MAZDA MODEL MX-5 MIATA 2003 Owners Manual
Page 101 of 256
5-19
Driving Your Mazda
Instrument Cluster and Indicators
Form No. 8R09-EA-02G
Tachometer
The tachometer shows engine speed in 
thousands of revolutions per minute 
(rpm).
 Engine Coolant Temperature 
Gauge
The engine coolant temperature gauge 
shows the temperature of the engine 
coolant.
If the needle exceeds normal range toward 
H, it indicates overheating.
NOTE
• Only the trip meters record tenths of 
kilometers (miles).
• The trip record will be erased when;
The power supply is interrupted 
(blown fuse or the battery is 
disconnected).
 The vehicle is driven over 999.9 
km (mile).
Don ’t run the engine with the 
tachometer needle in the RED ZONE.
This may cause severe engine damage.
Red zone
CAUTION
Driving with an overheated engine can 
cause serious engine damage (page 7-
11).
CAUTION
J07R_8R09_EA_02G_Edition4.book  Page 19  Monday, February 3, 2003  1:16 PM 
Page 102 of 256
5-20
Driving Your Mazda
Instrument Cluster and Indicators
Form No. 8R09-EA-02G
Fuel Gauge
The fuel gauge shows approximately how 
much fuel is in the tank. We recommend 
keeping the tank over 1/4 full. When the 
low fuel warning light illuminates or 
when the needle is near E, refuel as soon 
as possible.
Engine Oil Pressure Gauge
Engine oil pressure is normal when the 
engine oil pressure gauge needle points 
halfway between L and H with the engine 
running.
If the needle on the gauge doesn
’t move 
after starting the engine, follow steps 1 
through 3. If the engine oil pressure gauge moves to 
L (low) while you are driving, drive to the 
side of the road and park off the right-of-
way. Set the parking brake. Then follow 
steps 1 through 3.
1. Turn off the engine and inspect the 
engine oil level (page 8-13). If it ’s low, 
add oil.
2. Start the engine.
3. If the needle still doesn ’t move, have 
your vehicle checked at an Authorized 
Mazda Dealer.
Don ’t run the engine if the oil pressure 
is low. It could result in extensive 
engine damage.
CAUTION
J07R_8R09_EA_02G_Edition4.book  Page 20  Monday, February 3, 2003  1:16 PM 
Page 103 of 256
5-21
Driving Your Mazda
Instrument Cluster and Indicators
Form No. 8R09-EA-02G
Dashboard Illumination
When the headlight switch is in the   
or   position, rotate the thumb-wheel 
to adjust the brightness of the dashboard 
lights.
Dim Bright
J07R_8R09_EA_02G_Edition4.book  Page 21  Monday, February 3, 2003  1:16 PM 
Page 104 of 256
5-22
Driving Your Mazda
Form No. 8R09-EA-02G
Warning/Indicator Lights and Beeps
Warning/Indicator Lights
SignalWarning/Indicator Lights Page
Brake System Warning Light 5-24
Charging System Warning Light 5-25
Check Engine Light 5-26
ABS Warning Light 5-26
Air Bag/Seat Belt Pretensioner System Warning Light 5-27
Low Fuel Warning Light 5-27
Seat Belt Warning Light 5-27
Warning/Indicator lights will appear in any of the highlighted areas
J07R_8R09_EA_02G_Edition4.book  Page 22  Monday, February 3, 2003  1:16 PM 
Page 105 of 256
5-23
Driving Your Mazda
Warning/Indicator Lights and Beeps
Form No. 8R09-EA-02G
Immobilizer System Warning Light5-28
Headlight High-Beam Indicator Light 5-28
O/D OFF Indicator Light 5-28
Cruise Set Indicator Light 5-28
Signal
Warning/Indicator Lights Page
J07R_8R09_EA_02G_Edition4.book  Page 23  Monday, February 3, 2003  1:16 PM 
Page 106 of 256
5-24
Driving Your Mazda
Warning/Indicator Lights and Beeps
Form No. 8R09-EA-02G
Brake System Warning Light
This warning has the following functions:
Parking brake warning
The light comes on when the parking 
brake is applied with the ignition switch 
in the START or ON position. It goes off 
when the parking brake is fully released.
Low brake fluid level warning/
Electronic brake force distribution 
system warning
If the light stays on after the parking brake 
is fully released, you may have a brake 
problem.
Drive to the side of the road and park off 
the right-of-way.
Low brake fluid level warning
You may notice that the pedal is harder to 
push or that it may go closer to the floor. 
In either case, it will take longer to stop 
the vehicle.
1. With the engine stopped, check the 
brake fluid level immediately and add 
fluid as required (page 8-17).
2. After adding fluid, check the light  again. If the warning light remains on, or if the 
brakes do not operate properly, do not 
drive the vehicle. Have it towed to an 
Authorized Mazda Dealer.
Even if the light goes off, have your brake 
system inspected as soon as possible.
Electronic brake force distribution 
system warning
If the electronic brake force distribution 
control unit determines that some 
components are operating incorrectly, the 
control unit may turn the brake system 
warning light on.
In this case, the ABS warning light comes 
on at the same time (page 5-26).
J07R_8R09_EA_02G_Edition4.book  Page 24  Monday, February 3, 2003  1:16 PM 
Page 107 of 256
5-25
Driving Your Mazda
Warning/Indicator Lights and Beeps
Form No. 8R09-EA-02G
Charging System Warning Light
This warning light comes on when the 
ignition switch is turned to the ON 
position and goes off when the engine is 
started.
If the warning light comes on while 
driving, it indicates a malfunction of the 
alternator or of the charging system.
Drive to the side of the road and park off 
the right-of-way. Consult an Authorized 
Mazda Dealer.
Brake Warning Light:
Driving with the brake system 
warning light on is dangerous. It 
indicates that your brakes may not 
work at all or that they could 
completely fail at any time. If this 
light remains on, after checking that 
the parking brake is released, have 
the brakes inspected immediately. 
Don
’t drive with this light on, and 
contact an Authorized Mazda Dealer 
to have the brakes inspected as soon 
as possible.
ABS Warning Light and Brake 
Warning Light on at the Same Time:
Driving when the brake system 
warning light and ABS warning light 
are on at the same time is dangerous. 
When both lights are on, the rear 
wheels could lock more quickly in an 
emergency stop than under normal 
circumstances.
Don ’t drive with both lights on, and 
contact an Authorized Mazda Dealer 
to have the brakes inspected as soon 
as possible.
WARNING
Don't continue driving when the 
charging system warning light is 
illuminated.
CAUTION
J07R_8R09_EA_02G_Edition4.book  Page 25  Monday, February 3, 2003  1:16 PM 
Page 108 of 256
5-26
Driving Your Mazda
Warning/Indicator Lights and Beeps
Form No. 8R09-EA-02G
Check Engine Light
If this light comes on while driving, the 
vehicle may have a problem. It is 
important to note the driving conditions 
when the light came on and consult an 
Authorized Mazda Dealer.
The check engine light may come on in 
the following cases:
• The fuel tank level being very low or 
approaching empty.
• The engine
’s electrical system has a 
problem.
• The emission control system has a 
problem.
• The fuel-filler cap is missing or not 
tightened securely.
If the check engine light remains on, do 
not drive at high speeds and consult an 
Authorized Mazda Dealer as soon as 
possible.
 ABS Warning Light
The warning light stays on for a few 
seconds when the ignition switch is turned 
to the ON position.
If the ABS warning light stays on while 
you
’re driving, the ABS control unit has 
detected a system malfunction. If this 
occurs, your brakes will function 
normally as if the vehicle had no ABS.
Should this happen, consult an Authorized 
Mazda Dealer as soon as possible.
ABS Warning Light and Brake 
Warning Light on at the Same Time:
Driving when the brake system 
warning light and ABS warning light 
are on at the same time is dangerous.
When both lights are on, the rear 
wheels could lock more quickly in an 
emergency stop than under normal 
circumstances.
Don ’t drive with both lights on, and 
contact an Authorized Mazda Dealer 
to have the brakes inspected as soon 
as possible.
WARNING
J07R_8R09_EA_02G_Edition4.book  Page 26  Monday, February 3, 2003  1:16 PM 
Page 109 of 256
5-27
Driving Your Mazda
Warning/Indicator Lights and Beeps
Form No. 8R09-EA-02G
Air Bag/Seat Belt Pretensioner 
System Warning Light
If the air bag/seat belt pretensioner system 
is OK, the warning light comes on when 
the ignition switch is turned to the ON 
position or after the engine is cranked. 
After about 6 seconds it goes out.
A system malfunction is indicated when the 
warning light constantly flashes, stays on or 
doesn
’t come on at all when the ignition 
switch is turned to the ON position. If any of 
these occur, consult an Authorized Mazda 
Dealer as soon as possible. The system may 
not work in an accident.
 Low Fuel Warning Light
This warning light signals that the fuel 
tank will soon be empty.
Refuel as soon as possible.
Seat Belt Warning Light
If the driver
’s seat belt is not fastened 
when the ignition switch is turned to the 
ON position, the seat belt warning light 
will remain on until the belt is fastened.
If the system does not operate correctly, 
consult an Authorized Mazda Dealer.
NOTE
When the engine is jump-started to charge 
the battery, uneven rpm occurs and the 
ABS warning light comes on. This is due 
to a weak battery, not a malfunction.
Recharge the battery.
Self-Servicing the Air Bag/
Pretensioner Systems:
Self-servicing or tampering with the 
systems is dangerous. An air bag/
pretensioner could accidentally 
activate or become disabled. This 
could cause serious injuries. Never 
tamper with the systems and always 
have an Authorized Mazda Dealer 
perform all servicing and repairs.
WARNING
J07R_8R09_EA_02G_Edition4.book  Page 27  Monday, February 3, 2003  1:16 PM 
Page 110 of 256
5-28
Driving Your Mazda
Warning/Indicator Lights and Beeps
Form No. 8R09-EA-02G
Immobilizer System Warning 
Light
If the immobilizer system is working 
properly, the light will come on when the 
ignition switch is turned to the ON or 
START position. The light will go out 
when confirmation by the immobilizer 
system is completed.
If the light flashes rapidly, fails to come 
on, or comes on and stays on, it indicates 
a system malfunction. If any of these 
occur, contact an Authorized Mazda 
Dealer as soon as possible.
Headlight High-Beam Indicator 
Light
This light indicates one of two things:
• The high-beam headlights are on.
• The turn signal lever is in the flash-to-
pass position.
O/D OFF Indicator Light 
(Automatic transmission)
This light comes on when the overdrive 
has been turned off.
Cruise Set Indicator Light
This light comes on when a cruising speed 
is set.
If the overdrive-off indicator light 
flashes, the transmission has an 
electrical problem. Continuing to drive 
your Mazda in this condition could 
cause damage to your transmission. 
Consult an Authorized Mazda Dealer 
as soon as possible.
CAUTION
J07R_8R09_EA_02G_Edition4.book  Page 28  Monday, February 3, 2003  1:16 PM