Reverse MAZDA MODEL 6 2009 (in English) Owner's Manual

Black plate (385,1)
Brake lights/Taillights (Rear sidemarker lights)
With LED bulb
Due to the complexity and difficulty of
the procedure, the LED bulbs should be
replaced by an Authorized Mazda Dealer.
NOTE
LED bulb replacement is not possible. The
rear combination component must be replaced.
With Non-LED bulb
1. 1.Pull the center section of the plasticretainer and remove the retainers and
partially open the trunk side trim.
Removal
Installation
2. Turn the socket and bulb assemblycounterclockwise and remove it.
3. Disconnect the bulb from the socket.
4. Install the new bulb in the reverse order of removal.
NOTE
To replace the bulb, contact an Authorized
Mazda Dealer.
Rear turn signal lights
1. Pull the center section of the plastic retainer and remove the retainers and
partially open the trunk side trim.
Removal
Installation
2. Turn the socket and bulb assembly
counterclockwise and remove it.
3. Disconnect the bulb from the socket.
4. Install the new bulb in the reverse order of removal.
Maintenance and Care
Owner Maintenance
8-43
Mazda6_8Z64-EA-08H_Edition1 Page385
Wednesday, June 25 2008 10:5 AM
Form No.8Z64-EA-08H

Black plate (386,1)
NOTETo replace the bulb, contact an Authorized
Mazda Dealer.
Reverse lights
1. Pull the center section of the plasticretainer and remove the retainers, then
partially peel back the trunk rear trim.
Removal
Installation
2. Turn the socket and bulb assemblycounterclockwise and remove it.
3. Disconnect the bulb from the socket.
4. Install the new bulb in the reverse order of removal.
License plate lights
1. Pull the center section of the plasticretainer and remove the retainers, then
partially peel back the trunk rear trim.
Removal
Installation
2. Turn the socket and bulb assembly
counterclockwise and remove it.
3. Disconnect the bulb from the socket.
4. Install the new bulb in the reverse order of removal.
8-44
Maintenance and Care
Owner Maintenance
Mazda6_8Z64-EA-08H_Edition1 Page386
Wednesday, June 25 2008 10:5 AM
Form No.8Z64-EA-08H

Black plate (387,1)
qReplacing Interior Light Bulbs
Overhead light/Map light (Front),Overhead light (Rear), Courtesy lights,Vanity mirror lights
1. Wrap a small flathead screwdriver with
a soft cloth to prevent damage to the
lens and remove the lens by carefully
prying on the edge of the lens with the
flathead screwdriver.
2. Disconnect the bulb by pulling it out.
Overhead light/Map light (Front)
Overhead light (Rear)
Edge
Courtesy lights
Vanity mirror lights
3. Install the new bulb in the reverse order of removal.
Trunk light
1. Press both sides of the lens cap toremove it.
Maintenance and Care
Owner Maintenance
8-45
Mazda6_8Z64-EA-08H_Edition1 Page387
Wednesday, June 25 2008 10:5 AM
Form No.8Z64-EA-08H

Black plate (388,1)
2. Disconnect the bulb by pulling it out.
3. Install the new bulb in the reverse orderof removal.
Fuses
Your vehicle's electrical system is
protected by fuses.
If any lights, accessories, or controls don't
work, inspect the appropriate circuit
protector. If a fuse has blown, the inside
element will be melted.
If the same fuse blows again, avoid using
that system and consult an Authorized
Mazda Dealer as soon as possible.
qFuse Replacement
Replacing the fuses on the driver's sidekick-panel
If the electrical system does not work,
first inspect the fuses on the driver's side
kick-panel.
1. Turn off the ignition switch and other
switches.
2. Open the fuse panel cover by sliding the cover straight back toward you.
CAUTION
Pulling the cover off sideways may
break the retaining tabs off.
8-46
Maintenance and Care
Owner Maintenance
Mazda6_8Z64-EA-08H_Edition1 Page388
Wednesday, June 25 2008 10:5 AM
Form No.8Z64-EA-08H

Black plate (452,1)
Automatic transaxleItem Weight
GVWR (Gross Vehicle Weight Rating) 1,996 kg (4,400 lb)
GAWR (Gross Axle Weight Rating) Front
1,066 kg (2,350 lb)
Rear 934 kg (2,059 lb)
3.7-liter engine
Item Weight
GVWR (Gross Vehicle Weight Rating) 2,082 kg (4,590 lb)
GAWR (Gross Axle Weight Rating) Front
1,140 kg (2,513 lb)
Rear 943 kg (2,079 lb)
qAir Conditioner
Item Classification
Refrigerant Type HFC134a (R-134a)
qLight Bulbs
Exterior light
Light bulb Category
Wattage ECE R (SAE)
Headlights High beam
65H9 (H9)
Low beam Halogen
55H7 (H7)
Xenon fusion 35D2S (D2S)
Front turn signal lights/Parking lights 28/8―(#7444NA)
Fog lights
í55 H11 (H11)
Front side-marker lights 4.9―(#168)
High-mount brake light LED
*1―(― )
Rear turn signal lights 26.9―(#3757A)
Brake lights/Taillights (Rear side-marker lights) 26.9/6.7
―(#3057A)
LED
*1― (― )
Reverse lights 17.9W16W (#921)
License plate lights 4.8―(t94)
Ground illumination light
í5.5 ―(― )
*1 LED is the abbreviation for Light Emitting Diode.
10-6íSome models.
Specifications
Mazda6_8Z64-EA-08H_Edition1 Page452
Wednesday, June 25 2008 10:6 AM
Form No.8Z64-EA-08H