Rc low MAZDA MODEL 626 2002 Repair Manual

5-26
Driving Your Mazda
Warning/Indicator Lights and Beeps
Form No. 8Q50-EA-01G





Charging System Warning Light
This warning light indicates a malfunction
of the alternator or of the charging system.
If the light comes on while driving:
1. Drive to the side of the road and park
off the right-of-way.
2. Turn off the engine. Inspect the alternator drive belt for looseness and
breakage.
3. If it ’s OK, the charging system has a
problem. Consult an Authorized
Mazda Dealer as soon as possible.





Engine Oil Pressure Warning
Light
This warning light indicates low engine
oil pressure.
If the light comes on while driving:
1. Drive to the side of the road and park
off the right-of-way.
2. Turn off the engine and inspect the engine oil level (page 8-11). If it ’s low,
add oil.
3. Check the light.
If the light remains on even after you add
oil, have your vehicle towed to the nearest
service station or to an Authorized Mazda
Dealer.
Don
’t drive with a loose or broken
alternator belt. The engine could
overheat because this belt also drives
the water pump.
CAUTION
Don ’t run the engine if oil pressure is
low. It could result in extensive engine
damage.
CAUTION
J94S.book Page 26 Saturday, June 23, 2001 1:04 PM

5-27
Driving Your Mazda
Warning/Indicator Lights and Beeps
Form No. 8Q50-EA-01G





TCS Warning Light
This warning light stays on for a few
seconds when the ignition switch is turned
to the ON position. It flashes when the
system regulates engine torque.
If the light stays on, take your vehicle to
an Authorized Mazda Dealer. The traction
control system may have a malfunction.





Low Fuel Warning Light
This warning light in the fuel gauge
signals that the fuel tank will soon be
empty.
Get fuel as soon as possible.





Low Washer Fluid Level
Warning Light
This warning light reveals that little
windshield washer fluid remains. Add
fluid (page 8-20).





Check Engine Light
If this light comes on while driving, the
vehicle may have a problem. It is
important to note the driving conditions
when the light came on and consult an
Authorized Mazda Dealer.
The check engine light may come on in
the following cases:
• The fuel tank level being very low or
approaching empty.
• The engine ’s electrical system has a
problem.
• The emission control system has a
problem.
• The fuel-filler cap is missing or not
tightened securely.
NOTE
•In addition to the TCS warning light
flashing, a slight lugging sound will
come from the engine. This
indicates that the traction control
system is operating properly.
• On slippery surfaces, such as fresh
snow, it will be impossible to
achieve high rpm when the traction
control system is on.
J94S.book Page 27 Saturday, June 23, 2001 1:04 PM

5-32
Driving Your Mazda
Form No. 8Q50-EA-01G
Switches and Controls





Headlights
To turn on the lights, turn the knob on the
end of the control lever.





Lights-On Reminder
If lights are on and the key is removed
from the ignition switch, a beep will
sound when any door is opened.





Headlight High-Low Beam
Push the lever forward for high beams.
Pull it back for low.





Flashing the Headlights
To flash the headlights, pull the lever fully
toward you. The headlight switch need
not be on, and the lever will return to the
normal position when released.
Lighting Control
Lever Position OFF
Headlights Off Off OnTaillights
Parking lights
License lights
Side-marker lights Off On On
NOTE
•
If the light switch is left on, the
lights will automatically switch off
30 seconds after turning the ignition
switch to the LOCK position or
removing the key.
The lights will automatically switch
back on when the ignition switch is
turned to the ACC or ON position.
• To prevent discharging the battery,
don ’t leave the lights on while the
engine is off.
Low beams High beams
J94S.book Page 32 Saturday, June 23, 2001 1:04 PM

6-2
Interior Comfort
Form No. 8Q50-EA-01G
Climate Control System





Operating the Climate Control
System
Operate the climate control system with
the engine running.





Clearing the Air Inlet
Clear all obstructions like leaves, snow
and ice from the hood and the air inlet in
the cowling grille to improve the system
efficiency.





Foggy Windows
The windows may fog up easily in humid
weather. Use the climate control system to
defog the windows.
To help defog the windows, operate the
air conditioner to dehumidify the air.





Outside/Recirculated Air
Position
Use the outside air position in normal
conditions. The recirculated air position
can be used temporarily when driving on
dusty roads or for quick cooling of the
interior.





Parking in Direct Sunlight
If the vehicle has been parked in direct
sunlight during hot weather, open the
windows to let warm air escape, then run
the climate control system.





Not Using for a Long Period
Run the air conditioner at least once a
month to keep internal parts lubricated.





Check the Refrigerant before
Weather Gets Hot
Have the air conditioner checked before
the weather gets hot. Lack of refrigerant
may make the air conditioner less
efficient. Consult an Authorized Mazda
Dealer for refrigerant inspection.
The optional air conditioner is filled with
R134a, a refrigerant that will not damage
the ozone layer.
If the air conditioner is low on refrigerant
or has a malfunction, consult an
Authorized Mazda Dealer.
Operating Tips
J94S.book Page 2 Saturday, June 23, 2001 1:04 PM

6-3
Interior Comfort
Climate Control System
Form No. 8Q50-EA-01G





Adjusting the Vents
Directing airflow
You can direct air flow by moving the adjustment knobs and vents.
Adjusting the amount of airflow
These vents can be opened by rotating the vertical wheels up or closed by rotating them
down.
Ve n t O p e r a t i o n
NOTE
When using the air conditioner, mist may come out from the vents. This is not a sign of
trouble but a result of humid air being suddenly cooled.
Knob Vent
Open
Close
J94S.book Page 3 Saturday, June 23, 2001 1:04 PM

6-4
Interior Comfort
Climate Control System
Form No. 8Q50-EA-01G





Selecting the Airflow Mode
Dashboard and Floor Vents Defroster Vents
Floor Vents Dashboard Vents Defroster and Floor Vents
J94S.book Page 4 Saturday, June 23, 2001 1:04 PM

6-5
Interior Comfort
Climate Control System
Form No. 8Q50-EA-01G





Oscillating Air Vent
The air from the center ventilation vent
can automatically be swung in both right
and left directions.
To turn on, push the switch in.
Another push will turn it off. When the
switch is turned off, the direction of
airflow can manually be adjusted by the
thumb wheel.
NOTE
When the switch is turned on, the vent
always swings even when no air comes
out from the center ventilation.
J94S.book Page 5 Saturday, June 23, 2001 1:04 PM

6-6
Interior Comfort
Climate Control System
Form No. 8Q50-EA-01G





Control Switches
Fan control dial
This dial allows variable fan speeds.
0—Fan off
1—Low speed
2—Medium low speed
3—Medium high speed
4—High speed Temperature control dial
This dial controls temperature of the air
coming through the system. Turn it
clockwise for hot (red) and
counterclockwise for cold (blue).
Manual Type
Fan control dial
Mode selector switch
Mode selector switch
Temperature control dial
Air conditioner switchAir intake selector switch
Hot
Cold
J94S.book Page 6 Saturday, June 23, 2001 1:04 PM

6-7
Interior Comfort
Climate Control System
Form No. 8Q50-EA-01G
Mode selector switch
Press the mode selector switch to select
airflow mode (page 6-4).
Air conditioner switch
Press the switch to turn the air conditioner
on. An indicator light on the switch will
illuminate when the fan switch is on.
Press the switch once again to turn the air
conditioner off.Air intake selector switch
This switch controls the source of air
entering the vehicle.
The switch should be kept in the outside
air position under normal conditions.
Press the switch to alternate between the
two positions. The indicator light
illuminates when the recirculated air
position is selected.
Outside air position
This position is automatically selected
when the ignition switch is turned to the
ON position.
Use it for normal ventilation and heating.
The indicator light is out when the outside
air position is selected.
Recirculated air position
This position recirculates air within the
vehicle. Don
’t use the recirculated air
position for long periods when the vehicle
is stopped.
The indicator light is on when the
recirculated air position is selected.
NOTE
The air conditioner may not function
when the outside temperature
approaches 0 ° C (32 °F).
J94S.book Page 7 Saturday, June 23, 2001 1:04 PM

6-13
Interior Comfort
Audio System
Form No. 8Q50-EA-01G
Strong signal noise
This occurs very close to a transmitter
tower. The broadcast signals are
extremely strong, so the result is noise and
sound breakup at the radio receiver.
Station drift noise
When a vehicle reaches the area of two
strong stations broadcasting at similar
frequencies, the original station may be
temporarily lost and the second station
picked up. At this time there will be some
noise from this disturbance.




Operating Tips for Cassette Tape
Player
Cleaning the cassette tape player
The tape head, capstans, and pinch rollers
will gather oxide residue from cassette
tapes. This can cause weak or wavering
sounds and damage to the cassette tapes
and player. Use a good quality head-
cleaning tape or a liquid cleaner cassette
tape to remove it.
Should the unit not operate normally,
consult an Authorized Mazda Dealer.
Never attempt to repair it or insert a
screwdriver or anything else.
Handling the cassette tape player
The following precautions should be
observed.
• Do not spill any liquid on the audio
system.
• Do not insert any objects, other than
cassette tape, into the slot.
Station 1
88.1 MHz Station 2
88.3 MHz
J94S.book Page 13 Saturday, June 23, 2001 1:04 PM