MAZDA MODEL MX-30 EV 2022 Owners Manual

If the switch is pressed again, the
parking sensor becomes operational
and the indicator light turns off.
1. Indicator light
NOTE
The detection indicator and buzzer
of the front ultrasonic sensors/front
corner ultrasonic sensors do not
operate when the selector lever is in
the P position.
The detection indicator and buzzer
sound do not activate when the
parking brake is applied.
▼ Obstruction Detection Indication
The position of a sensor which has
detected an obstruction is indicated.
The gauge illuminates in
different areas
depending on the distance to an
obstruction detected by the sensor.
As the vehicle approaches closer to an
obstruction, the zone in the gauge
closer to the vehicle illuminates.
Without 360°view monitor
1. Front ultrasonic sensor gauge*
2. Right front corner ultrasonic sensor
gauge*
3. Right rear corner ultrasonic sensorgauge/Right rear side ultrasonic
sensor gauge
*
4. Rear ultrasonic sensor gauge
5. Left rear corner ultrasonic sensorgauge/Left rear side ultrasonic
sensor gauge
*
6. Left front corner ultrasonic sensor
gauge*
With 360°view monitor
1. Front ultrasonic sensor gauge
2. Right front corner ultrasonic sensorgauge
3. Right rear corner ultrasonic sensor gauge/Right rear side ultrasonic
sensor gauge
*
4. Rear ultrasonic sensor gauge
When Driving
Pa r k i n g S e n s o r Sys te m
4-202*Some models.
MX -30_8JD4-EA -21G_Edition2_new 2021-5-18 14:38:07

5. Left rear corner ultrasonic sensorgauge/Left rear side ultrasonic
sensor gauge
*
6. Left front corner ultrasonic sensor
gauge
NOTE
The detection indicator can be
switched between display and
non-display and the buzzer volume
can be changed.
Refer to the Settings section in the
Mazda Connect Owner's Manual.
(Vehicles with 360° View Monitor)
When the detection indicator is set to
“Display”, even with the 360° view
monitor not displayed, if a front sensor
or a front corner sensor detects an
obstruction, the 360° view monitor
switches automatically to display.
When an obstruction is no longer
detected, the display switches to the
display before the obstruction was
detected. However, while the 360°
view monitor is displayed, it continues
to display no matter if an obstruction is
detected or not.
System problem noti fication
The indication displays if the system
has a malfunction.
Without 360°view monitor
With 360°view monitor
Check the reason for the indication
displaying on the center display or
multi-information display.
Refer to If a Warning Light Turns On or
Flashes on page 7-21.
When Driving
Pa r k i n g S e n s o r Sys te m
*Some models.4-203
MX -30_8JD4-EA -21G_Edition2_new 2021-5-18 14:38:07

▼Parking Sensor Warning Beep
Informs the driver of the ap
proximate distance from the vehicle to the obstruction
using warning beeps depending on the distance. If multiple obstructions are
detected at the same time, warning beeps are activated according to the distance to
the nearest obstruction. The warning beeps are activated as follows while the system
is operating. However, the warning beeps are not activated while the seat belt
reminder is operating.
Front ultrasonic sensor
*, Rear ultrasonic sensor
Distance De-
tection area Distance between vehicle and obstruction
Beeper sound*1Front ultrasonic sensor Rear ultrasonic sensor
Farthest dis- tance Approx. 100
―60.0 cm
(39.3 ―23.6 in)
Approx. 150 ―60.0 cm
(59.0 ―23.6 in)
Slow intermittent
sound
Far distance Approx. 60.0
―45.0 cm
(23.6 ―17.7 in)
Approx. 60.0 ―45.0 cm
(23.6 ―17.7 in)
Medium intermit-
tent sound
Middle dis- tance Approx. 45.0
―35.0 cm
(17.7 ―13.7 in)
Approx. 45.0 ―35.0 cm
(17.7 ―13.7 in)
Fast intermittent
sound
Close distance Within approx. 35.0 cm (13.7
in)
Within approx. 35.0 cm (13.7in)
Continuous
sound
*1 The rate at which the intermittent sound beeps increases as the vehicle approaches the obstruction.
When Driving
Pa r k i n g S e n s o r Sys te m
4-204*Some models.
MX-30_8JD4-EA -21G_Edition2_new 2021-5-18 14:38:07

Front corner ultrasonic sensor*, Rear corner/Rear side* ultrasonic sensor
Distance Detectionarea Distance between vehicle and obstruction
Beeper sound*1Front corner ultrasonic sensor/Rear corner,Rear side ultrasonic sensor
Far distance Approx. 55.0
―38.0 cm (21.6 ―14.9 in)
Medium intermittent
sound
Middle distance Approx. 38.0
―25 cm (14.9 ―9.8 in)
Fast intermittent sound
Close distance Within approx. 25 cm (9.8 in)
Continuous sound
*1 The rate at which the intermittent sound beeps increases as the vehicle approaches the obstruction.
NOTE
If an obstruction in the same area excluding the close area is detected
continuously for 6 seconds or longer, on
ly the warning beeps stop activating.
(Detection is indicated) If the detection area changes to the close side, the
warning beeps resumes. (If the detection area changes to the far side, the warning
beeps remain off)
The sound volume (each of front and rear) can be changed.
Refer to the Settings section in the Mazda Connect Owner's Manual.
▼ When Warning Indicator/Beep is Activated
The system notifies the driver of an abnormality by activating the beep sound and
the indicator light.
When Driving
Pa r k i n g S e n s o r Sys te m
*Some models.4-205
MX
-30_8JD4-EA -21G_Edition2_new 2021-5-18 14:38:07

Indicator/BeepHow to check
A message indicating a sys-
tem malfunction or sensor
malfunction is displayed. There may be a problem with the system. Have your vehicle inspected
by an Authorized Mazda Dealer as soon as possible.
A message indicating that the
sensor is dirty is displayed. Remove any foreign matter from the sensor area. If the system does not
recover, have the vehicle inspected by an Authorized Mazda Dealer.
A certain obstruction detec-
tion indication is continuous-
ly displayed. Foreign matter may have gotten on the sensor area corresponding to
the detection indicator. If the system does not recover, have the vehicle
inspected by an Authorized Mazda Dealer.
When Driving
Pa r k i n g S e n s o r Sys te m
4-206
MX
-30_8JD4-EA -21G_Edition2_new 2021-5-18 14:38:07

5Interior Features
Use of various features for ride comfort, including air-
conditioning system and audio system.
Climate Control System............. 5-2 For Your Ride Comfort........... 5-2
Climate Control System
Operation Area......................5-3
Basic Climate Control System
Operation............................. 5-7
Convenient Ways to Use the
Climate Control System........ 5-10
Mazda Connect...................... 5-14 What is Mazda Connect ?.....5-14
Mazda Connect Basic
Operations.......................... 5-18
Connected Service (If
applicable).......................... 5-35
Interior Equipment.................. 5-36 Sunvisors............................. 5-36
Interior Lights...................... 5-37
Accessory Sockets................ 5-39
AC Power Outlet
*.................5-40
Cup Holder......................... 5-42
Bottle Holder.......................5-43
Assist Grips......................... 5-44
Rear Coat Hooks................. 5-44
Storage Compartments........ 5-45
*Some models.5-1
MX -30_8JD4-EA -21G_Edition2_new 2021-5-18 14:38:07

For Your Ride Comfort
▼For Your Ride Comfort
If the vehicle has been parked in
direct sunlight during hot weather,
open the windows to let warm air
escape, then run the climate control
system.
The climate control system measures
inside and outside temperatures,
humidity and sunlight using the
sunlight/temperature sensor. It sets
temperatures inside the cabin
accordingly.
CAUTION
Do not obstruct both sensors,
otherwise the climate control system
will not operate properly.
Sunlight sensor
1. Sunlight sensor
Interior temperature sensor
1. Interior temperature sensor
Clear all obstructions such as leaves,
snow and ice from the hood and the
air inlet in the cowl grille to improve
the system e
fficiency.
NOTE
If the air flow of the climate control
system significantly decreases, the air
fi lter may be clogged. Replace the air
fi lter.
Use the climate control system to
defog the windows and dehumidify
the air.
Run the air conditioner about 10
minutes at least once a month to
keep internal parts lubricated.
Have the air conditioner checked
before the weather gets hot. Lack of
refrigerant may make the air
conditioner less
effi cient.
The refrigerant specifications are
indicated on a label attached to the
inside of the motor compartment. If
the wrong type of refrigerant is used,
it could result in a serious
malfunction of the air conditioner.
Consult a professional, government
certi fied repairer for the inspection
or repair because a special device is
required for the air conditioner
maintenance.
For details, consult an Authorized
Mazda Dealer.
1. Label
Interior Features
Climate Control System
5-2
MX -30_8JD4-EA -21G_Edition2_new 2021-5-18 14:38:07

Climate Control System Operation Area
▼List of Climate Control System Switches/Icons
Climate control system information is displayed on the display.
Auto operation screen
ƒ
AUTO switch...................................................................................... page 5-4
„ Seat warmer icon*............................................................................. page 2-21
… Steering warmer icon*....................................................................... page 2-23
† Seat warmer setting icon*.................................................................. page 2-21
Steering warmer setting icon*.............................................................page 2-23
‡ Climate control power switch.............................................................. page 5-5
ˆ Rear window defogger switch.............................................................. page 5-5
‰ Fan control icon.................................................................................. page 5-5
Š Fan control switch............................................................................... page 5-5
‹ Display setting icon............................................................................. page 5-5
ΠECO icon............................................................................................ page 5-6
Auto and manual operation screen switching icon................................. page 5-6
Ž A/C icon............................................................................................ page 5-6
Air intake selector icon........................................................................ page 5-6
Temperature control switch.................................................................. page 5-5
‘ Temperature control icon..................................................................... page 5-5
’ Windshield defroster switch................................................................. page 5-6
Interior Features
Climate Control System
*Some models.5-3
MX -30_8JD4-EA -21G_Edition2_new 2021-5-18 14:38:07

Manual operation screen
ƒMode selector icon............................................................................. page 5-6
NOTE
Free/open source software information
This product includes free/open sources. Information about the licensing and source
code is available at the following URL.
https://www.alpine.com/m/e/oss/download/
▼ Touch Panel Basic Operation
CAUTION
Do not press the screen strongly or
press it with a sharp-pointed object.
Otherwise, the screen could be
damaged.
Touch panel operation
You can do three types of icon
operations on the touch panel using
your
finger including , touch, touch and
hold, and swipe operations.
Switching between auto and manual
operation screens
Touch the seat indication in the center
of the screen to switch from the auto
operation screen to the manual
operation screen. Press the AUTO
switch to switch from the manual
operation screen to the auto operation
screen.
▼ AUTO Switch
By pressing the AUTO switch the
following functions will be
automatically controlled in accordance
with the selected set temperature:
Air
flow temperatureAmount of
airflowSelection of airfl ow modeOutside/Recirculated air selectionAir conditioner (cooling, defrosting
functions) operation
*Seat warmer level selection*1
*Heated steering wheel operation*1
*1 Auto mode operates when auto mode is
enabled in the Mazda Connect settings.
Refer to the Settings section in the Mazda
Connect Owner's Manual.
Interior Features
Climate Control System
5-4*Some models.
MX-30_8JD4-EA -21G_Edition2_new 2021-5-18 14:38:07

NOTE
AUTO switch indicator light
ON
The indicator light turns on during
auto operation.
OFF
When any switch or icon is operated
during auto operation, including the
, , , , , , , the
fan control switch, or the defroster
switch, the indicator light turns o ff.
At this time, the functions other than
the one operated operate
automatically.
▼ Temperature Control Switch/Icon
The temperature setting can be
adjusted between 15 °C (60 °F) and
29 °C (84 °F) by pressing the
temperature setting switch, or touching
the
(red) or (blue).
The temperature setting can be quickly
adjusted by pressing and holding the
temperature setting switch, or touching
and holding the
(red) or
(blue).
NOTE
When you set the temperature to the
lower or upper limit, “LO” or “HI” is
displayed.
The temperature units for the
temperature setting display can be
changed in conjunction with the
temperature units for the outside
temperature display.
When swiping the (red) or
(blue) up/down, the temperature
can be adjusted up or down in
increments of 3 °C (6 °F).
To reduce power consumption by
the climate control system, warm air flow may not be supplied when
the ambient temperature is 25 °C
(77 °F) or more.
▼ Fan Control Switch/Icon
The air
flow amount can be adjusted to
7 levels.
The air flow amount can be adjusted by
pressing the fan control switch, or by
touching the
or .
In addition, when the fan control
switch,
, or is pressed and held,
the air flow amount can be adjusted
quickly.
NOTE
When the or is swiped
upward, the air flow amount can be
increased at 3 levels. When swiped
downward, the air flow amount can
be decreased at 3 levels.
▼ Climate Control Power Switch
(System On/Off
)
The climate control system turns on
and
off each time the climate control
power switch is pressed.
▼ Rear Window Defogger Switch
Press the rear window defogger switch
to defrost the rear window.
When the defroster is operated, the
outside mirror defogger
* and the
windshield wiper de-icer* operate in
conjunction.
▼ Display Setting Icon
To u c h t h e to display the display
setting screen.
You can adjust the brightness (41
levels), select the screen from
Interior Features
Climate Control System
*Some models.5-5
MX -30_8JD4-EA -21G_Edition2_new 2021-5-18 14:38:07