29
Map Lights...................................... 5-130
Mazda Radar Cruise Control
(MRCC)...........................................4-102 Close proximity warning........... 4-104
Cruise control function.............. 4-110
Display indication......................4-104
Setting the system..................... 4-104
Shift-up/shift-down request
display........................................ 4-110
Mazda Radar Cruise Control (MRCC)
System warnings............................... 7-41
Meters and Gauges............................4-12
Mirrors Outside mirrors............................ 3-32
Rearview mirror.......................... 3-33
Mirror Defogger.......... ...................... 4-54
Moonroof...........................................3-38
O
Odometer and Trip Meter................. 4-13
Outside Mirrors................................. 3-32
Outside Temperature Display............4-17
Overhead Console........................... 5-136
Overhead Lights......... ..................... 5-130
Overheating....................................... 7-20
Overloading....................................... 3-50
Over Rev. buzzer...............................7-41
Owner Maintenance Closing the Hood.........................6-21
Engine Compartment
Overview..................................... 6-22
Key battery replacement..............6-35
Opening the Hood....................... 6-20
Owner Maintenance
Precautions...................................6-18
P
Parking Brake....................................4-61
Personalization Features................... 9-12
Power Steering.................................. 4-76
Power steering warning buzzer......... 7-41
Power Windows................................ 3-35
R
Radar Sensors (Rear)...................... 4-139
Radar Sensor (Front).......................4-136
Rearview Mirror................................3-33
Rear Coat Hooks......... .................... 5-138
Rear Cross Traffic Alert (RCTA)...... 4-98
Rear Door Child Safet y Locks.......... 3-19
Rear Seat............................................. 2-7
Rear View Monitor......................... 4-150
Displayable range on the
screen......................................... 4-152
Picture quality adjustment......... 4-158
Rear view monitor operation..... 4-154
Rear view parking camera
location...................................... 4-151
Switching to the rear view monitor
display........................................4-151
Variance between actual road
conditions and displayed
Image......................................... 4-156
10-6
Mazda3_8GE4-EA-17F_Edition1 2017-4-7 11:59:21